Kelvin probe force microscopy-based characterization techniques applied for electrostatic MEMS/NEMS devices and bare dielectric films to investigate the dielectric and substrate charging phenomena

In this study, two different characterization techniques based on Kelvin probe force microscopy (KPFM) have been used to investigate the dielectric and substrate charging in electrostatic micro- and nano-electromechanical systems (MEMS and NEMS). The first technique (KPFM-MEMS) has been employed to study the discharging process on a microscopic scale in a charged MEMS dielectric film. This has been performed by monitoring the surface potential decay with time of charged PECVD silicon nitride films implemented in electrostatic capacitive MEMS switches. The second methodology, KPFM-thin films (KPFM-TF), has been applied to investigate the charging/discharging processes in bare SiNx films as well as the substrate charging phenomenon. It makes use of the atomic force microscope tip to simulate charge injection through a single asperity, and then measure the induced surface potential. The influence of the SiNx film thickness and deposition conditions has been studied. Moreover, the impact of bias amplitude and...

[1]  A. Stemmer,et al.  Resolution and contrast in Kelvin probe force microscopy , 1998 .

[2]  Andreas Stemmer,et al.  Surface potential mapping: A qualitative material contrast in SPM , 1997 .

[3]  Patrick Pons,et al.  Charging-Effects in RF capacitive switches influence of insulating layers composition , 2006, Microelectron. Reliab..

[4]  J. C. Phillips,et al.  Stretched exponential relaxation in molecular and electronic glasses , 1996 .

[5]  J.C.M. Hwang,et al.  Modeling and characterization of dielectric-charging effects in RF MEMS capacitive switches , 2005, IEEE MTT-S International Microwave Symposium Digest, 2005..

[6]  W. De Raedt,et al.  Analytical Model of the DC Actuation of Electrostatic MEMS Devices With Distributed Dielectric Charging and Nonplanar Electrodes , 2007, Journal of Microelectromechanical Systems.

[7]  Bharat Bhushan,et al.  Measurements and analysis of surface potential change during wear of single-crystal silicon (100) at ultralow loads using Kelvin probe microscopy , 2000 .

[8]  Michael Hietschold,et al.  Parasitic charging of dielectric surfaces in capacitive microelectromechanical systems (MEMS) , 1998 .

[9]  H. Wang,et al.  Assessment of dielectric charging in electrostatically driven MEMS devices: A comparison of available characterization techniques , 2010, Microelectron. Reliab..

[10]  G. Papaioannou,et al.  Temperature study of the dielectric polarization effects of capacitive RF MEMS switches , 2005, IEEE Transactions on Microwave Theory and Techniques.

[11]  Shiano Ono,et al.  Kelvin probe force microscopy on InAs thin films grown on GaAs giant step structures formed on (110) GaAs vicinal substrates , 2001 .

[12]  R. Puers,et al.  Effect of Gas Pressure on the Lifetime of Capacitive RF MEMS Switches , 2006, 19th IEEE International Conference on Micro Electro Mechanical Systems.

[13]  P. Pons,et al.  A novel low cost failure analysis technique for dielectric charging phenomenon in electrostatically actuated MEMS devices , 2010, 2010 IEEE International Reliability Physics Symposium.

[14]  Robert Puers,et al.  Effect of substrate charging on the reliability of capacitive RF MEMS switches , 2009 .

[15]  J. Papapolymerou,et al.  Effect of deposition conditions on charging processes in SiNx: Application to RF-MEMS capacitive switches , 2009 .

[16]  Patrick Pons,et al.  Voltage and temperature effect on dielectric charging for RF-MEMS capacitive switches reliability investigation , 2008, Microelectron. Reliab..

[17]  Patrick Pons,et al.  Dielectric charging in silicon nitride films for MEMS capacitive switches: Effect of film thickness and deposition conditions , 2009, Microelectron. Reliab..

[18]  Robert Plana,et al.  ESD failure signature in capacitive RF MEMS switches , 2008, Microelectron. Reliab..

[19]  Patrick Pons,et al.  Structure dependent charging process in RF MEMS capacitive switches , 2007, Microelectron. Reliab..

[20]  J. R. Reid,et al.  Measurements of charging in capacitive microelectromechanical switches , 2002 .

[21]  R Plana,et al.  Nanoscale characterization of different stiction mechanisms in electrostatically driven MEMS devices based on adhesion and friction measurements. , 2011, Journal of colloid and interface science.

[22]  A. Stemmer,et al.  Practical aspects of Kelvin probe force microscopy , 1999 .

[23]  John G. Simmons,et al.  Poole-Frenkel Effect and Schottky Effect in Metal-Insulator-Metal Systems , 1967 .

[24]  J. Cazaux,et al.  Reliability modeling of capacitive RF MEMS , 2005, IEEE Transactions on Microwave Theory and Techniques.

[25]  R Plana,et al.  On the influence of environment gases, relative humidity and gas purification on dielectric charging/discharging processes in electrostatically driven MEMS/NEMS devices , 2011, Nanotechnology.

[26]  B. Bhushan,et al.  Use of a nanoscale Kelvin probe for detecting wear precursors , 1998 .

[27]  J. Schmitz,et al.  Kelvin probe study of laterally inhomogeneous dielectric charging and charge diffusion in RF MEMS capacitive switches , 2008, 2008 IEEE International Reliability Physics Symposium.

[28]  Patrick Pons,et al.  Kelvin probe microscopy for reliability investigation of RF-MEMS capacitive switches , 2008, Microelectron. Reliab..

[29]  Patrick Pons,et al.  A systematic reliability investigation of the dielectric charging process in electrostatically actuated MEMS based on Kelvin probe force microscopy , 2010 .