Damage detection in a composite wind turbine blade using 3D scanning laser vibrometry

As worldwide wind energy generation capacity grows, there is an increasing demand to ensure structural integrity of the turbine blades to maintain efficient and safe energy generation. Currently, traditional non-destructive testing methods and visual inspections are employed which require the turbine to be out-of-operation during the inspection periods, resulting in costly and lengthy downtime. This study experimentally investigates the potential for using Lamb waves to monitor the structural integrity of a composite wind turbine blade that has been subject to an impact representative of damage which occurs in service. 3D scanning laser vibrometry was used to measure Lamb waves excited at three different frequencies both prior to, and after, impact to identify settings for an optimal system. Signal processing techniques were applied to the datasets to successfully locate the damage and highlight regions on the structure where the Lamb wave was significantly influenced by the presence of the impact damage. Damage size resulting from the impact was found to correlate well with the laser vibrometry results. The study concluded that acousto-ultrasonic-based structural health monitoring systems have great potential for monitoring the structural integrity of wind turbine blades.

[1]  A. G. Dutton,et al.  Design, Fatigue Test and NDE of a Sectional Wind Turbine Rotor Blade , 2002 .

[2]  Carol Ann Featherston,et al.  Using genetic algorithms to optimize an active sensor network on a stiffened aerospace panel with 3D scanning laser vibrometry data , 2015 .

[3]  Bernd Frankenstein,et al.  Wireless system for structural health monitoring based on Lamb waves , 2012, Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[4]  Yozo Fujino,et al.  Experimental study of laser Doppler vibrometer and ambient vibration for vibration-based damage detection , 2006 .

[5]  Shoichi Kobayashi,et al.  Determination of Stress-Acoustic Coefficients of Rayleigh Wave by Use of Laser Doppler Velocimetry , 2001 .

[6]  Mark Eaton.  Acoustic Emission (AE) monitoring of buckling and failure in carbon fibre composite structures. , 2007 .

[7]  M. J. Blanch,et al.  Acoustic Emission Monitoring of Field Tests of an Operating Wind Turbine , 2003 .

[8]  R ROLFES,et al.  Integral SHM-System for Offshore Wind Turbines Using Smart Wireless Sensors , 2009 .

[9]  Eric Udd,et al.  Acoustic emission detection using fiber Bragg gratings , 2001, SPIE Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[10]  P. Stanley.  Applications and potential of thermoelastic stress analysis , 1997 .

[11]  Karen Margaret Holford,et al.  Characterisation of Damage in Composite Structures using Acoustic Emission , 2011 .

[12]  J. Rose.  Ultrasonic Waves in Solid Media , 1999 .

[13]  Fabrizio Scarpa,et al.  Structural health monitoring using scanning laser vibrometry: I. Lamb wave sensing , 2004 .

[14]  Jerome P. Lynch,et al.  Structural monitoring of wind turbines using wireless sensor networks , 2010 .

[15]  Carol Ann Featherston,et al.  Sensor location studies for damage detection in aerospace structures using 3D scanning laser vibrometry , 2015 .

[16]  O. Nishizawa,et al.  Detection of shear wave in ultrasonic range by using a laser Doppler vibrometer , 1998 .

[17]  K. L. Edwards.  Design data for reinforced plastics: A guide for engineers and designers , 1994 .

[18]  Anindya Ghoshal,et al.  Structural health monitoring techniques for wind turbine blades , 2000 .

[19]  H. Hanselka,et al.  Numerical and experimental investigation of lamb wave interaction with discontinuities , 2003 .

[20]  Karen Margaret Holford,et al.  On the Development of a Damage Detection System using Macro-fibre Composite Sensors , 2012 .

[21]  G. Hayward,et al.  Comparison of different piezoelectric materials for the design of embedded transducers for structural health monitoring applications , 2000, 2000 IEEE Ultrasonics Symposium. Proceedings. An International Symposium (Cat. No.00CH37121).

[22]  Branko Klarin,et al.  Thermal imaging and Thermoelastic Stress Analysis of impact damage of composite materials , 2011 .

[23]  Charles R. Farrar,et al.  An overview of modal-based damage identification methods , 1997 .

[24]  Charles R. Farrar,et al.  Novelty detection applied to vibration data from a CX-100 wind turbine blade under fatigue loading , 2012 .

