Experimental and numerical studies of a U-shaped solar energy collector to track the maximum CPV/T system output by varying the flow rate

In the last decade, no comprehensive numerical and experimental analyses have been performed to find the maximum possible power generation from a concentrated photovoltaic thermal (CPV/T) system by varying the flow rate of the fluid. This paper describes numerical and experimental studies of a U-shaped solar energy collector model of a CPV/T system, with the goal of determining the maximal thermal and electrical power outputs against a specific volumetric flow rate also called an optimum flow rate. The CPV/T system was based on the union of 8 triple junction solar cells, 8 SOG Fresnel lenses, effective dual-axis tracking, and a forced cooling system. Analyses were performed by changing the flow rate of the working fluid at a considered solar irradiation and ambient temperature. The thermal and electrical power outputs also varied with changes in the ambient temperature and available solar radiation. The relatively high value of CPV/T power was observed against the optimum flow rate at a given irradiation and ambient temperature. Analysis of the energy of the U- shaped solar energy collector system was evaluated experimentally. The numerical results and experimental measurements of the U-shaped solar energy collector model showed great harmony, with minimal deviations of <7% between them.

[1]  Zied Chtourou,et al.  Artificial Neural Network based control for PV/T panel to track optimum thermal and electrical power , 2013 .

[2]  Zhang Tao,et al.  Annual analysis of heat pipe PV/T systems for domestic hot water and electricity production , 2012 .

[3]  Arvind Tiwari,et al.  Exergy analysis of integrated photovoltaic thermal solar water heater under constant flow rate and constant collection temperature modes , 2009 .

[4]  Ruzhu Wang,et al.  Numerical and experimental analysis of a point focus solar collector using high concentration imaging PMMA Fresnel lens , 2011 .

[5]  Li Zhu,et al.  The performance and long-term stability of silicon concentrator solar cells immersed in dielectric liquids , 2013 .

[6]  Damir Dović,et al.  Numerically assisted analysis of flat and corrugated plate solar collectors thermal performances , 2012 .

[7]  A. Q. Malik,et al.  Optimum tilt angle and orientation for solar collector in Brunei Darussalam , 2001 .

[8]  Rattanasuda Naewngerndee,et al.  Finite element method for computational fluid dynamics to design photovoltaic thermal (PV/T) system configuration , 2011 .

[9]  Xiaosong Zhang,et al.  Experimental study on the operating characteristics of a novel low-concentrating solar photovoltaic/thermal integrated heat pump water heating system , 2011 .

[10]  Xin Li,et al.  Dynamic test model for the transient thermal performance of parabolic trough solar collectors , 2013 .

[11]  Kim Tiow Ooi,et al.  Analytical models for the computation and optimization of single and double glazing flat plate solar collectors with normal and small air gap spacing , 2013 .

[12]  Niccolò Aste,et al.  Thermal-electrical optimization of the configuration a liquid PVT collector , 2012 .

[13]  Hasila Jarimi,et al.  Design concept and mathematical model of a bi-fluid photovoltaic/thermal (PV/T) solar collector , 2014 .

[14]  M. U. Siddiqui,et al.  Three-dimensional thermal modeling of a photovoltaic module under varying conditions , 2012 .

[15]  Xu Ji,et al.  Performance study of solar cell arrays based on a Trough Concentrating Photovoltaic/Thermal system , 2011 .

[16]  James K. Carson,et al.  Effect of flow distribution on the photovoltaic performance of a building integrated photovoltaic/thermal (BIPV/T) collector , 2012 .

[17]  J. I. Rosell,et al.  Hybrid photovoltaic–thermal solar collectors dynamic modeling , 2013 .

[18]  Abul Fazal M. Arif,et al.  Electrical, thermal and structural performance of a cooled PV module: Transient analysis using a multiphysics model , 2013 .

[19]  Francesco Calise,et al.  A novel solar trigeneration system based on concentrating photovoltaic/thermal collectors. Part 1: Design and simulation model , 2013 .

[20]  Abraham Kribus,et al.  Solar cooling with concentrating photovoltaic/thermal (CPVT) systems , 2007 .

[21]  Kok-Keong Chong,et al.  A comprehensive study of dense-array concentrator photovoltaic system using non-imaging planar concentrator , 2014 .

[22]  W. Beckman,et al.  Solar Engineering of Thermal Processes , 1985 .

[23]  Chien-Hsiung Tsai,et al.  Numerical investigation of high-concentration photovoltaic module heat dissipation , 2013 .

[24]  Alistair B. Sproul,et al.  Maximising the energy output of a PVT air system , 2012 .

[25]  Y. Tripanagnostopoulos,et al.  Air-cooled PV/T solar collectors with low cost performance improvements , 2007 .

[26]  Xiaosong Zhang,et al.  Double-stage photovoltaic/thermal ED regeneration for liquid desiccant cooling system , 2012 .

[27]  Farzad Jafarkazemi,et al.  Energetic and exergetic evaluation of flat plate solar collectors , 2013 .

[28]  Deepali Kamthania,et al.  Performance evaluation of a hybrid photovoltaic thermal double pass facade for space heating , 2011 .

[29]  Tapas K. Mallick,et al.  Effects of Nonuniform Incident Illumination on the Thermal Performance of a Concentrating Triple Junction Solar Cell , 2014 .