Control-oriented modeling analysis and optimization of planar solid oxide fuel cell system

Abstract Because of multi-timescale characteristics and gas transmission delays, the thermal electrical cooperative control of solid oxide fuel cells is a complex and difficult issue. We have used modeling, analysis and optimization of a solid oxide fuel cell system control to guarantee a high efficiency and temperature safety during steady-state and power switch transients. An analysis-based optimization method that applies to discrete optimization problem with constraints is proposed to obtain optimal operating points with a maximum efficiency and to satisfy temperature constraints. Artificial neural-network models that were identified from a validated two-dimensional differential model were used to analyze the temperature constraints and system efficiency. Compared with traversal optimization in literature, the proposed optimization method could save more than 90% of the workload and allow for a more reasonable choice of variable discrete precision. The optimization results were proven feasible by the proposed new system structure and stack inlet condition-based control strategy. The simulation results show that the key problems of the solid oxide fuel cell system control, which include temperature safety, fast load following, fuel starvation and efficiency promotion, could be solved by the proposed strategy.

[1]  Zhonghua Deng,et al.  A nonlinear sliding mode observer for the estimation of temperature distribution in a planar solid oxide fuel cell , 2015 .

[2]  S. Campanari,et al.  Comparison of Finite Volume SOFC Models for the Simulation of a Planar Cell Geometry , 2005 .

[3]  Wenjian Cai,et al.  Control oriented modeling of ejector in anode gas recirculation solid oxygen fuel cell systems , 2011 .

[4]  B.H. Chowdhury,et al.  SOFC-based Fuel Cells for Load Following Stationary Applications , 2006, 2006 38th North American Power Symposium.

[5]  Lieh-Kwang Chiang,et al.  Thermal stress analysis of a planar SOFC stack , 2007 .

[6]  Achim Kienle,et al.  Development and experimental investigation of an extended Kalman filter for a molten carbonate fuel cell system , 2006 .

[7]  Lin Zhang,et al.  Control strategy for power management, efficiency-optimization and operating-safety of a 5-kW solid oxide fuel cell system , 2015 .

[8]  F. Calise,et al.  Design and partial load exergy analysis of hybrid SOFC–GT power plant , 2006 .

[9]  Jeong L. Sohn,et al.  Performance characteristics of part-load operations of a solid oxide fuel cell/gas turbine hybrid system using air-bypass valves , 2008 .

[10]  Faryar Jabbari,et al.  Novel solid oxide fuel cell system controller for rapid load following , 2007 .

[11]  I. Yasuda,et al.  3-D model calculation for planar SOFC , 2001 .

[12]  M. Khaleel,et al.  Three-dimensional thermo-fluid electrochemical modeling of planar SOFC stacks , 2003 .

[13]  Xi Li,et al.  Thermal management of an independent steam reformer for a solid oxide fuel cell with constrained generalized predictive control , 2012 .

[14]  Mohsen Assadi,et al.  Artificial neural network model of a short stack solid oxide fuel cell based on experimental data , 2014 .

[15]  Comas Haynes,et al.  Simulating process settings for unslaved SOFC response to increases in load demand , 2002 .

[16]  Xi Li,et al.  Dynamic modeling and analysis of a 5-kW solid oxide fuel cell system from the perspectives of cooperative control of thermal safety and high efficiency , 2015 .

[17]  F. Jabbari,et al.  Feedback control of solid oxide fuel cell spatial temperature variation , 2010 .

[18]  Dai Fei Liu,et al.  Optimal Control for Aluminum Hydroxide Calcinations Based on Fuzzy Neural Networks , 2009, 2009 International Conference on Energy and Environment Technology.

[19]  Kohei Ito,et al.  Performance analysis of planar-type unit SOFC considering current and temperature distributions , 2000 .

[20]  C. Adjiman,et al.  Anode-supported intermediate temperature direct internal reforming solid oxide fuel cell. I: model-based steady-state performance , 2004 .

[21]  Lieh-Kwang Chiang,et al.  Thermo-electrochemical and thermal stress analysis for an anode-supported SOFC cell , 2008 .

[22]  Gang Feng,et al.  Rapid Load Following of an SOFC Power System via Stable Fuzzy Predictive Tracking Controller , 2009, IEEE Trans. Fuzzy Syst..

[23]  Y. Inui,et al.  Analytical investigation on cell temperature control method of planar solid oxide fuel cell , 2006 .

[24]  L. A. Chick,et al.  Demonstration of a highly efficient solid oxide fuel cell power system using adiabatic steam reforming and anode gas recirculation , 2012 .

[25]  S.S. Choi,et al.  An analysis of the control and operation of a solid oxide fuel-cell power plant in an isolated system , 2005, IEEE Transactions on Energy Conversion.

[26]  Matthias Rzepka,et al.  Thermal start-up behaviour and thermal management of SOFC's , 2006 .

[27]  Miriam Kemm,et al.  Steady state and transient thermal stress analysis in planar solid oxide fuel cells , 2005 .

[28]  E. Achenbach.  Response of a solid oxide fuel cell to load change , 1995 .

[29]  Xin-Jian Zhu,et al.  Predictive control of SOFC based on a GA-RBF neural network model , 2008 .

[30]  Xin-Jian Zhu,et al.  Short communication Modeling a SOFC stack based on GA-RBF neural networks identification , 2007 .

[31]  Kevin Tomsovic,et al.  Development of models for analyzing the load-following performance of microturbines and fuel cells , 2002 .

[32]  Hongliang Cao,et al.  Dynamic modeling and experimental validation for the electrical coupling in a 5-cell solid oxide fuel cell stack in the perspective of thermal coupling , 2011 .