Positioning the reference electrode in proton exchange membrane fuel cells: calculations of primary and secondary current distribution

The primary and secondary current distribution study indicates the geometry of a thin electrolyte in a proton exchange membrane (PEM) fuel cell has a direct relation to the measured electrode polarization, thus making the positioning of the reference electrode and ohmic compensation critical. The different kinetic overpotentials on the electrodes can also affect the potential distribution and therefore affect the measurement accuracy. The measurement error can be significant for the fuel cell system with different kinetic overpotentials and with electrode misalignment. The measurement error for both hydrogen and direct methanol fuel cells (DMFC) has been analyzed over the current density region with no mass transfer effects. By using two reference electrodes, the measurement error can be substantially decreased for both anode and cathode measurement in a direct methanol fuel cell, and for the cathode measurement in a hydrogen/air fuel cell.

[1]  John Newman,et al.  Ohmic Potential Measured by Interrupter Techniques , 1970 .

[2]  J. Newman.  Current Distribution on a Rotating Disk below the Limiting Current , 1966 .

[3]  W. Preidel,et al.  Status of the development of a direct methanol fuel cell , 1999 .

[4]  J. Winkler,et al.  Geometric Requirements of Solid Electrolyte Cells with a Reference Electrode , 1998 .

[5]  H. Iwahara,et al.  Dependence of observed overvoltages on the positioning of the reference electrode on the solid electrolyte , 1994 .

[6]  Edson A. Ticianelli,et al.  Localization of platinum in low catalyst loading electrodes to to attain high power densities in SPE fuel cells , 1988 .

[7]  S. Chan,et al.  Reliability and accuracy of measured overpotential in a three-electrode fuel cell system , 2001 .

[8]  R. Richards,et al.  Reference electrode placement and seals in electrochemical oxygen generators , 2000 .

[9]  R. Savinell,et al.  O 2 Reduction on an Ink‐Type Rotating Disk Electrode Using Pt Supported on High‐Area Carbons , 1998 .

[10]  J. Newman,et al.  The Error in Measurements of Electrode Kinetics Caused by Nonuniform Ohmic‐Potential Drop to a Disk Electrode , 1973 .

[11]  J. Newman,et al.  Corrections to Kinetic Measurements Taken on a Disk Electrode , 1989 .

[12]  Tohru Kato,et al.  Influence of cell configuration on measuring interfacial impedances between a solid electrolyte and an electrode , 2000 .

[13]  J. Newman,et al.  Interpretation of Kinetic Rate Data Taken in a Channel Flow Cell , 1989 .

[14]  S. Gojković,et al.  Methanol oxidation on an ink type electrode using Pt supported on high area carbons , 2001 .