Investigation of Two-Phase Flow in a Hydrophobic Fuel-Cell Micro-Channel

This paper presents a quantitative visualization study and a theoretical analysis of two-phase flow relevant to polymer electrolyte membrane fuel cells (PEMFCs) in which liquid water management is critical to performance. Experiments were conducted in an air-flow microchannel with a hydrophobic surface and a side pore through which water was injected to mimic the cathode of a PEMFC. Four distinct flow patterns were identified: liquid bridge (plug), slug/plug, film flow, and water droplet flow under small Weber number conditions. Liquid bridges first evolve with quasi-static properties while remaining pinned; after reaching a critical volume, bridges depart from axisymmetry, block the flow channel, and exhibit lateral oscillations. A model that accounts for capillarity at low Bond number is proposed and shown to successfully predict the morphology, critical liquid volume and evolution of the liquid bridge, including deformation and complete blockage under specific conditions. The generality of the model is also illustrated for flow conditions encountered in the manipulation of polymeric materials and formation of liquid bridges between patterned surfaces. The experiments provide a database for validation of theoretical and computational methods.

[1]  C. Hebling,et al.  Visualization of water buildup in the cathode of a transparent PEM fuel cell , 2003 .

[2]  Wei Liu,et al.  Numerical Simulation of Water Transport in a Proton Exchange Membrane Flow Cell Flow Channel , 2018, Energies.

[3]  Huiying Wu,et al.  Start-up, heat transfer and flow characteristics of silicon-based micro pulsating heat pipes , 2012 .

[4]  Ziping Feng,et al.  Two-phase flow in microchannels , 2002 .

[5]  Peter Beike,et al.  Intermolecular And Surface Forces , 2016 .

[6]  M. Matthay,et al.  Chest Medicine: Essentials of Pulmonary and Critical Care Medicine , 2011 .

[7]  L. E. Scriven,et al.  Pendular rings between solids: meniscus properties and capillary force , 1975, Journal of Fluid Mechanics.

[8]  Zhaoli Guo,et al.  Multiple-relaxation-time lattice Boltzmann model for binary mixtures of nonideal fluids based on the Enskog kinetic theory , 2015 .

[9]  Kenneth E. Goodson,et al.  Impact of channel geometry on two-phase flow in fuel cell microchannels , 2011 .

[10]  Yanzhou Qin,et al.  Water Transport and Removal in PEMFC Gas Flow Channel with Various Water Droplet Locations and Channel Surface Wettability , 2018 .

[11]  John F. Canny,et al.  A Computational Approach to Edge Detection , 1986, IEEE Transactions on Pattern Analysis and Machine Intelligence.

[12]  Katsuei Kenmotsu,et al.  Surfaces of revolution with prescribed mean curvature , 1980 .

[13]  Huiying Wu,et al.  An experimental study of convective heat transfer in silicon microchannels with different surface conditions , 2003 .

[14]  N. Djilali,et al.  Woven gas diffusion layers for polymer electrolyte membrane fuel cells: Liquid water transport and conductivity trade-offs , 2018, Journal of Power Sources.

[15]  O. Kabov,et al.  Regimes of two-phase flow in micro- and minichannels (review) , 2015 .

[16]  Edmund Koch,et al.  Fundamental medical and engineering investigations on protective artificial respiration : a collection of papers from the DFG funded research program PAR , 2011 .

[17]  M. Wörner.  Numerical modeling of multiphase flows in microfluidics and micro process engineering: a review of methods and applications , 2012 .

[18]  E. J. Vega,et al.  Numerical simulation of a liquid bridge in a coaxial gas flow , 2011 .

[19]  R. Fisher.  Further note on the capillary forces in an ideal soil , 1928, The Journal of Agricultural Science.

[20]  Alex Jarauta,et al.  Challenges in Computational Modeling of Two-Phase Transport in Polymer Electrolyte Fuel Cells Flow Channels: A Review , 2018 .

[21]  D. Wilkinson,et al.  A critical review of two-phase flow in gas flow channels of proton exchange membrane fuel cells , 2010 .

[22]  Hong Wang,et al.  Numerical investigation of the moving liquid column coalescing with a droplet in triangular microchannels using CLSVOF method , 2015 .

[23]  Mechanical imperfections effect on the minimum volume stability limit of liquid bridges , 2010 .

[24]  P. Sui,et al.  Numerical analysis of ice-induced stresses in the membrane electrode assembly of a PEM fuel cell under sub-freezing operating conditions , 2018 .

[25]  A. Serizawa.  Two-Phase Flow in Micro-Channels , 2002 .

[26]  Vilayanur V. Viswanathan,et al.  Magnetic resonance imaging (MRI) of PEM dehydration and gas manifold flooding during continuous fuel cell operation , 2006 .

[27]  I. Kevrekidis,et al.  Water slug to drop and film transitions in gas-flow channels. , 2013, Langmuir : the ACS journal of surfaces and colloids.

[28]  D. Dyson,et al.  Stability of fluid interfaces of revolution between equal solid circular plates , 1971 .

[29]  Ned Djilali,et al.  Computational modelling of polymer electrolyte membrane (PEM) fuel cells: Challenges and opportunities , 2007 .

[30]  P. Sui,et al.  Numerical simulation of emergence of a water droplet from a pore into a microchannel gas stream , 2008 .

[31]  K. Breuer,et al.  The motion, stability and breakup of a stretching liquid bridge with a receding contact line , 2010, Journal of Fluid Mechanics.

[32]  S. Kandlikar,et al.  Visualization of Fuel Cell Water Transport and Performance Characterization under Freezing Conditions , 2010 .

