Transport, chemical and electrochemical processes in a planar solid oxide fuel cell: Detailed three-dimensional modeling

A detailed numerical three-dimensional (3D) model for a planar solid oxide fuel cell (SOFC) is developed in this paper. The 3D model takes into account detailed processes including transport, chemical and electrochemical processes taking place in the cell. Moreover, effects of the composite electrodes are taken into account by considering an electrochemically active layer of finite thickness in each of the electrodes. The developed model is applied to a repeating unit of an anode-supported SOFC working under direct internal reforming conditions. Detailed results for chemical species, temperature, current density and electric potential distribution are presented and discussed. It was found that the temperature distribution across the cell is more uniform in the interconnects than in the inner part of the cell. However, only small differences in the electric potential between the electrode and the corresponding interconnect are found. The current density in the electrodes is found to be high near the electrolyte and low deep into the electrochemically active layer. The current density is also low under the ribs of the interconnects.

[1]  Y. Inui,et al.  Analytical investigation on cell temperature control method of planar solid oxide fuel cell , 2006 .

[2]  Kyle J. Daun,et al.  Radiation heat transfer in planar SOFC electrolytes , 2006 .

[3]  Alex C. Hoffmann,et al.  Modeling of transport, chemical and electrochemical phenomena in a cathode-supported SOFC , 2009 .

[4]  M. Khaleel,et al.  Three-dimensional thermo-fluid electrochemical modeling of planar SOFC stacks , 2003 .

[5]  A. Chaisantikulwat,et al.  Dynamic modelling and control of planar anode-supported solid oxide fuel cell , 2008, Comput. Chem. Eng..

[6]  Kohei Ito,et al.  Performance analysis of planar-type unit SOFC considering current and temperature distributions , 2000 .

[7]  Vinod M. Janardhanan,et al.  Numerical study of mass and heat transport in solid-oxide fuel cells running on humidified methane , 2007 .

[8]  R. Kee,et al.  Modeling Distributed Charge-Transfer Processes in SOFC Membrane Electrode Assemblies , 2008 .

[9]  Yoshitaka Inui,et al.  Performance simulation of planar SOFC using mixed hydrogen and carbon monoxide gases as fuel , 2006 .

[10]  I. Yasuda,et al.  3-D model calculation for planar SOFC , 2001 .

[11]  Xin-jian Zhu,et al.  Two-dimensional dynamic simulation of a direct internal reforming solid oxide fuel cell , 2007 .

[12]  L. Schaefer,et al.  A numerical model coupling the heat and gas species' transport processes in a tubular SOFC , 2004 .

[13]  Ayodeji Jeje,et al.  3D modeling of anode-supported planar SOFC with internal reforming of methane , 2007 .

[14]  Yann Bultel,et al.  Modeling of a SOFC fuelled by methane: From direct internal reforming to gradual internal reforming , 2007 .

[15]  D. Jeon,et al.  A comprehensive micro-scale model for transport and reaction in intermediate temperature solid oxide fuel cells , 2006 .

[16]  Alex C. Hoffmann,et al.  Numerical analysis of a planar anode-supported SOFC with composite electrodes , 2009 .

[17]  Andrei G. Fedorov,et al.  Spectral Radiative Heat Transfer Analysis of the Planar SOFC , 2005 .

[18]  K. Karan,et al.  Engineering of microstructure and design of a planar porous composite SOFC cathode: A numerical analysis , 2007 .

[19]  Robert J. Kee,et al.  Importance of Anode Microstructure in Modeling Solid Oxide Fuel Cells , 2008 .

[20]  C. Adjiman,et al.  Anode-supported intermediate temperature direct internal reforming solid oxide fuel cell. I: model-based steady-state performance , 2004 .

[21]  I. Dincer,et al.  Mathematical modeling of planar solid oxide fuel cells , 2006 .

[22]  Mohammad A. Khaleel,et al.  The effect of interconnect rib size on the fuel cell concentration polarization in planar SOFCs , 2003 .

[23]  Yingru Zhao,et al.  A new analytical approach to model and evaluate the performance of a class of irreversible fuel cells , 2008 .

[24]  Xiongwen Zhang,et al.  Numerical study on electric characteristics of solid oxide fuel cells , 2007 .

[25]  Tohru Kato,et al.  Numerical analysis of output characteristics of tubular SOFC with internal reformer , 2001 .

[26]  Stefano Ubertini,et al.  Experimental and numerical analysis of a radial flow solid oxide fuel cell , 2007 .

[27]  Allen J. Bard,et al.  Electrochemical Methods: Fundamentals and Applications , 1980 .

[28]  Yoshitaka Inui,et al.  Three dimensional analysis of planar solid oxide fuel cell stack considering radiation , 2007 .

[29]  Hiroshi Iwai,et al.  Quantification of SOFC anode microstructure based on dual beam FIB-SEM technique , 2010 .

[30]  Vinod M. Janardhanan,et al.  Modeling Elementary Heterogeneous Chemistry and Electrochemistry in Solid-Oxide Fuel Cells , 2005 .