An Improved Impactor Design for Eliminating Spallation in High-Impedance Flyers During Hypervelocity Launch

[1]  Q. Shen,et al.  Interfacial Microstructure and Mechanical Strength of 93W/Ta Diffusion-Bonded Joints with Ni Interlayer , 2013, Metallurgical and Materials Transactions A.

[2]  Q. Shen,et al.  An investigation on diffusion bonding of aluminum and magnesium using a Ni interlayer , 2012 .

[3]  Q. Shen,et al.  Effects of Zn additions on the solid-state sintering of W–Cu composites , 2012 .

[4]  Vincent T. Romero,et al.  Asay window: A new spall diagnostic , 2006 .

[5]  Jidong Weng,et al.  Optical-fiber interferometer for velocity measurements with picosecond resolution , 2006 .

[6]  Lalit C. Chhabildas,et al.  HVL{_}CTH: A Simple Tool That Simulates The Hyper-Velocity Launch of a Flyer Plate , 2003 .

[7]  Nancy A. Winfree,et al.  Equation of state measurements of materials using a three-stage gun to impact velocities of 11 km/s , 2000 .

[8]  Lalit C. Chhabildas,et al.  Time-resolved particle velocity measurements at impact velocities of 10 km/s , 1998 .

[9]  G. R. Gathers.  Determination of spall strength from surface motion studies , 1990 .

[10]  Ping Li,et al.  The gas gun launch advances in numerical simulation of hypervelocity impact , 2014 .

[11]  B. Jing.  A Numerical Analysis of the Influence of Buffer Material on Tantalum Flier Plate Velocity in the Hypervelocity Launcher , 2008 .

[12]  Mario Pagliaro,et al.  Fundamentals of Shock Wave Propagation in Solids , 2008 .

[13]  Lalit C. Chhabildas,et al.  An impact technique to accelerate flier plates to velocities over 12 km/s , 1993 .

[14]  Y. Syono,et al.  High-pressure research : application to earth and planetary sciences , 1992 .

[15]  Marc A. Meyers,et al.  Dynamic fracture (spalling) of metals , 1983 .