Sensing Technologies for Grain Crop Yield Monitoring Systems: A Review

Purpose: Yield monitoring systems are an essential component of precision agriculture. They indicate the spatial variability of crop yield in fields, and have become an important factor in modern harvesters. The objective of this paper was to review research trends related to yield monitoring sensors for grain crops. Methods: The literature was reviewed for research on the major sensing components of grain yield monitoring systems. These major components included grain flow sensors, moisture content sensors, and cutting width sensors. Sensors were classified by sensing principle and type, and their performance was also reviewed. Results: The main targeted harvesting grain crops were rice, wheat, corn, barley, and grain sorghum. Grain flow sensors were classified into mass flow and volume flow methods. Mass flow sensors were mounted primarily at the clean grain elevator head or under the grain tank, and volume flow sensors were mounted at the head or in the middle of the elevator. Mass flow methods used weighing, force impact, and radiometric approaches, some of which resulted in measurement error levels lower than 5% (R 2 = 0.99). Volume flow methods included paddle wheel type and optical type, and in the best cases produced error levels lower than 3%. Grain moisture content sensing was in many cases achieved using capacitive modules. In some cases, errors were lower than 1%. Cutting width was measured by ultrasonic distance sensors mounted at both sides of the header dividers, and the errors were in some cases lower than 5%. Conclusions: The design and fabrication of an integrated yield monitoring system for a target crop would be affected by the selection of a sensing approach, as well as the layout and mounting of the sensors. For accurate estimation of yield, signal processing and correction measures should be also implemented.

[1]  K. Toriyama.  Estimation of fertilizer nitrogen requirement for average rice yield in Japanese paddy fields , 2002 .

[2]  B. S. Blackmore,et al.  Yield Mapping; Errors and Algorithms , 2015 .

[3]  Kenneth A. Sudduth,et al.  Comparison of sensors and techniques for crop yield mapping , 1996 .

[4]  Stephen W. Searcy,et al.  Mapping of Spatially Variable Yield During Grain Combining , 1989 .

[5]  Randal K. Taylor,et al.  A DIAPHRAGM IMPACT SENSOR FOR MEASURING COMBINE GRAIN FLOW , 1999 .

[6]  M. Demmel.  Site-Specific Recording of Yields , 2013 .

[7]  K. Sudduth,et al.  Sensing corn population – another variable in the yield equation , 2001 .

[8]  J. De Baerdemaeker,et al.  Performance Evaluation of a Three-dimensional Optical Volume Flow Meter , 1996 .

[9]  H. D. Kutzbach,et al.  Investigations on a particular yield mapping system for combine harvesters , 1996 .

[10]  Timothy S. Stombaugh,et al.  Laboratory Performance of a Mass Flow Sensor for Dry Edible Bean Harvesters , 2009 .

[11]  Joseph N. Gray,et al.  Grain flow measurements with X-ray techniques. , 2000 .

[12]  Thomas S. Colvin,et al.  Laboratory test stand for combine grain yield monitors , 1998 .

[13]  Stuart O. Nelson,et al.  Microwave Sensing of Moisture Content and Bulk Density in Flowing Grain and Seed , 2016 .

[14]  Shufeng Han,et al.  A bitmap method for determining effective combine cut width in yield mapping. , 1997 .

[15]  Yaoming Li,et al.  Original papers: Grain separation loss monitoring system in combine harvester , 2011 .

[16]  P. C. Robert,et al.  Field evaluation of a corn population sensor. , 2000 .

[17]  J. V. Stafford,et al.  Cut width sensors to improve the accuracy of yield mapping systems , 1997 .

[18]  D. Pessina,et al.  Measurement of Cereal Moisture Content with an Experimental Acoustic Device , 2012 .

[19]  Dan S. Long,et al.  On-combine, multi-sensor data collection for post-harvest assessment of environmental stress in wheat , 2015, Precision Agriculture.

[20]  I. Farkas,et al.  On-Line Microwave Measurement of the Moisture Content of Wheat , 2008 .

[21]  Michael Heisig,et al.  Estimation of yield zones using aerial images and yield data from a few tracks of a combine harvester , 2008, Precision Agriculture.

[22]  P. C. Robert,et al.  A review of yield reconstruction and sources of errors in yield maps. , 2000 .

[23]  K. C. Lawrence,et al.  PARALLEL-PLATE MOISTURE SENSOR FOR YELLOW-DENT FIELD CORN , 1998 .

[24]  P. C. Robert,et al.  Yield Mapping — A Guide to Improved Techniques and Strategies , 1995 .

[25]  Chengliang Liu,et al.  Elimination of vibration noise from an impact-type grain mass flow sensor , 2014, Precision Agriculture.

[26]  Brian L. Steward,et al.  Automatic corn plant population measurement using machine vision , 2001 .

[27]  Pedro Amorim Berbert,et al.  On-line moisture content measurement of wheat , 1996 .

[28]  B. Missotten.  Measurement systems for the mapping and the evaluation of crop production performance , 1998 .

[29]  Kenneth A. Sudduth.  Engineering for Precision Agriculture - Past Accomplishments and Future Directions , 1998 .

[31]  John P. Fulton,et al.  Grain yield monitor flow sensor accuracy for simulated varying field slopes. , 2009 .

[32]  New technique for remote estimation of vegetation fraction: principles, algorithms and validation. , 2000 .

[33]  Singh,et al.  Precision in grain yield monitoring technologies: A review (Review) , 2012 .

[34]  P. Reyns,et al.  On-line measurement of grain quality with NIR technology , 2004 .

[35]  Thomas S. Colvin,et al.  Continuous grain yield monitoring , 1996 .

[36]  P. Reyns,et al.  A Review of Combine Sensors for Precision Farming , 2002, Precision Agriculture.

[37]  Ancha Srinivasan.  Precision Farming in Asia: Progress and Prospects , 1999 .