Stress, Sheet Resistance, and Microstructure Evolution of Electroplated Cu Films During Self-Annealing

Electroplated copper films are known to change their microstructure due to the self-annealing effect. The self-annealing effect of electroplated copper films was investigated by measuring the time dependence of the film stress and sheet resistance for different layer thicknesses between 1.5 and 20 ¿m. While the sheet resistance was found to decrease as time elapsed, a size-dependent change in film stress was observed. Films with the thickness of 5 ¿m and below decrease in stress, while thicker films initially reveal an increase in film stress followed by a stress relaxation at a later stage. This behavior is explained by the superposition of grain growth and grain-size-dependent yielding.

[1]  Lubomyr T. Romankiw,et al.  A path: from electroplating through lithographic masks in electronics to LIGA in MEMS , 1997 .

[2]  Weng Hong Teh,et al.  Study of microstructure and resistivity evolution for electroplated copper films at near-room temperature , 2001 .

[3]  Yidong Xia,et al.  Room-temperature microstructural evolution of electroplated Cu studied by focused ion beam and positron annihilation lifetime spectroscopy , 2008 .

[4]  W. Brückner,et al.  Abnormal grain growth in { 111 } textured Cu thin films , 2002 .

[5]  Qing-Tang Jiang,et al.  Recrystallization effects in Cu electrodeposits used in fine line damascene structures , 2001 .

[6]  K. Maex,et al.  Self-annealing characterization of electroplated copper films , 1999 .

[7]  S. Wong,et al.  Studies of the driving force for room-temperature microstructure evolution in electroplated copper films , 2004 .

[8]  K. Yin,et al.  The kinetics and mechanism of room-temperature microstructural evolution in electroplated copper foils , 2008 .

[9]  M. Somers,et al.  In situ investigation of the microstructure evolution in nanocrystalline copper electrodeposits at room temperature , 2006 .

[10]  Panayotis C. Andricacos,et al.  Damascene copper electroplating for chip interconnections , 1998, IBM J. Res. Dev..

[12]  K. Bowman.  Mechanical Behavior of Materials , 2003 .

[13]  Supratik Guha,et al.  Thermodynamics and kinetics of room-temperature microstructural evolution in copper films , 2003 .

[14]  In situ transmission electron microscope studies of the kinetics of abnormal grain growth in electroplated copper films , 2000 .

[15]  H. Wendrock,et al.  Influence of initial microstructure and impurities on Cu room-temperature recrystallization (self-annealing) , 2008 .

[16]  L. Freund,et al.  Thin Film Materials: Stress, Defect Formation and Surface Evolution , 2004 .

[17]  M. D. Thouless,et al.  Stress development and relaxation in copper films during thermal cycling , 1993 .

[18]  I. Tabaković,et al.  Effect of organic additives on structure, resistivity, and room-temperature recrystallization of electrodeposited Copper , 2004 .

[19]  G. Beyer,et al.  TWO-STEP ROOM TEMPERATURE GRAIN GROWTH IN ELECTROPLATED COPPER , 1999 .

[20]  P. Roper,et al.  Full copper wiring in a sub-0.25 /spl mu/m CMOS ULSI technology , 1997, International Electron Devices Meeting. IEDM Technical Digest.

[21]  M. E. Gross,et al.  RECRYSTALLIZATION KINETICS OF ELECTROPLATED CU IN DAMASCENE TRENCHES AT ROOM TEMPERATURE , 1998 .

[22]  C. Cabral,et al.  Mechanisms for microstructure evolution in electroplated copper thin films near room temperature , 1999 .

[23]  William D. Nix,et al.  Stresses and deformation processes in thin films on substrates , 1988 .

[24]  R. Beresford,et al.  Competition between tensile and compressive stress mechanisms during Volmer-Weber growth of aluminum nitride films , 2005 .

[25]  William D. Nix,et al.  Mechanical properties of thin films , 1989 .

[26]  D. J. Pearson,et al.  Copper interconnection integration and reliability , 1995 .

[27]  M. V. Hove,et al.  Grain growth in copper interconnect lines , 2004 .