Microwave Measurements Part II Non-linear Measurements

This paper addresses the problems in microwave non-linear measurements. It discusses techniques to synthesize loads, the most used non-linear measurement techniques, and harmonic load-pulling. An experimental setup for characterizing power amplifiers must be able to measure the complex spectrum of the waves at the amplifier ports as a function of frequency, input power, and source and load termination at the fundamental and harmonic frequencies. The vector network analyzer (VNA) is the core instrument used in the non-linear characterization scenario. The basic idea is to keep the operations of VNA/mixers linear, diverting to them only a small portion of the signal present at the device under test (DUT) ports, therefore keeping unaltered the VNA capabilities already exhibited for small signal measurements.

[1]  R. Marks.  A multiline method of network analyzer calibration , 1991 .

[2]  Dylan F. Williams,et al.  A General Waveguide Circuit Theory , 1992, Journal of research of the National Institute of Standards and Technology.

[3]  A. Ferrero,et al.  Two-port network analyzer calibration using an unknown 'thru' , 1992, IEEE Microwave and Guided Wave Letters.

[4]  F. Raab,et al.  Power amplifiers and transmitters for RF and microwave , 2002 .

[5]  J. Brown,et al.  A computer-controlled microwave tuner for automated load pull , 1983 .

[6]  M. Pirola,et al.  Generalized mixed-mode S-parameters , 2006, IEEE Transactions on Microwave Theory and Techniques.

[7]  Franco Giannini,et al.  Load-Pull Techniques , 2005 .

[8]  K. Kurokawa,et al.  Power Waves and the Scattering Matrix , 1965 .

[9]  Umberto Pisani,et al.  Active load technique for load-pull characterisation at microwave frequencies , 1982 .

[10]  Andrea Pierenrico Ferrero,et al.  An improved calibration technique for on-wafer large-signal transistor characterization , 1993 .

[11]  Y. Takayama.  A New Load-Pull Characterization Method for Microwave Power Transistors , 1976 .

[12]  Andrea Pierenrico Ferrero,et al.  A new implementation of a multiport automatic network analyzer , 1992 .

[13]  Andrea Ferrero,et al.  Accuracy Evaluation of On-Wafer Load-Pull Measurements , 2000, 55th ARFTG Conference Digest.

[14]  Robert H. Caverly,et al.  HF, VHF, and UHF systems and technology , 2002 .

[15]  L. Dunleavy,et al.  Broadband Space Conservative On-Wafer Network Analyzer Calibrations With More Complex Load and Thru Models , 2006, IEEE Transactions on Microwave Theory and Techniques.

[16]  Valeria Teppati,et al.  Broad-band coaxial directional couplers for high-power applications , 2003 .

[17]  V. Camarchia,et al.  Microwave measurements Part I: Linear Measurements , 2007, IEEE Instrumentation & Measurement Magazine.