High resolution X-ray microtomography-based CFD simulation for the characterization of flow permeability and effective thermal conductivity of aluminum metal foams

Abstract Nowadays, the need for developing more effective heat transfer technologies and innovative materials, capable of increasing performances while keeping power consumption, cost and size at reasonable levels, is well understood. Under this perspective, metal foams are gaining attention in view of their potential for increasing the thermal efficiency of heat transfer devices, while allowing the use of smaller and lighter equipments. In this work, the results of high-resolution X-ray microtomography-based CFD simulations, performed on three open-cell aluminum foams samples of different pore densities (10–20–30 PPI), will be illustrated. The computed values of permeability and effective thermal conductivity are reported and compared to the corresponding experimental values available in the literature. The flow simulations were conducted with an incompressible flow of air at steady state and in laminar flow regime (the Reynolds number, defined on the nominal pore diameter of the foam and the superficial velocity, was varied between 1 and 100).

[1]  W. Hsieh,et al.  Measurement and correlation of friction characteristic of flow through foam matrixes , 2006 .

[2]  F. Topin,et al.  Flow Laws in Metal Foams: Compressibility and Pore Size Effects , 2008 .

[3]  R. Mahajan,et al.  Metal Foam and Finned Metal Foam Heat Sinks for Electronics Cooling in Buoyancy-Induced Convection , 2006 .

[4]  R. Mahajan,et al.  The Effective Thermal Conductivity of High Porosity Fibrous Metal Foams , 1999 .

[5]  A. Cavallini,et al.  Heat Transfer Performance of Aluminum Foams , 2011 .

[6]  Claudio Zilio,et al.  Pressure drop during air flow in aluminum foams , 2010 .

[7]  N. Dukhan.  Correlations for the pressure drop for flow through metal foam , 2006 .

[8]  Suresh V. Garimella,et al.  Microtomography-Based Simulation of Transport through Open-Cell Metal Foams , 2010 .

[9]  J. Murthy,et al.  Direct simulation of transport in open-cell metal foam , 2006 .

[10]  E. Vallazza,et al.  SYNCHROTRON-RADIATION MICROTOMOGRAPHY FOR THE NON-DESTRUCTIVE STRUCTURAL EVALUATION OF BOWED STRINGEDINSTRUMENTS , 2010 .

[11]  C. Balaji,et al.  Experimental investigation of flow assisted mixed convection in high porosity foams in vertical channels , 2011 .

[12]  T. Fend,et al.  Effective permeability and thermal conductivity of open-cell metallic foams via homogenization on a microstructure model , 2009 .

[13]  I. Dincer,et al.  Exergy transfer in a porous rectangular channel , 2010 .

[14]  R. Mahajan,et al.  Forced Convection in High Porosity Metal Foams , 2000 .

[15]  A. T. Prata,et al.  Performance of microchannel condensers with metal foams on the air-side: Application in small-scale refrigeration systems , 2012 .

[16]  P. Magnico.  Analysis of permeability and effective viscosity by CFD on isotropic and anisotropic metallic foams , 2009 .

[17]  Claudio Zilio,et al.  Experimental air heat transfer and pressure drop through copper foams , 2012 .

[18]  F. Topin,et al.  About the use of fibrous materials in compact heat exchangers , 2004 .

[19]  A. Steinfeld,et al.  Tomography based determination of permeability, Dupuit–Forchheimer coefficient, and interfacial heat transfer coefficient in reticulate porous ceramics , 2008 .

[20]  J. Hyun,et al.  Effective Thermal Conductivity and Permeability of Aluminum Foam Materials1 , 2000 .

[21]  L. Feldkamp,et al.  Practical cone-beam algorithm , 1984 .

[22]  L. Mancini,et al.  High resolution microtomography-based CFD simulation of flow and heat transfer in aluminum metal foams , 2014 .

[23]  Lucia Mancini,et al.  Quantitative analysis of X-ray microtomography images of geomaterials: Application to volcanic rocks , 2010 .

[24]  Claudio Zilio,et al.  Heat transfer during air flow in aluminum foams , 2010 .

[25]  Yiannis Ventikos,et al.  Simulations of flow through open cell metal foams using an idealized periodic cell structure , 2003 .

[26]  Enrico Bianchi,et al.  An appraisal of the heat transfer properties of metallic open-cellfoams for strongly exo-/endo-thermic catalytic processes in tubular reactors , 2012 .

[27]  B. Kang,et al.  Forced convection from aluminum foam materials in an asymmetrically heated channel , 2001 .

[28]  J. Matsuo,et al.  A Study on Effective Thermal Conductivity of Porous Metals. , 1992 .

[29]  R. Mahajan,et al.  Thermophysical properties of high porosity metal foams , 2002 .

[30]  D. Bouris,et al.  3D numerical simulation of flow and conjugate heat transfer through a pore scale model of high porosity open cell metal foam , 2010 .

[31]  Roop L. Mahajan,et al.  Non-Darcy natural convection in high porosity metal foams , 2002 .

[32]  J. Thovert,et al.  Transport properties of real metallic foams. , 2010, Journal of colloid and interface science.