Modeling and Optimizing Honing Texture for Reduced Friction in Internal Combustion Engines

[1]  Modelling of the Asperity Contact Area on Actual 3D Surfaces , 2005 .

[2]  Yong Li,et al.  Analyzing the Effects of Three-Dimensional Cylinder Liner Surface Texture on Ring-Pack Performance With a Focus on Honing Groove Cross-Hatch Angle , 2005 .

[3]  Masaaki Takiguchi,et al.  Improvement of Piston Lubrication in a Diesel Engine By Means of Cylinder Surface Roughness , 2004 .

[4]  F. Sadeghi,et al.  Film Thickness and Friction Measurement of Piston Ring Cylinder Liner Contact With Corresponding Modeling Including Mixed Lubrication , 2004 .

[5]  Stephen H. Hill.  Cylinder Bore Finishes and Their Effect on Oil Consumption , 2001 .

[6]  Tian Tian,et al.  Modeling the Lubrication, Dynamics, and Effects of Piston Dynamic Tilt of Twin-Land Oil Control Rings in Internal Combustion Engines , 2000 .

[7]  John B. Heywood,et al.  A Piston Ring-Pack Film Thickness and Friction Model for Multigrade Oils and Rough Surfaces , 1996 .

[8]  Yeau-Ren Jeng,et al.  Impact of plateaued surfaces on tribological performance , 1996 .

[9]  James R. Brown,et al.  An Experimental Study of the Effect of Cylinder Bore Finish on Engine Oil Consumption , 1995 .

[10]  Gary Barber,et al.  The Effects of Roughness on Piston Ring Lubrication—Part II: The Relationship between Cylinder Wall Surface Topography and Oil Film Thickness , 1995 .

[11]  Gary Barber,et al.  The Effects of Roughness on Piston Ring Lubrication Part I: Model Development , 1995 .

[12]  B. Hamrock,et al.  Fundamentals of Fluid Film Lubrication , 1994 .

[13]  Ward O. Winer,et al.  The High Shear Stress Rheology of Liquid Lubricants at Pressures of 2 to 200 MPa , 1990 .

[14]  John I. McCool,et al.  Comparison of models for the contact of rough surfaces , 1986 .

[15]  H. Cheng,et al.  Application of Average Flow Model to Lubrication Between Rough Sliding Surfaces , 1979 .

[16]  J. Greenwood,et al.  The Contact of Two Nominally Flat Rough Surfaces , 1970 .