A Novel Crosstalk Suppression Method of the 2-D Networked Resistive Sensor Array

The 2-D resistive sensor array in the row–column fashion suffered from the crosstalk problem for parasitic parallel paths. Firstly, we proposed an Improved Isolated Drive Feedback Circuit with Compensation (IIDFCC) based on the voltage feedback method to suppress the crosstalk. In this method, a compensated resistor was specially used to reduce the crosstalk caused by the column multiplexer resistors and the adjacent row elements. Then, a mathematical equivalent resistance expression of the element being tested (EBT) of this circuit was analytically derived and verified by the circuit simulations. The simulation results show that the measurement method can greatly reduce the influence on the EBT caused by parasitic parallel paths for the multiplexers' channel resistor and the adjacent elements.

[1]  Yu Zhongzhou.  A Small Size Device Using Temperature Sensor Array , 2011 .

[2]  Yon-Kyu Park,et al.  Design concept of high-performance flexible tactile sensors with a robust structure , 2012 .

[3]  Tommaso D'Alessio,et al.  Measurement errors in the scanning of piezoresistive sensors arrays , 1999 .

[4]  Manuele Bernabei,et al.  Design of a very large chemical sensor system for mimicking biological olfaction , 2010 .

[5]  R. K. Bhan,et al.  A new discrete circuit for readout of resistive sensor arrays , 2009 .

[6]  R. K. Bhan,et al.  Crosstalk suppression in networked resistive sensor arrays using virtual ground technique , 2013 .

[7]  Mircea Arcan,et al.  Dynamic contact stress analysis using a compliant sensor array , 1993 .

[8]  Fernando Vidal-Verdú,et al.  Tactile sensors based on conductive polymers , 2010 .

[9]  R K Bhan,et al.  Analysis of Crosstalk in Networked Arrays of Resistive Sensors , 2011, IEEE Sensors Journal.

[10]  Alfonso García-Cerezo,et al.  A Large Area Tactile Sensor Patch Based on Commercial Force Sensors , 2011, Sensors.

[11]  C. R. Jalwania,et al.  A Novel Test Structure for Process Control Monitor for Un-Cooled Bolometer Area Array Detector Technology , 2006 .

[12]  Raghvendra Sahai Saxena,et al.  Virtual Ground Technique for Crosstalk Suppression in Networked Resistive Sensors , 2011, IEEE Sensors Journal.

[13]  K. Fan,et al.  A 32 × 32 temperature and tactile sensing array using PI-copper films , 2010 .

[14]  Thomas H. Speeter.  A Tactile Sensing System for Robotic Manipulation , 1990, Int. J. Robotics Res..

[15]  Óscar Oballe-Peinado,et al.  Three Realizations and Comparison of Hardware for Piezoresistive Tactile Sensors , 2011, Sensors.

[16]  Yuanfei Zhang,et al.  Measurement errors in the scanning of resistive sensor arrays , 2010 .

[17]  R. K. Bhan,et al.  PSPICE circuit simulation of microbolometer infrared detectors with noise sources , 2012 .

[18]  Jianqing Li,et al.  VF-NSE method measurement error analysis of networked resistive sensor array , 2014 .

[19]  JianQing Li,et al.  Design and Crosstalk Error Analysis of the Circuit for the 2-D Networked Resistive Sensor Array , 2015, IEEE Sensors Journal.

[20]  Yu-long Zhao,et al.  Design and fabrication of a thin and soft tactile force sensor array based on conductive rubber , 2012 .