Sheet Resistance Determination Using Symmetric Structures With Contacts of Finite Size

This paper proposes an extension of van der Pauw's celebrated method for the extraction of the sheet resistance Rsq of planar homogeneously conducting samples with four point-like contacts to symmetric samples with contacts of finite length. Using the method, Rsq can be extracted, e.g., from symmetric integrated Hall plates and stress sensors, without having to resort to dedicated van der Pauw structures. First, the analog of van der Pauw's formula for arbitrarily shaped samples with four extended contacts separated by point-like insulations is derived. Based on this and van der Pauw's original result, an interpolation formula applicable to symmetric samples with contacts of arbitrary length is constructed. The new formalism was successfully put to the test using ten widely differing CMOS sensor structures, with contacts covering between 10.1% and 91.3% of the device periphery. The extracted Rsq values lie within the range specified by the CMOS foundry used for the fabrication of the samples and show a relative standard deviation of 1.04%.

[1]  Henry Baltes,et al.  Offset reduction in Hall devices by continuous spinning current method , 1998 .

[2]  Christoph Maier,et al.  Contactless angle measurement using four Hall devices on single chip , 1997, Proceedings of International Solid State Sensors and Actuators Conference (Transducers '97).

[3]  W. R. Thurber,et al.  An Experimental Study of Various Cross Sheet Resistor Test Structures , 1978 .

[4]  L. J. V. D. Pauw A METHOD OF MEASURING SPECIFIC RESISTIVITY AND HALL EFFECT OF DISCS OF ARBITRARY SHAPE , 1991 .

[5]  W. Versnel,et al.  Analysis of symmetrical Hall plates with finite contacts , 1981 .

[6]  Peter Blood,et al.  The Electrical Characterization of Semiconductors: Majority Carriers and Electron States , 1992 .

[7]  Patrick Ruther,et al.  Geometry optimization for planar piezoresistive stress sensors based on the pseudo-Hall effect , 2006 .

[8]  Patrick Ruther,et al.  Thermomagnetic residual offset in integrated Hall plates , 2002, Proceedings of IEEE Sensors.

[9]  C. R. Crowell,et al.  Contact size effects on the van der Pauw method for resistivity and Hall coefficient measurement , 1974 .

[10]  Radivoje Popovic,et al.  Hall effect devices , 1991 .

[11]  P. Blood,et al.  The electrical characterisation of semiconductors , 1978 .

[12]  R.C. Jaeger,et al.  The van der Pauw stress sensor , 2006, IEEE Sensors Journal.

[13]  O. Paul,et al.  Piezo-FET stress-sensor arrays for wire-bonding characterization , 2006, Journal of Microelectromechanical Systems.

[14]  J. Marêché,et al.  Contactless resistivity measurements: a technique adapted to graphite intercalation compounds , 1980 .

[15]  S. Grützmann The application of the relaxation method to the calculation of the potential distribution of Hall plates , 1966 .

[16]  F. Smits Measurement of sheet resistivities with the four-point probe , 1958 .

[17]  D. W. Koon Effect of contact size and placement, and of resistive inhomogeneities on van der Pauw measurements , 1989 .

[18]  J. Haeusler,et al.  Exakte lösungen von potentialproblemen beim Halleffekt durch konforme abbildung , 1966 .

[19]  W. Versnel Analysis of the Greek cross, a Van der Pauw structure with finite contacts , 1979 .

[20]  L. B. Valdes,et al.  Resistivity Measurements on Germanium for Transistors , 1954, Proceedings of the IRE.