CFD Analysis to Study Effect of Circular Vortex Generator Placed in Inlet Section to Investigate Heat Transfer Aspects of Solar Air Heater

CFD analysis of 2-dimensional artificially roughened solar air heater duct with additional circular vortex generator, inserted in inlet section is carried out. Circular transverse ribs on the absorber plate are placed as usual. The analysis is done to investigate the effect of inserting additional vortex generator on the heat transfer and flow friction characteristics inside the solar air heater duct. This investigation covers relative roughness pitch in the range of 10 ≤ P/e ≤ 25 and relevant Reynolds numbers in the range of 3800 ≤ Re ≤ 18000. Relative roughness height (e/D) is kept constant as 0.03 for analysis. The turbulence created due to additional circular vortex generator increases the heat transfer rate and at the same time there is also increase in friction factor values. For combined arrangement of ribs and vortex generator, maximum Nusselt number is found to be 2.05 times that of the smooth duct. The enhancement in Nusselt number with ribs and additional vortex generator is found to be 1.06 times that of duct using ribs alone. The maximum increase in friction factor with ribs and circular vortex generator is found to be 2.91 times that of the smooth duct. Friction factor in a combined arrangement is 1.114 times that in a duct with ribs alone on the absorber plate. The augmentation in Thermal Enhancement Factor (TEF) with vortex generator in inlet section is found to be 1.06 times more than with circular ribs alone on the absorber plate.

[1]  A. D. Young,et al.  An Introduction to Fluid Mechanics , 1968 .

[2]  H. Gurney.  Heat Transmission , 1909, Nature.

[3]  A. N. Tikekar,et al.  Analysis of fluid flow and heat transfer in a rib grit roughened surface solar air heater using CFD , 2010 .

[4]  J. L. Bhagoria,et al.  Modeling and Simulation of Turbulent Flows through a Solar Air Heater Having Square-Sectioned Transverse Rib Roughness on the Absorber Plate , 2013, TheScientificWorldJournal.

[5]  B. N. Prasad,et al.  Investigation for the optimal thermohydraulic performance of artificially roughened solar air heaters , 2000 .

[6]  M. Mcpherson,et al.  Introduction to fluid mechanics , 1997 .

[7]  S. C. Solanki,et al.  Analysis of heat transfer augmentation and flow characteristics due to rib roughness over absorber plate of a solar air heater , 2006 .

[8]  R. Saini,et al.  CFD based performance analysis of a solar air heater duct provided with artificial roughness , 2009 .

[9]  J. L. Bhagoria,et al.  Heat transfer and fluid flow analysis of solar air heater: A review of CFD approach , 2013 .

[10]  Anil Singh Yadav,et al.  A CFD Analysis Of A Solar Air Heater Having Triangular Rib Roughness On The Absorber Plate , 2013 .

[11]  A. S. Dhoble,et al.  Effect of roughness geometries on heat transfer enhancement in solar thermal systems – A review , 2014 .

[12]  S. Patankar.  Numerical Heat Transfer and Fluid Flow , 2018, Lecture Notes in Mechanical Engineering.

[13]  E. Eckert,et al.  Application of rough surfaces to heat exchanger design , 1972 .

[14]  J. L. Bhagoria,et al.  A CFD based thermo-hydraulic performance analysis of an artificially roughened solar air heater having equilateral triangular sectioned rib roughness on the absorber plate , 2014 .

[15]  J. L. Bhagoria,et al.  Numerical investigation of flow through an artificially roughened solar air heater , 2015 .

[16]  L. M. Hossfeld,et al.  Effect of rounding of protruding edges on heat transfer and pressure drop in a duct , 1984 .

[17]  Varun,et al.  Nusselt number and friction factor correlations for solar air heater duct having protrusions as roughness elements on absorber plate , 2013 .

[18]  S. Mullick,et al.  Heat transfer characteristics of a solar air heater used for drying purposes , 1983 .

[19]  J. L. Bhagoria,et al.  A CFD (computational fluid dynamics) based heat transfer and fluid flow analysis of a solar air heater provided with circular transverse wire rib roughness on the absorber plate , 2013 .

[20]  Pongjet Promvonge,et al.  Thermal behavior in solar air heater channel fitted with combined rib and delta-winglet ☆ , 2011 .