PBM and activated sludge flocculation: From experimental data to calibrated model

A new comprehensive calibration methodology for a population balance model (PBM) is presented using experimental size distribution data obtained on-line during flocculation tests. It was found that the moving-pivot discretization technique should be used to accurately solve the PBM. A new methodology for grid transformation and volume to number transformation, based on the sludge concentration and the densities of liquid, solids, and flocs, is presented. Model fits were performed on four different fitting variables. Volume-based fitting (vol % and D[4, 3]) tends to fit the middle part of both the vol % and number distribution better than the tails of smaller and larger particle sizes. Severe underpredictions (up to a factor of 30) of the lower-size classes are observed at steady state. Number-based fitting [(weighted) number distribution] tends to fit the small-size classes better, but still underpredicts them by a factor of 2 at steady state. © 2005 American Institute of Chemical Engineers AIChE J, 2005

[1]  D. Ramkrishna,et al.  On the solution of population balance equations by discretization—II. A moving pivot technique , 1996 .

[2]  Denny S. Parker,et al.  Influence of activated sludge flocculation time on secondary clarification , 1994 .

[3]  P. J. Blatz,et al.  Note on the Kinetics of Systems Manifesting Simultaneous Polymerization-Depolymerization Phenomena , 1945 .

[4]  S. Katz,et al.  Some problems in particle technology: A statistical mechanical formulation , 1964 .

[5]  John A. Nelder,et al.  A Simplex Method for Function Minimization , 1965, Comput. J..

[6]  Vanni,et al.  Approximate Population Balance Equations for Aggregation-Breakage Processes. , 2000, Journal of colloid and interface science.

[7]  G. Hidy,et al.  The dynamics of aerocolloidal systems , 1970 .

[8]  Patrick T. Spicer,et al.  Coagulation and fragmentation: Universal steady‐state particle‐size distribution , 1996 .

[9]  D Dirk Thoenes,et al.  Aggregation kinetics of small particles in agitated vessels , 1997 .

[10]  John A. McCorquodale,et al.  Modeling of Rectangular Settling Tanks , 1992 .

[11]  Simon Judd,et al.  Flocculation modelling : A review , 1999 .

[12]  Doraiswami Ramkrishna,et al.  Population Balances: Theory and Applications to Particulate Systems in Engineering , 2000 .

[13]  Serra,et al.  Aggregation and Breakup of Particles in a Shear Flow , 1997, Journal of colloid and interface science.

[14]  M. Hounslow,et al.  A discretized population balance for nucleation, growth, and aggregation , 1988 .

[15]  Doraiswami Ramkrishna,et al.  Precipitation in small systems-I. stochastic analysis , 1994 .

[16]  P A Vanrolleghem,et al.  Modelling the activated sludge flocculation process combining laser light diffraction particle sizing and population balance modelling (PBM). , 2002, Water science and technology : a journal of the International Association on Water Pollution Research.

[17]  J Haarhoff,et al.  Modelling of floc-bubble aggregate rise rates in dissolved air flotation. , 2001, Water science and technology : a journal of the International Association on Water Pollution Research.

[18]  E. Schroeder,et al.  Density of activated sludge solids , 1991 .

[19]  Paul Lant,et al.  Activated sludge flocculation: on-line determination of floc size and the effect of shear , 2000 .

[20]  B. Wilén.  Properties of Activated Sludge Flocs , 1999 .

[21]  S. Iveson,et al.  Limitations of one-dimensional population balance models of wet granulation processes☆ , 2002 .

[22]  Prodromos Daoutidis,et al.  Numerical solution of a mass structured cell population balance model in an environment of changing substrate concentration , 1999 .

[23]  W. Verstraete,et al.  Linking floc structure and settling properties to activated sludge population dynamics in an SBR. , 2003, Water science and technology : a journal of the International Association on Water Pollution Research.

[24]  S. Saito,et al.  Scale effect on breakup process in liquid-liquid agitated tanks. , 1983 .

[25]  M. Hounslow,et al.  Adjustable discretized population balance for growth and aggregation , 1995 .

[26]  J. Ducoste.  A two-scale PBM for modeling turbulent flocculation in water treatment processes , 2002 .

[27]  Ingmar Nopens,et al.  Comparison of discretization methods to solve a population balance model of activated sludge flocculation including aggregation and breakage , 2003 .

[28]  T. Waite,et al.  Rapid Structure Characterization of Bacterial Aggregates , 1998 .

[29]  Clark,et al.  Incorporation of Aggregate Breakup in the Simulation of Orthokinetic Coagulation. , 1999, Journal of colloid and interface science.

[30]  A. Agresti,et al.  Categorical Data Analysis , 1991, International Encyclopedia of Statistical Science.

[31]  P. Adler.  Heterocoagulation in shear flow , 1981 .

[32]  Kristian Keiding,et al.  Effects of Colloidal Stability on Clarification and Dewatering of Activated Sludge , 1996 .

[33]  Wolfgang Rodi,et al.  Numerical modeling of flow and settling in primary rectangular clarifiers , 1989 .

[34]  Thomas D. Waite,et al.  Measurement and implications of floc structure in water and wastewater treatment , 1999 .

[35]  W. Gujer,et al.  Activated sludge model No. 3 , 1995 .