Resistive Impedance Matching Circuit for Piezoelectric Energy Harvesting

A two-stage power conditioning circuit consisting of an AC-DC converter followed by a DC-DC converter is proposed for a vibration-based energy harvesting system. The power conditioning circuit intends to maximize the amount of power extracted from a piezoelectric energy harvester by matching the source impedance with the circuit by adaptively adjusting the duty cycle. An equivalent electrical circuit representation derived from a distributed-parameter piezoelectric energy harvester model is adapted to enable the impedance matching method proposed here. For a given piezoelectric energy harvester, there is a theoretical maximum power output that is determined by the mechanical damping, base acceleration, and the effective mass of the harvester structure under base excitation. Experimental results are given to validate the effectiveness of the proposed resistive impedance matching circuit around the first resonance frequency of a cantilevered piezoelectric energy harvester.

[1]  R. Feinberg.  Introduction to electronic circuits , 1952 .

[2]  Daniel Guyomar,et al.  Semi-passive damping using continuous switching of a piezoelectric device , 1999, Smart Structures.

[3]  Claude Richard,et al.  Enhanced semi-passive damping using continuous switching of a piezoelectric device on an inductor , 2000, Smart Structures.

[4]  Zoya Popovic,et al.  Broadband Rectenna Arrays for Randomly Polarized Incident Waves , 2000, 2000 30th European Microwave Conference.

[5]  Heath Hofmann,et al.  Adaptive piezoelectric energy harvesting circuit for wireless remote power supply , 2002 .

[6]  Robert W. Erickson,et al.  Fundamentals of Power Electronics , 2001 .

[7]  G.K. Ottman,et al.  Optimized piezoelectric energy harvesting circuit using step-down converter in discontinuous conduction mode , 2002, 2002 IEEE 33rd Annual IEEE Power Electronics Specialists Conference. Proceedings (Cat. No.02CH37289).

[8]  Joseph A. Paradiso,et al.  Energy scavenging for mobile and wireless electronics , 2005, IEEE Pervasive Computing.

[9]  D. Guyomar,et al.  Toward energy harvesting using active materials and conversion improvement by nonlinear processing , 2005, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[10]  K.D.T. Ngo,et al.  Converter and controller for micro-power energy harvesting , 2005, Twentieth Annual IEEE Applied Power Electronics Conference and Exposition, 2005. APEC 2005..

[11]  D. Reisner,et al.  Prototype silicon micropower supply for sensors , 2006, IEEE Sensors Journal.

[12]  Claude Richard,et al.  Single crystals and nonlinear process for outstanding vibration-powered electrical generators , 2006, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[13]  S. Beeby,et al.  Energy harvesting vibration sources for microsystems applications , 2006 .

[14]  D. Guyomar,et al.  Buck-Boost Converter for Sensorless Power Optimization of Piezoelectric Energy Harvester , 2007, IEEE Transactions on Power Electronics.

[15]  Henry A. Sodano,et al.  A review of power harvesting using piezoelectric materials (2003–2006) , 2007 .

[16]  S. Priya.  Advances in energy harvesting using low profile piezoelectric transducers , 2007 .

[17]  T. O'Donnell,et al.  Energy scavenging for long-term deployable wireless sensor networks. , 2008, Talanta.

[18]  N. Hudak,et al.  Small-scale energy harvesting through thermoelectric, vibration, and radiofrequency power conversion , 2008 .

[19]  Patrick Audebert,et al.  Efficient Power Management Circuit: From Thermal Energy Harvesting to Above-IC Microbattery Energy Storage , 2007, IEEE Journal of Solid-State Circuits.

[20]  Daniel J. Inman,et al.  Issues in mathematical modeling of piezoelectric energy harvesters , 2008 .

[21]  Daniel J. Inman,et al.  A Distributed Parameter Electromechanical Model for Cantilevered Piezoelectric Energy Harvesters , 2008 .

[22]  Cesare Alippi,et al.  An Adaptive System for Optimal Solar Energy Harvesting in Wireless Sensor Network Nodes , 2008, IEEE Transactions on Circuits and Systems I: Regular Papers.

[23]  R. Zane,et al.  Resistor Emulation Approach to Low-Power RF Energy Harvesting , 2008, IEEE Transactions on Power Electronics.

[24]  Saibal Roy,et al.  Self-powered autonomous wireless sensor node using vibration energy harvesting , 2008 .

[25]  Daniel J. Inman,et al.  An experimentally validated bimorph cantilever model for piezoelectric energy harvesting from base excitations , 2009 .

[26]  N. Elvin,et al.  A General Equivalent Circuit Model for Piezoelectric Generators , 2009 .