Implementation of Sliding Mode Control in a Full Bridge (DC-DC) Converter

Converters are widely used in many fields specially Distributed Generation applications. Because of the non-linear and the uncertain characteristics of DC-DC converters, Sliding Mode Control (SMC), which is robust against uncertainties and disturbances, is implemented in a full-bridge converter in order to control the converter output by varying the duty cycle of the converter. The proposed method is explained and formulated using state-space average model of the fullbridge converter. Additionally, the effects of changing the design parameters of the introduced sliding mode controller in tracking performance and tracking are discussed. Moreover, the system behavior during load and source sudden changes is analyzed. High performance and tracking accuracy of the system under parameter variation are confirmed appropriately using simulations.

[1]  J. Nazarzadeh,et al.  Time-optimal sliding-mode control for multi-quadrant buck converters , 2011 .

[2]  Yuichiro Shibata,et al.  Fast response digital PID control circuit for DC-DC converter , 2010, TENCON 2010 - 2010 IEEE Region 10 Conference.

[3]  V. Fernão Pires,et al.  Advanced control methods for power electronics systems , 2003, Math. Comput. Simul..

[4]  Lixuan Lu,et al.  Modelling, simulation and control of a proton exchange membrane fuel cell (PEMFC) power system , 2010 .

[5]  Weiping Li,et al.  Applied Nonlinear Control , 1991 .

[6]  Kamel Guesmi,et al.  Shifting nonlinear phenomena in a DC-DC converter using a fuzzy logic controller , 2008, Mathematics and Computers in Simulation.

[7]  Seyed Ali Mohammad Javadian,et al.  A Fault Location Method in Distribution Networks Including DG , 2011 .

[8]  Luis Martinez-Salamero,et al.  Two-Loop Digital Sliding Mode Control of DC–DC Power Converters Based on Predictive Interpolation , 2011, IEEE Transactions on Industrial Electronics.

[9]  Seyed Hossein Hosseini,et al.  Multiinput Direct DC–AC Converter With High-Frequency Link for Clean Power-Generation Systems , 2011, IEEE Transactions on Power Electronics.

[10]  John Y. Hung,et al.  Comparative evaluation of sliding mode fuzzy controller and PID controller for a boost converter , 2011 .

[11]  Seyed Ali Mohammad Javadian,et al.  An Adaptive overcurrent Protection Scheme for Distribution Networks Including DG Using Distribution Automation System and its Implementation on a Real Distribution Network , 2011 .

[12]  Bin Liang,et al.  The Research of Adaptive Fuzzy PID Control Algorithm Based on LQR Approach in DC-DC Converter , 2008, 2008 IEEE Pacific-Asia Workshop on Computational Intelligence and Industrial Application.

[13]  Hasan Rastegar,et al.  Control of islanded industrial networks with fuel cell based distributed generation units and ultra‐capacitor storage device , 2011 .

[14]  Yuri B. Shtessel,et al.  Sliding mode control of boost and buck-boost power converters using method of stable system centre , 2003, Autom..

[15]  Ali Aref,et al.  Optimal Placement and Estimation of DG Capacity in Distribution Network's Using Genetic Algorithm-based Method , 2012 .

[16]  Seyed Ali Mohammad Javadian,et al.  Calculation of Maximum DG's Capacity According to their Location for Remaining the Protection Coordination in Distribution Networks , 2011 .

[17]  Francesc Guinjoan,et al.  Sliding-mode control design of a boost-buck switching converter for AC signal generation , 2004, IEEE Transactions on Circuits and Systems I: Regular Papers.

[18]  P. Olver Nonlinear Systems , 2013 .

[19]  Jon Andreu,et al.  New fault tolerant matrix converter , 2011 .

[20]  Hasan Rastegar,et al.  Load Sharing Control of Fuel Cell Based Generation Units in Stand-Alone Distribution Networks , 2011 .

[21]  V. Fernão Pires,et al.  Teaching nonlinear modeling, simulation, and control of electronic power converters using MATLAB/SIMULINK , 2002, IEEE Trans. Educ..

[22]  Yuichiro Shibata,et al.  A new fast digital PID control dc-dc converter , 2010, Proceedings of 14th International Power Electronics and Motion Control Conference EPE-PEMC 2010.

[23]  J. Mahdavi,et al.  Application of neural networks and State-space averaging to DC/DC PWM converters in sliding-mode operation , 2005, IEEE/ASME Transactions on Mechatronics.

[24]  John Y. Hung,et al.  Design of a fuzzy controller using variable structure approach for application to DC–DC converters , 2012 .

[25]  Eva Navarro Lopez,et al.  Reply to Comments on "Design of practical sliding-mode controllers with constant switching frequency for power converters" , 2009 .

[26]  A. Keyhani,et al.  Control of distributed generation systems - Part II: Load sharing control , 2004, IEEE Transactions on Power Electronics.

[27]  A. Prodic,et al.  Design of a digital PID regulator based on look-up tables for control of high-frequency DC-DC converters , 2002, 2002 IEEE Workshop on Computers in Power Electronics, 2002. Proceedings..

[28]  Zhang Chengning,et al.  Study on the method of fuzzy PID control for DC/DC converter , 2010, 2010 International Conference on Information, Networking and Automation (ICINA).

[29]  C.K. Tse,et al.  A fixed-frequency pulsewidth modulation based quasi-sliding-mode controller for buck converters , 2005, IEEE Transactions on Power Electronics.

[30]  Chok-You Chan,et al.  A Nonlinear Control for DC–DC Power Converters , 2007, IEEE Transactions on Power Electronics.

[31]  Ali Keyhani,et al.  DEVELOPMENT OF AVERAGE MODEL FOR CONTROL OF A FULL BRIDGE PWM DC-DC CONVERTER , 2007 .

[32]  Il-Yop Chung,et al.  Integration of a bi-directional DC–DC converter model into a real-time system simulation of a shipboard medium voltage DC system , 2011 .

[33]  Hiroaki Kakigano,et al.  Low-Voltage Bipolar-Type DC Microgrid for Super High Quality Distribution , 2010, IEEE Transactions on Power Electronics.

[34]  A. Keyhani,et al.  Control of distributed generation systems-Part I: Voltages and currents control , 2004, IEEE Transactions on Power Electronics.