Universal Induction Motor Model With Low-to-High Frequency-Response Characteristics

A three-phase induction motor model that depicts the motor behavior over a wide range of frequencies from 10 Hz to 10 MHz is presented in this paper. The model is universal in the sense that common-mode, differential-mode, and bearing circuit models are combined into one three-phase equivalent circuit model. The proposed model is basically an extension of the low-frequency IEEE Standard 112 circuit model. The proposed model was experimentally simulated and verified with results presented.

[1]  Gary L. Skibinski,et al.  Resonant tank motor model for voltage reflection simulations with PWM drives , 1999, IEEE International Electric Machines and Drives Conference. IEMDC'99. Proceedings (Cat. No.99EX272).

[2]  Aldo Boglietti,et al.  Induction motor high frequency model , 1999, Conference Record of the 1999 IEEE Industry Applications Conference. Thirty-Forth IAS Annual Meeting (Cat. No.99CH36370).

[3]  T.A. Lipo,et al.  High frequency modeling for cable and induction motor overvoltage studies in long cable drives , 2001, Conference Record of the 2001 IEEE Industry Applications Conference. 36th IAS Annual Meeting (Cat. No.01CH37248).

[4]  S. Bell,et al.  Will your motor insulation survive a new adjustable frequency drive? , 1996, Proceedings of 1996 IAS Petroleum and Chemical Industry Technical Conference.

[5]  Ieee Standards Board.  IEEE standard test procedure for polyphase induction motors and generators , 1992 .

[6]  J. Erdman,et al.  Assessing AC motor dielectric withstand capability to reflected voltage stress using corona testing , 1996, IAS '96. Conference Record of the 1996 IEEE Industry Applications Conference Thirty-First IAS Annual Meeting.

[7]  P. J. Link,et al.  Minimizing electric bearing currents in ASD systems , 1999 .

[8]  Alfio Consoli,et al.  Induction motor modeling for common mode and differential mode emission evaluation , 1996, IAS '96. Conference Record of the 1996 IEEE Industry Applications Conference Thirty-First IAS Annual Meeting.

[9]  M. Schinkel,et al.  Efficient HF modeling and model parameterization of induction machines for time and frequency domain simulations , 2006, Twenty-First Annual IEEE Applied Power Electronics Conference and Exposition, 2006. APEC '06..

[10]  T.A. Lipo,et al.  Transient modeling and analysis of motor terminal voltage on PWM inverter-fed AC motor drives , 1998, Conference Record of 1998 IEEE Industry Applications Conference. Thirty-Third IAS Annual Meeting (Cat. No.98CH36242).

[11]  Doyle F. Busse,et al.  System electrical parameters and their effects on bearing currents , 1996, Proceedings of Applied Power Electronics Conference. APEC '96.

[12]  Hamid A. Toliyat,et al.  Predicting the transient effects of PWM voltage waveform on the stator windings of random wound induction motors , 1999 .

[13]  Kenichi Iimori,et al.  A Common Mode Equivalent Circuit Usable for Calculating Common Mode Current and Bearing Current of Induction Motor Driven by PWM Inverter , 2005 .

[14]  Russel J. Kerkman,et al.  EMI emissions of modern PWM AC drives , 1999 .

[15]  Gary L. Skibinski,et al.  Effect of surge voltage risetime on the insulation of low voltage machines fed by PWM converters , 1997, IAS '97. Conference Record of the 1997 IEEE Industry Applications Conference Thirty-Second IAS Annual Meeting.

[16]  E. Persson,et al.  Transient effects in application of PWM inverters to induction motors , 1991, Conference Record of 1991 Annual Pulp and Paper Industry Technical Conference.

[17]  Thomas A. Lipo,et al.  NEUTRAL-TO-GROUND VOLTAGE MINIMIZATION IN A PWM-RECTIFIER / INVERTER CONFIGURATION , 1998 .

[18]  David Leggate,et al.  Interaction of drive modulation and cable parameters on AC motor transients , 1996, IAS '96. Conference Record of the 1996 IEEE Industry Applications Conference Thirty-First IAS Annual Meeting.

[19]  A. von Jouanne,et al.  The effect of long motor leads on PWM inverter fed AC motor drive systems , 1995, Proceedings of 1995 IEEE Applied Power Electronics Conference and Exposition - APEC'95.

[20]  R. Schiferl,et al.  Circuit model for shaft voltage prediction in induction motors fed by PWM-based AC drives , 2003 .

[21]  Thomas A. Lipo,et al.  Modeling of motor bearing currents in PWM inverter drives , 1995 .

[22]  D. K. Sharma,et al.  Measurement and Analysis of Surge Distribution in Motor Stator Windings , 1989, IEEE Power Engineering Review.

[23]  D. Schlegel,et al.  Reflected wave modeling techniques for PWM AC motor drives , 1998, APEC '98 Thirteenth Annual Applied Power Electronics Conference and Exposition.

[24]  Hermann W. Dommel,et al.  Digital Computer Solution of Electromagnetic Transients in Single-and Multiphase Networks , 1969 .

[25]  G. Skibinski,et al.  Common Mode and Differential Mode Analysis of Three Phase Cables for PWM AC Drives , 2006, Conference Record of the 2006 IEEE Industry Applications Conference Forty-First IAS Annual Meeting.

[26]  Gary L. Skibinski,et al.  Design methodology of a cable terminator to reduce reflected voltage on AC motors , 1996, IAS '96. Conference Record of the 1996 IEEE Industry Applications Conference Thirty-First IAS Annual Meeting.

[27]  M. Schinkel,et al.  Troubleshooting and fixing of inverter driven induction motor bearing currents in existing plants of large size - an evaluation of possible mitigation techniques in practical applications , 2006, Twenty-First Annual IEEE Applied Power Electronics Conference and Exposition, 2006. APEC '06..

[28]  Doyle F. Busse,et al.  Characteristics of shaft voltage and bearing currents , 1997 .

[29]  A. Binder,et al.  Calculation of motor capacitances for prediction of discharge bearing currents in machines of inverter-based drive systems , 2005, IEEE International Conference on Electric Machines and Drives, 2005..

[30]  Donald W. Novotny,et al.  The influence of winding capacitance on high frequency time harmonic losses in induction motors , 1992, Conference Record of the 1992 IEEE Industry Applications Society Annual Meeting.

[31]  A. Boglietti, E. Carpaneto.  An Accurate Induction Motor High-Frequency Model for Electromagnetic Compatibility Analysis , 2001 .

[32]  David B. Hyypio,et al.  Simulation of cable and winding response to steep-fronted voltage waves , 1995, IAS '95. Conference Record of the 1995 IEEE Industry Applications Conference Thirtieth IAS Annual Meeting.