An Improved Theoretical Critical Heat Flux Model for Low-Quality Flow

Based on the Helmholtz instability at the microlayer/vapor interface as a trigger condition for microlayer dryout, a previous study developed a mechanistic critical heat flux (CHF) model for subcooled flow boiling. An improved CHF model is implemented with more solid theoretical bases for subcooled and low-quality flow boiling under pressurized water reactor conditions. Comparisons between the predictions and experimental data show that the present model is more accurate than the well-known theoretical CHF model and empirical CHF correlations for water flowing through uniformly heated round tubes within the applicable ranges. The applicability of the present model to rod bundles is also under investigation. High satisfactory results are obtained from the comparisons of predicted to observed bundle critical power.

[1]  Y. Katto,et al.  An improved version of the generalized correlation of critical heat flux for the forced convective boiling in uniformly heated vertical tubes , 1984 .

[2]  R. Hino,et al.  Studies on heat transfer and flow characteristics in subcooled flow boiling. Part 2. Flow characteristics , 1985 .

[3]  S. Levy.  Forced convection subcooled boiling—prediction of vapor volumetric fraction , 1967 .

[4]  W. J. Green.  A flow boiling critical heat flux correlation for water and Freon-12 at low mass fluxes , 1982 .

[5]  A. Serizawa.  Theoretical prediction of maximum heat flux in power transients , 1983 .

[6]  C. Lee,et al.  A mechanistic critical heat flux model for subcooled flow boiling based on local bulk flow conditions , 1988 .

[7]  R. Mesler,et al.  A mechanism supported by extensive experimental evidence to explain high heat fluxes observed during nucleate boiling , 1976 .

[8]  Bau-Shei Pei,et al.  A Theoretical Critical Heat Flux Model for Rod Bundles Under Pressurized Water Reactor Conditions , 1989 .

[9]  J. Weisman,et al.  Prediction of critical heat flux in flow boiling at low qualities , 1983 .

[10]  D. G. Reddy,et al.  Parametric study of CHF data. Volume 2. A generalized subchannel CHF correlation for PWR and BWR fuel assemblies. Final report , 1983 .

[11]  A. E. Dukler,et al.  Frictional pressure drop in two-phase flow: B. An approach through similarity analysis , 1964 .

[12]  J. Saini,et al.  Heat transfer in nucleate pool boiling at high heat flux , 1983 .

[13]  Steven Beyerlein,et al.  Prediction of bubble concentration profiles in vertical turbulent two-phase flow , 1985 .

[14]  L. S. Tong,et al.  Prediction of departure from nucleate boiling for an axially non-uniform heat flux distribution , 1967 .