Improvement in water and oil absorbency of textile substrate by atmospheric pressure cold plasma treatment

Cold plasma, an ionized mixture of gases with bulk temperature near the room temperature, can be safely used for surface modification of textile substrates. Plasma treatment can change surface hydrophilicity of the textile substrates by forming hydrophilic groups or can clean the surfaces by etching out top layers. With an aim to improve water absorbency of the textile substrates, nylon and polyester fabrics were treated continuously in an atmospheric-pressure-glow-discharge-plasma produced in presence of different gases. After plasma treatment, time taken in spreading a water droplet over a pre-defined area was found to decrease significantly. As expected, the chemical changes brought about by plasma, increased the surface energy of both nylon and polyester fabrics. However, the rate of oil absorption (a hydrophobic fluid) was also found to increase to a great extent. Spreading time for mustard oil droplet over a specified area was observed to decrease significantly from 152 s in an untreated fabric to 52 s in He plasma treated fabric for nylon, whereas, it decreased from 28.6 min in untreated fabric to 2.8 min in the treated fabric for PET samples. The effect of plasma treatment on the rate of oil absorbency was further confirmed for cotton fabrics, where the time for oil absorbency decreased from 59.5 s in the untreated sample to 30.4 s in the treated sample. The atomic force microscopy (AFM) analysis of the treated fabrics revealed the formation of nano-sized channels on their surfaces. The samples, after plasma treatment, showed only a marginal drop in their mechanical properties.

[1]  U. Vohrer,et al.  Glow-discharge treatment for the modification of textiles , 1998 .

[2]  J. Yip,et al.  Low temperature plasma-treated nylon fabrics , 2002 .

[3]  L. Meda,et al.  Cold plasma-induced modification of the dyeing properties of poly(ethylene terephthalate) fibers , 2006 .

[4]  G. Borcia,et al.  Surface treatment of natural and synthetic textiles using a dielectric barrier discharge , 2006 .

[5]  J. Roth,et al.  Surface Modification of Fabrics Using a One-Atmosphere Glow Discharge Plasma to Improve Fabric Wettability , 1997 .

[6]  S. Venkatakrishnan,et al.  Antisoiling of polyester (PET) by a novel method of plasma treatments and its evaluation by color measurement , 1990 .

[7]  A. Neimark,et al.  The Wicking Kinetics of Liquid Droplets into Yarns , 2001 .

[8]  D. Vangeneugden,et al.  Physical and chemical properties of hybrid barrier coatings obtained in an atmospheric pressure dielectric barrier discharge , 2005 .

[9]  R. Delobel,et al.  Elaboration of a fire retardant coating for polyamide-6 using cold plasma polymerization of a fluorinated acrylate , 2004 .

[10]  Yukihiro Sato,et al.  Surface Characteristics of Wool and Poly ( ethylene Terephthalate) Fabrics and Film Treated with Low-Temperature Plasma Under Atmospheric Pressure , 1993 .

[11]  F. Hochart,et al.  Graft-polymerization of a hydrophobic monomer onto PAN textile by low-pressure plasma treatments , 2003 .

[12]  H. Uchiyama,et al.  Dyeing Properties of Wool Treated with Low-Temperature Plasma Under Atmospheric Pressure , 1993 .

[13]  Hartwig Höcker,et al.  Plasma treatment of textile fibers , 2002 .

[14]  P. Ning,et al.  Surface modification of PBO fibers by argon plasma and argon plasma combined with coupling agents , 2006 .

[15]  C. J. Jahagirdar,et al.  Study of plasma polymerization of dichloromethane on cotton and polyester fabrics , 2004 .

[16]  Weidong Gao,et al.  Dynamic water adsorption behaviour of plasma-treated polypropylene nonwovens , 2006 .

[17]  G. Stevens,et al.  Adhesion enhancement of polymer surfaces by atmospheric plasma treatment , 2001 .

[18]  Wu Gwo-Mei.  Oxygen plasma treatment of high performance fibers for composites , 2004 .

[19]  Y. Qiu,et al.  Effect of Atmospheric Plasma Treatment on Desizing of PVA on Cotton , 2003 .