Origins and evolution of stress development in sol-gel derived thin layers and multideposited coatings of lead titanate

Stress development in thin layers of lead titanate prepared by sol-gel processing was monitored by in situ laser reflectance measurements. Layers were spin coated onto silicon substrates and thermally cycled to 500 °C. The shrinkage normal to the rigid substrate was determined by in situ ellipsometry. Changes that occurred on drying and firing, which related to densification and stress development, are reported. The observed changes were explained in terms of evaporation and solvent/polymeric network interactions at lower temperatures, and thermal expansion mismatch between the substrate and the coating after formation of the dense oxide. Crystallization into the perovskite structure occurred only in thicker or multideposited coatings, altering the state of stress from tensile, to progressively more compressive, on cooling. The importance of the choice of substrate material, deposition method and heat treatment conditions, in relation to stress development and dependent electrical properties, are discussed.

[1]  J. S. Liu,et al.  The oriented growth of thin films deposited by a sol - gel process on substrates without lattice match , 1997 .

[2]  E. Yeatman,et al.  Effects of H2O on structure of acid-catalysed SiO2 sol-gel films , 1995 .

[3]  David R. Clarke,et al.  Stress Measurement in Single‐Crystal and Polycrystalline Ceramics Using Their Optical Fluorescence , 1993 .

[4]  S. Desu Stress induced modifications in ferroelectric films , 1994 .

[5]  C. E. Land Longitudinal Electrooptic Effects and Photosensitivities of Lead Zirconate Titanate Thin Films , 1989 .

[6]  M. J. E. Ulenaers,et al.  STRESSES IN PT/PB(ZR,TI)O3/PT THIN-FILM STACKS FOR INTEGRATED FERROELECTRIC CAPACITORS , 1995 .

[7]  S. Desu,et al.  Processing of PbTiO3 thin films. I. in situ investigation of formation kinetics , 1996 .

[8]  K. Budd,et al.  Thin-film ferroelectrics of PZT of sol-gel processing , 1988, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[9]  G. Exarhos,et al.  Spectroscopic measurements of stress relaxation during thermally induced crystallization of amorphous titania films , 1992 .

[10]  D. C. Agrawal,et al.  Interfacial mechanisms controlling phase formation in sol-gel derived lead zirconate titanate thin films , 1994 .

[11]  Koichi Kuroiwa,et al.  Interaction of PbTiO3 Films with Si Substrate , 1994 .

[12]  T. Parrill Heat treatment of spun-on acid-catalyzed sol-gel silica films , 1994 .

[13]  D. C. Agrawal,et al.  Raman spectroscopy and x‐ray diffraction of PbTiO3 thin film , 1995 .

[14]  J.H.L. Voncken,et al.  New method for the measurement of stress in thin drying gel layers, produced during the formation of ceramic membranes , 1992 .

[15]  K. Etzold,et al.  Substrate and temperature effects in lead zirconate titanate films produced by facing targets sputtering , 1992 .

[16]  C. Brinker,et al.  Sol → gel → glass: II. Physical and structural evolution during constant heating rate experiments , 1985 .

[17]  G. Stoney The Tension of Metallic Films Deposited by Electrolysis , 1909 .

[18]  C. Brinker,et al.  Sol-Gel Science: The Physics and Chemistry of Sol-Gel Processing , 1990 .

[19]  Jiefang Li,et al.  Field‐induced phase switching and electrically driven strains in sol‐gel derived antiferroelectric (Pb,Nb)(Zr,Sn,Ti)O3 thin layers , 1995 .

[20]  M. Ohring The Materials Science of Thin Films , 1991 .

[21]  Terry J. Garino,et al.  Residual Stress in Pzt Thin Films and its Effect on Ferroelectric Properties , 1991 .

[22]  D. Payne,et al.  Integrated electroceramics: densification and stress development in sol-gel derived thin layers , 1997 .