Near‐source seismic hazard and design scenarios

Earthquakes damage engineering structures near, relatively to the rupture’s size, to the source. In this region, the fault’s dynamics affect ground motion propagation differently from site to site, resulting in systematic spatial variability known as directivity. Although a number of researches recommend that records with directivity-related velocity pulses should be explicitly taken into account when defining design seismic action on structures, probabilistic seismic hazard analysis (PSHA), in its standard version, seems inadequate for the scope. In the study, it is critically reviewed why, from the structural engineering point of view, hazard assessment should account for near-source effects (i.e., pulse-like ground motions), and how this can be carried out adjusting PSHA analytically via introduction of specific terms and empirically calibrated models. Disaggregation analysis and design scenarios for near-source PSHA are also formulated. The analytical procedures are then applied to develop examples of hazard estimates for sites close to strike–slip or dip–slip faults and to address differences with respect to the ordinary case, that is, when pulse-like effects are not explicitly accounted for. Significant increase of hazard for selected spectral ordinates is found in all investigated cases; increments depend on the fault-site configuration. Moreover, to address design scenarios for seismic actions on structures, disaggregation results are also discussed, along with limitations of current design spectra to highlight the pulse-like effects of structural interest. Finally, an attempt to overcome these, by means of disaggregation-based scenarios specific for the pulse occurrence case, is presented. Copyright © 2012 John Wiley & Sons, Ltd.