Sensing mechanism of RuO2–SnO2 thick film pH sensors studied by potentiometric method and electrochemical impedance spectroscopy

Abstract In this work, we developed thick film pH sensors based on the nanostructured RuO 2 –SnO 2 system and analyzed their sensing mechanism using the potentiometric and electrochemical impedance spectroscopic (EIS) methods. The crystal structure and morphology of the sensitive films were investigated by X-ray diffractometry, Raman spectroscopy, scanning electron microscopy and energy dispersive spectroscopy. The potentiometric sensor exhibits Nernstian behavior (56.5 mV/pH) in the pH range of 2–12. It shows very fast response (5 s and 9 s, for acidic to basic and basic to acidic solutions), long lifetime, small hysteresis effect, and good reproducibility. Selectivity test proved that the presence of Li + , Na + , and K + ions in a solution had no significant influence on the sensor performance. Conductance, capacitance and impedance of the conductimetric pH sensor with the interdigitated electrode were found to vary with changing pH and as a function of the applied frequency in the range of 10 Hz–2 MHz. The EIS analysis of the complex impedance data by using Nyquist and Bode plots revealed the information about the underlying processes, like adsorption, diffusion and charge transfer, occurring at the metal oxide-solution interface. The proposed thick film pH sensors were intended to be used for water pollution monitoring.

[1]  Catarina I. Gonçalves,et al.  Development of RuO2–TiO2 (70–30)mol% for pH measurements , 2006 .

[2]  Katarina N. Cvejin,et al.  Potentiometric RuO2-Ta2O5 pH sensors fabricated using thick film and LTCC technologies. , 2016, Talanta.

[3]  Bin Xu,et al.  Modification of vertically aligned carbon nanotubes with RuO2 for a solid-state pH sensor , 2010 .

[4]  P. Kurzweil,et al.  Metal Oxides and Ion-Exchanging Surfaces as pH Sensors in Liquids: State-of-the-Art and Outlook , 2009, Sensors.

[5]  S. Zhuiykov,et al.  Investigation of Electrochemical Properties of La2O3–RuO2 Thin‐Film Sensing Electrodes Used in Sensors for the Analysis of Complex Solutions , 2011 .

[6]  Lijian Meng.  Raman spectroscopy analysis of magnetron sputtered RuO2 thin films , 2003 .

[7]  A. Battisti,et al.  Investigation of RuO2–SnO2 thin film formation by thermogravimetry–mass spectrometry and infrared emission spectroscopy , 2006 .

[8]  Angel Diéguez,et al.  The complete Raman spectrum of nanometric SnO 2 particles , 2001 .

[9]  S. Zhuiykov.  Solid-state sensors monitoring parameters of water quality for the next generation of wireless sensor networks , 2012 .

[10]  S. Zhuiykov,et al.  Improved antifouling resistance of electrochemical water quality sensors based on Cu2O-doped RuO2 sensing electrode , 2011 .

[11]  R. Compton,et al.  Validating the geometry of interdigitated band electrodes: A variable scan rate study , 2015 .

[12]  E. Tombácz.  pH-dependent surface charging of metal oxides , 2009 .

[13]  Vadim F. Lvovich,et al.  Impedance Spectroscopy: Applications to Electrochemical and Dielectric Phenomena , 2012 .

[14]  Krzysztof Zaraska,et al.  Electrochemical Impedance Spectroscopic Analysis of RuO2 Based Thick Film pH Sensors , 2015 .

[15]  Winfried Vonau,et al.  Recent developments in electrochemical sensor application and technology—a review , 2009 .

[16]  P. Kurzweil.  Precious metal oxides for electrochemical energy converters: Pseudocapacitance and pH dependence of redox processes , 2009 .

[17]  Agner Fog,et al.  Electronic semiconducting oxides as pH sensors , 1984 .

[18]  T. Kenny,et al.  CORRIGENDUM: Quantum Limit of Quality Factor in Silicon Micro and Nano Mechanical Resonators , 2014, Scientific Reports.

[19]  D. Macdonald.  Reflections on the history of electrochemical impedance spectroscopy , 2006 .

[20]  D. Guay,et al.  Physicochemical Characterization of Mixed RuO 2 -SnO 2 Solid Solutions , 2005 .

[21]  D. E. Yates,et al.  Site-binding model of the electrical double layer at the oxide/water interface , 1974 .

[22]  Katarina N. Cvejin,et al.  The Effect of Sheet Resistivity and Storage Conditions on Sensitivity of RuO2 Based pH Sensors , 2014 .

[23]  Cengiz S. Ozkan,et al.  Hydrous Ruthenium Oxide Nanoparticles Anchored to Graphene and Carbon Nanotube Hybrid Foam for Supercapacitors , 2014, Scientific Reports.

[24]  Yu Xie,et al.  Facile ultrasonic synthesis of graphene/SnO2 nanocomposite and its application to the simultaneous electrochemical determination of dopamine, ascorbic acid, and uric acid , 2015 .

[25]  I. Suni.  Impedance methods for electrochemical sensors using nanomaterials , 2008 .

[26]  B. Pejcic,et al.  Electrochemical impedance spectroscopy and X-ray photoelectron spectroscopy study of the response mechanism of the chalcogenide glass membrane iron(III) ion-selective electrode in saline media. , 2000, Analytical chemistry.

[27]  Jing-en Zhou,et al.  Microstructure, morphology and electrochemical property of RuO270SnO230 mol% and RuO230SnO270 mol% coatings , 2007 .

[28]  Russell Binions,et al.  Metal Oxide Semi-Conductor Gas Sensors in Environmental Monitoring , 2010, Sensors.

[29]  Andrew J. DeRouin,et al.  A Varactor-Based, Inductively Coupled Wireless pH Sensor , 2011, IEEE Sensors Journal.

[30]  Krzysztof Zaraska,et al.  Fabrication of thick film sensitive RuO2-TiO2 and Ag/AgCl/KCl reference electrodes and their application for pH measurements , 2014 .

[31]  Magnus Willander,et al.  The pH Response and Sensing Mechanism of n-Type ZnO/Electrolyte Interfaces , 2009, Sensors.

[32]  H. Hsu,et al.  Raman scattering characterization of well-aligned RuO2 nanocrystals grown on sapphire substrates , 2007 .

[33]  Khalil Arshak,et al.  Investigation of tin oxides as sensing layers in conductimetric interdigitated pH sensors , 2007 .

[34]  Qing Wang,et al.  Electrochemical impedance spectroscopic analysis of dye-sensitized solar cells. , 2005, The journal of physical chemistry. B.

[35]  Laurent Pilon,et al.  Physical Interpretation of Cyclic Voltammetry for Hybrid Pseudocapacitors , 2015 .