Improving bit error rate under burst noise in OFDM power line communications

Noise in Power Line Communications is typically impulsive, with impulses being a fraction of the OFDM symbol length. Because of their large duration the impulse can also be called bursts. The short duration of the burst compared with the OFDM symbol length implies that there is a strong correlation between the noise at different carriers, given a determined burst position. The position can be determined using an estimate of the noise after a first demodulation. The high correlation is used to develop demodulators with a reduced bit error rate in comparison with conventional demodulators, so increasing the capacity. The demodulators use a smoothed estimate of the noise signal or a new metric for the distance based on the new correlation matrix. About half of the bit errors can be corrected in this way, corresponding to a 1 dB improvement in Signal Noise Ratio (SNR). How to split the OFDM symbol without increasing the overhead due to the circular prefix is also shown. Noise measurements in power lines are presented. These measurements are used in the simulations.

[1]  James W. Modestino,et al.  Errors-and-erasures coding to combat impulse noise on digital subscriber loops , 1990, IEEE Trans. Commun..

[2]  Paulo A C Lopes,et al.  Modeling and optimization of the access impedance of power line channels , 2010, ISPLC2010.

[3]  John G. Proakis,et al.  Digital Communications , 1983 .

[4]  Keum-Chan Whang,et al.  Mitigation of Performance Degradation by Impulsive Noise in LDPC Coded OFDM System , 2006, 2006 IEEE International Symposium on Power Line Communications and Its Applications.

[5]  Sergey V. Zhidkov,et al.  Performance analysis and optimization of OFDM receiver with blanking nonlinearity in impulsive noise environment , 2006, IEEE Transactions on Vehicular Technology.

[6]  A. J. Han Vinck,et al.  On impulse noise and its models , 2014, 18th IEEE International Symposium on Power Line Communications and Its Applications.

[7]  John B. Shoven,et al.  I , Edinburgh Medical and Surgical Journal.

[8]  Matthias Götz,et al.  Power line channel characteristics and their effect on communication system design , 2004, IEEE Communications Magazine.

[9]  Wai Ho Mow,et al.  Joint Erasure Marking and Viterbi Decoding Algorithm for Unknown Impulsive Noise Channels , 2008, IEEE Transactions on Wireless Communications.

[10]  Tareq Y. Al-Naffouri,et al.  Impulse noise cancellation in OFDM: an application of compressed sensing , 2008, 2008 IEEE International Symposium on Information Theory.

[11]  P. A. C. Lopes,et al.  Dealing With Unknown Impedance and Impulsive Noise in the Power-Line Communications Channel , 2013, IEEE Transactions on Power Delivery.

[12]  S. Habib,et al.  Impulsive noise mitigation in wireless communication systems using EMD technique , 2012, 2012 7th International Conference on Electrical and Computer Engineering.

[13]  S. V. Zhidkov,et al.  Impulsive noise suppression in OFDM-based communication systems , 2003, IEEE Trans. Consumer Electron..

[14]  A. J. Han Vinck,et al.  Iterative decoding of codes over complex numbers for impulsive noise channels , 2003, IEEE Trans. Inf. Theory.

[15]  Peter Jung,et al.  Error Correction in Impulsive Noise Environments by Applying Turbo Codes , 2006, 2006 IEEE 17th International Symposium on Personal, Indoor and Mobile Radio Communications.

[16]  Yunghsiang Sam Han,et al.  Robust Clipping for OFDM Transmissions over Memoryless Impulsive Noise Channels , 2012, IEEE Communications Letters.

[17]  Peter Jung,et al.  Turbo decoding in impulsive noise environments , 2003 .

[18]  Ramjee Prasad,et al.  OFDM for Wireless Multimedia Communications , 1999 .

[19]  K. Dostert,et al.  Analysis and modeling of impulsive noise in broad-band powerline communications , 2002 .

[20]  S. Denno,et al.  A decoding for low density parity check codes over impulsive noise channels , 2005, International Symposium on Power Line Communications and Its Applications, 2005..

[21]  D. Middleton An Introduction to Statistical Communication Theory , 1960 .

[22]  Sergey V. Zhidkov,et al.  Analysis and comparison of several simple impulsive noise mitigation schemes for OFDM receivers , 2008, IEEE Transactions on Communications.