Optimization of a micro Coriolis mass flow sensor using Lorentz force actuation

In this paper we present Finite Element models to optimize the Lorentz force actuation of a micro Coriolis mass flow sensor. These models specify six different configurations for the permanent magnets used to create the magnetic field for the actuation. The models are used to compare the various configurations in terms of the strength of the Lorentz force used for actuating the vibrational modes, and in terms of the sensitivity to misalignment of the magnetic field of the magnets. The simulations show that the Lorentz force actuation can be increased significantly by improving the placement of the magnets and that the actuation is insensitive to misalignment of the tube in relation to the magnetic field. By applying the models to a fabricated sensor, the magnetic field outside the sensor area has been reduced by 6 orders of magnitude. Due to the smaller size of the new permanent magnets, the footprint of the chip, including actuation, has been reduced by a factor 3. The models of two magnet configurations without misalignment have been validated with measurements.

[1]  M.J. de Boer,et al.  Micro Coriolis Mass Flow Sensor with Integrated Capacitive Readout , 2009, 2009 IEEE 22nd International Conference on Micro Electro Mechanical Systems.

[2]  Peter Enoksson,et al.  A silicon resonant sensor structure for Coriolis mass-flow measurements , 1997 .

[3]  Remco J. Wiegerink,et al.  Modeling, design, fabrication and characterization of a micro Coriolis mass flow sensor , 2010 .

[4]  H. Droogendijk,et al.  Highly sensitive micro coriolis mass flow sensor , 2008, 2008 IEEE 21st International Conference on Micro Electro Mechanical Systems.

[5]  Douglas Ray Sparks,et al.  A portable MEMS Coriolis mass flow sensor , 2003, Proceedings of IEEE Sensors 2003 (IEEE Cat. No.03CH37498).

[6]  T.S.J. Lammerink,et al.  Single chip flow sensing system with a dynamic flow range of more than 4 decades , 2011, 2011 16th International Solid-State Sensors, Actuators and Microsystems Conference.