[25]  Yunze He,et al.  Progress and trends in nondestructive testing and evaluation for wind turbine composite blade , 2016 .

[26]  Holger Speckmann,et al.  Structural Health Monitoring: A Contribution to the Intelligent Aircraft Structure , 2006 .

[27]  Hoon Sohn,et al.  Automated detection of delamination and disbond from wavefield images obtained using a scanning laser vibrometer , 2011 .

[28]  Karen Margaret Holford,et al.  Delta T source location for acoustic emission , 2007 .

[29]  Mayorkinos Papaelias,et al.  Wind turbine reliability analysis , 2013 .

[30]  Keith Worden,et al.  Rayleigh and Lamb Waves ‐ Basic Principles , 2001 .

[31]  Carol Ann Featherston,et al.  Assessment of Damage Detection in Composite Structures Using 3D Vibrometry , 2015 .

[32]  W. Staszewski,et al.  Fatigue crack detection in metallic structures with Lamb waves and 3D laser vibrometry , 2007 .

[33]  John E. Hurtado,et al.  In-field use of laser Doppler vibrometer on a wind turbine blade , 1998 .

[34]  Jung-Ryul Lee,et al.  Structural health monitoring for a wind turbine system: a review of damage detection methods , 2008 .

[35]  Young-Shin Lee,et al.  Damage assessment of wind turbine blade under static loading test using acoustic emission , 2014 .

[36]  Jung-Ryul Lee,et al.  Long distance laser ultrasonic propagation imaging system for damage visualization , 2011 .

[37]  Mark Rumsey,et al.  Application of damage detection techniques using wind turbine modal data , 1998 .

[39]  Assimina A. Pelegri,et al.  Analysis of 3D random chopped fiber reinforced composites using FEM and random sequential adsorption , 2008 .

[40]  D R Ambur,et al.  Damage-Tolerance Characteristics of Composite Fuselage Sandwich Structures With Thick Facesheets , 1997 .

[41]  Henry A. Sodano,et al.  A review of power harvesting using piezoelectric materials (2003–2006) , 2007 .

[42]  Gyuhae Park,et al.  A full-scale fatigue test of 9-m CX-100 wind turbine blades , 2011 .

[43]  C. P. Debel,et al.  Improved design of large wind turbine blade of fibre composites based on studies of scale effects (Phase 1) - Summary Report , 2004 .

[44]  S.-E. Chen,et al.  Nondestructive bridge cable tension assessment using laser vibrometry , 2005 .

[45]  George Marsh.  The challenge of wind turbine blade repair , 2011 .

[46]  HighWire Press.  Proceedings of the Royal Society of London. Series A, Containing papers of a mathematical and physical character , 1934 .

[47]  Yoshihiro Mizutani,et al.  Noncontact detection of delamination in impacted cross-ply CFRP using laser-generated Lamb waves , 2001, SPIE Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[48]  I. G. Tuluzov,et al.  Method of remote dynamic thermographic testing of wind turbine blades , 2014 .

[49]  K. Maslov,et al.  Scanning Laser Vibrometry for Lamb Wave Evaluation of Composite Tubulars , 1998 .

[50]  Nobuo Takeda,et al.  Development of smart composite structures with small-diameter fiber Bragg grating sensors for damage detection: Quantitative evaluation of delamination length in CFRP laminates using Lamb wave sensing , 2005 .

[51]  Keith Worden,et al.  An Overview of Intelligent Fault Detection in Systems and Structures , 2004 .

[52]  J.-Y. Kim,et al.  Nondestructive sizing and localization of internal microcracks in fatigue samples , 2007 .

[53]  Andrew Kusiak,et al.  The prediction and diagnosis of wind turbine faults , 2011 .

[54]  Carlos E. S. Cesnik,et al.  Review of guided-wave structural health monitoring , 2007 .

[55]  H. Lamb.  On waves in an elastic plate , 1917 .

[56]  Enrico Primo Tomasini,et al.  Laser Doppler Vibrometry: Development of advanced solutions answering to technology's needs , 2006 .

[57]  M. Allen,et al.  Output-Only Modal Analysis Using Continuous-Scan Laser Doppler Vibrometry and Application to a 20 kW Wind Turbine , 2010 .

[58]  Jung-Ryul Lee,et al.  A novel fiber Bragg grating acoustic emission sensor head for mechanical tests , 2005 .