Study of the Splat Formation for HVOF Sprayed NiCr on Stainless Steel Substrates and the Effects of Heating and Boiling Pre-Treatments

[1]  P. Munroe,et al.  Study of the microstructure of NiCr splats plasma sprayed on to stainless steel substrates by TEM , 2010 .

[2]  P. Munroe,et al.  Study of the effects of surface chemistry on splat formation for plasma sprayed NiCr onto stainless steel substrates , 2010 .

[3]  Paul Munroe,et al.  The application of focused ion beam microscopy in the material sciences , 2009 .

[4]  A. Gouldstone,et al.  On the Role of Bubbles in Metallic Splat Nanopores and Adhesion , 2008 .

[5]  E. Lavernia,et al.  Cold gas dynamic spraying of a high temperature Al alloy , 2006 .

[6]  P. Munroe,et al.  Effect of substrate hardness on splat morphology in high-velocity thermal spray coatings , 2006 .

[7]  P. Fauchais,et al.  Influence of stainless steel substrate preheating on surface topography and on millimeter- and micrometer-sized splat formation , 2006 .

[8]  S. Chandra,et al.  Investigation of splat curling up in thermal spray coatings , 2006, International Thermal Spray Conference.

[9]  S. Leen,et al.  Effect of particle impact on residual stress development in HVOF sprayed coatings , 2006, International Thermal Spray Conference.

[10]  T. Marrocco,et al.  Microstructure and properties of thermally sprayed Al-Sn-based alloys for plain bearing applications , 2006, International Thermal Spray Conference.

[11]  Sanjay Sampath,et al.  On the role of particle state and deposition procedure on mechanical, tribological and dielectric response of high velocity oxy-fuel sprayed alumina coatings , 2006 .

[12]  Martin Rein,et al.  Cold spray deposition: Significance of particle impact phenomena , 2005 .

[13]  P. D. Brown,et al.  The microstructures of a thermally sprayed and heat treated Al–20 wt.%Sn–3 wt.%Si alloy , 2005 .

[14]  X. Y. Wang,et al.  Substrate melting during thermal spray splat quenching , 2004 .

[15]  P. Fauchais,et al.  Knowledge concerning splat formation: An invited review , 2004 .

[16]  S. Harris,et al.  Influence of the HVOF spraying process on the microstructure and corrosion behaviour of Ni-20%Cr coatings , 2003 .

[17]  D. Zhang,et al.  Microstructure formation and corrosion behaviour in HVOF-sprayed Inconel 625 coatings , 2003 .

[18]  Javad Mostaghimi,et al.  Air bubble entrapment under an impacting droplet , 2003 .

[19]  Chang-jiu Li,et al.  Effect of particle state on the adhesive strength of HVOF sprayed metallic coating , 2002 .

[20]  R. N. Wright,et al.  Microstructure and stresses in HVOF sprayed iron aluminide coatings , 2002 .

[21]  M. Dorfman.  Thermal spray basics , 2002 .

[22]  Hui Zhang,et al.  Studies of splat morphology and rapid solidification during thermal spraying , 2001 .

[23]  S. Kuroda,et al.  Peening action and residual stresses in high-velocity oxygen fuel thermal spraying of 316L stainless steel , 2001 .

[24]  A. Matthews,et al.  Handbook of Hard Coatings: Edited by Rointan E Bunshah; Noyes Publications/William Andrew Publishing, New York 2001 (Available from American Technical Publishers Ltd, 27-29 Knowl Piece, Wilbury Way, Hitchin, Herts, SG4 0SX, England, Price £94) , 2001 .

[25]  O. Madelung,et al.  Non-tetrahedrally bonded binary compounds II , 2000 .

[26]  S. Sampath,et al.  Impact of high velocity cold spray particles , 1999 .

[27]  V. Sobolev,et al.  Effect of oxidation on droplet flattening and splat-substrate interaction in thermal spraying , 1999 .

[28]  J. Guilemany,et al.  Microstructure characterization of WC-Ni coatings obtained by HVOF thermal spraying , 1995 .

[29]  V. Sobolev,et al.  Investigation of coating porosity formation during high velocity oxy-fuel (HVOF) spraying , 1994 .

[30]  J. A. Browning.  Hypervelocity impact fusion—a technical note , 1992 .

[31]  A. Papyrin,et al.  A method of "cold" gas-dynamic deposition , 1990 .

[32]  N. McIntyre,et al.  Characterization of oxide structures formed on nickel-chromium alloy during low pressure oxidation at 500–600°C , 1990 .

[33]  G. C. Allen,et al.  A surface study of the oxidation of type 304L stainless steel at 600 K in air , 1988 .

[34]  C. Rosa.  The high temperature oxidation of nickel , 1983 .

[35]  A. Hasui,et al.  A study of the bonding mechanism of sprayed coatings , 1974 .

[36]  B. A. Wilcox,et al.  The high-temperature oxidation of nickel-20 wt. % chromium alloys containing dispersed oxide phases , 1972 .