[33]  José Manuel Perales Perales,et al.  Stability of liquid bridges between equal disks in an axial gravity field , 1993 .

[35]  K. Nagayama,et al.  Chapter 11 - Capillary Bridges and Capillary-Bridge Forces , 2001 .

[36]  Roland Zengerle,et al.  Passive water removal in fuel cells by capillary droplet actuation , 2008 .

[37]  J. Zasadzinski,et al.  Finite element calculations of fluid menisci and thin-films in a model porous media , 1987 .

[38]  J. C. Melrose.  Model calculations for capillary condensation , 1966 .

[39]  Michael M. Daino,et al.  Water management studies in PEM fuel cells, part III: Dynamic breakthrough and intermittent drainage characteristics from GDLs with and without MPLs , 2010 .

[40]  P. Sui,et al.  Three-dimensional numerical simulations of water droplet dynamics in a PEMFC gas channel , 2008 .

[41]  Chang-Soo Kim,et al.  X-ray imaging of water distribution in a polymer electrolyte fuel cell , 2008 .

[42]  Ying Zheng.  Liquid Plug Dynamics in Pulmonary Airways. , 2008 .

[43]  J. Nouri,et al.  Dynamics of water droplets detached from porous surfaces of relevance to PEM fuel cells. , 2006, Journal of colloid and interface science.

[44]  L. Rayleigh.  On The Instability Of Jets , 1878 .

[45]  A. Nepomnyashchy,et al.  Thermocapillary flow regimes and instability caused by a gas stream along the interface , 2013, Journal of Fluid Mechanics.

[46]  Kirk W Feindel,et al.  In situ observations of water production and distribution in an operating H2/O2 PEM fuel cell assembly using 1H NMR microscopy. , 2004, Journal of the American Chemical Society.

[47]  L. Witkowski,et al.  Solutocapillary instabilities in liquid bridges , 2002 .

[48]  Aimy Bazylak,et al.  Liquid water visualization in PEM fuel cells: A review , 2009 .

[49]  B. Hatton,et al.  Novel electrospun gas diffusion layers for polymer electrolyte membrane fuel cells: Part II. In operando synchrotron imaging for microscale liquid water transport characterization , 2017 .

[50]  Ned Djilali,et al.  Numerical investigation of water droplet dynamics in a low-temperature fuel cell microchannel: Effect of channel geometry , 2010 .

[51]  F. Mugele,et al.  Droplets Formation and Merging in Two-Phase Flow Microfluidics , 2011, International journal of molecular sciences.

[52]  K. Kenmotsu.  Surfaces of revolution with periodic mean curvature , 2003 .

[53]  K. Jiao,et al.  Direct numerical simulation of low Reynolds number turbulent air-water transport in fuel cell flow channel. , 2017, Science bulletin.

[54]  Qiang Ye,et al.  In situ visualization study of CO2 gas bubble behavior in DMFC anode flow fields , 2005 .

[55]  S. D. Poisson,et al.  Nouvelle théorie de l'action capillaire. , 1831 .

[56]  Haiping Fang,et al.  Modeling the rupture of a capillary liquid bridge between a sphere and plane , 2010 .

[57]  N. Djilali,et al.  Experimental investigation of water droplet emergence in a model polymer electrolyte membrane fuel cell microchannel , 2012 .

[58]  Flow Regime Evolution in Long, Serpentine Microchannels With a Porous Carbon Paper Wall , 2008 .

[59]  Chris R. Kleijn,et al.  Benchmark numerical simulations of segmented two-phase flows in microchannels using the Volume of Fluid method , 2013 .

[60]  P. Sui,et al.  Dynamic behaviour of liquid water emerging from a GDL pore into a PEMFC gas flow channel , 2007 .

[61]  H. Wiklund.  Lattice Boltzmann simulations of two-phased flow in fibre network systems , 2012 .

[62]  Joelle Frechette,et al.  From concave to convex: capillary bridges in slit pore geometry. , 2012, Langmuir : the ACS journal of surfaces and colloids.

[63]  P. Kralchevsky,et al.  Capillary forces and structuring in layers of colloid particles , 2001 .

[64]  Stanislav N. Gorb,et al.  The design of the fly adhesive pad: distal tenent setae are adapted to the delivery of an adhesive secretion , 1998, Proceedings of the Royal Society of London. Series B: Biological Sciences.

[65]  J. Thome,et al.  Macro-to-microchannel transition in two-phase flow: Part 1 – Two-phase flow patterns and film thickness measurements , 2011 .

[66]  J. Meseguer,et al.  On the breaking of long, axisymmetric liquid bridges between unequal supporting disks at minimum volume stability limit , 2003 .

[67]  P. Ferraro,et al.  3D lithography by rapid curing of the liquid instabilities at nanoscale , 2011, Proceedings of the National Academy of Sciences.

[68]  N. Djilali,et al.  Flow within a water droplet subjected to an air stream in a hydrophobic microchannel , 2009 .

[69]  Srinivas Garimella,et al.  Characterization of two-phase flow patterns in small diameter round and rectangular tubes , 1999 .

[70]  Ken S. Chen,et al.  Droplet dynamics in a polymer electrolyte fuel cell gas flow channel: Forces, deformation, and detachment. I: Theoretical and numerical analyses , 2012 .

[71]  A. Bar-Cohen,et al.  Two-Phase Liquid Cooling for Thermal Management of IGBT Power Electronic Module , 2013 .

[72]  R. A. Fisher.  On the capillary forces in an ideal soil; correction of formulae given by W. B. Haines , 1926, The Journal of Agricultural Science.

[73]  Arantza Basauri,et al.  Predictive model for the design of reactive micro-separations , 2019, Separation and Purification Technology.