Single-mode operation of a coiled multimode fiber amplifier.

We report a new approach to obtaining single-transverse-mode operation of a multimode fiber amplifier in which the gain fiber is coiled to induce significant bend loss for all but the lowest-order mode. We demonstrated this method by constructing a coiled amplifier using Yb-doped, double-clad fiber with a core diameter of 25 microm and a numerical aperture of ~0.1 (V approximately 7.4) . When the amplifier was operated as an amplified-spontaneous-emission source, the output beam had an M(2) value of 1.09 +/- 0.09 ; when seeded at 1064 nm, the slope efficiency was similar to that of an uncoiled amplifier. This technique will permit scaling of pulsed fiber lasers and amplifiers to significantly higher pulse energies and peak powers and cw fiber sources to higher average powers while maintaining excellent beam quality.

[1]  A. Galvanauskas,et al.  Low-noise amplification of high-power pulses in multimode fibers , 1999, IEEE Photonics Technology Letters.

[2]  Christopher C. Davis,et al.  Lasers and Electro-Optics , 1996 .

[3]  D J Richardson,et al.  High-energy single-transverse-mode Q-switched fiber laser based on a multimode large-mode-area erbium-doped fiber. , 1998, Optics letters.

[4]  J. Nilsson,et al.  Compact high-energy Q-switched cladding-pumped fiber laser with a tuning range over 40 nm , 1999, IEEE Photonics Technology Letters.

[5]  U. Griebner,et al.  Laser operation with nearly diffraction-limited output from a Yb:YAG multimode channel waveguide. , 1999, Optics letters.

[6]  K. Williams,et al.  158-microJ pulses from a single-transverse-mode, large-mode-area erbium-doped fiber amplifier. , 1997, Optics letters.

[7]  R Grunwald,et al.  Efficient laser operation with nearly diffraction-limited output from a diode-pumped heavily Nd-doped multimode fiber. , 1996, Optics letters.

[8]  Govind P. Agrawal,et al.  Nonlinear Fiber Optics , 1989 .

[9]  L. Goldberg,et al.  Compact 1-W Yb-doped double-cladding fiber amplifier using V-groove side-pumping , 1998, IEEE Photonics Technology Letters.

[10]  B Jaskorzynska,et al.  Modeling and optimization of low-repetition-rate high-energy pulse amplification in cw-pumped erbium-doped fiber amplifiers. , 1993, Optics letters.

[11]  D. Hanna,et al.  Yb(3+)-ring-doped fiber for high-energy pulse amplification. , 1997, Optics letters.

[12]  O. G. Okhotnikov,et al.  Flared single-transverse-mode fibre amplifier , 1999 .

[13]  David J. Richardson,et al.  Q-switched erbium doped fibre laser utilising a novel large mode area fibre , 1997 .

[14]  A. Tünnermann,et al.  All-solid-state neodymium-based single-frequency master-oscillator fiber power-amplifier system emitting 5.5 W of radiation at 1064 nm. , 1999, Optics letters.

[15]  M M Fejer,et al.  Chirped-pulse-amplification circuits for fiber amplifiers, based on chirped-period quasi-phase-matching gratings. , 1998, Optics letters.

[16]  Michael W. Sasnett,et al.  Beam characterization and measurement of propagation attributes , 1991, Photonics West - Lasers and Applications in Science and Engineering.

[17]  Dietrich Marcuse,et al.  Field deformation and loss caused by curvature of optical fibers , 1976 .

[18]  Joao M.M. Sousa,et al.  MULTIMODE ER-DOPED FIBER FOR SINGLE-TRANSVERSE-MODE AMPLIFICATION , 1999 .

[19]  M. Fermann,et al.  Single-mode excitation of multimode fibers with ultrashort pulses. , 1998, Optics letters.

[20]  Dietrich Marcuse,et al.  Curvature loss formula for optical fibers , 1976 .