ROLE OF DUAL INPUT FUZZY CONTROLLER FOR THE BETTER PRODUCTION OF REAL POWER IN WIND SYSTEM

As non-renewable resources such as coal and tar are not only on the verge of depletion but also environmentally damaging, the world is looking towards alternative sources of energy that are environmentally and economically sustainable. Wind energy production has been growing at a rapid rate and has a promising outlook. It has come to play a vital part in supplying future energy needs. The work reported in this paper is about implementing the power maximization control technique towards the rectifier side. In order to attain this, grid-connected PMSG based WECS is scrutinized with one input fuzzy logic controller and modified fuzzy logic controller. The main focus of the research is to boost the power produced by the fuzzy one input controller applied towards the side of rectifier in tracking the uttermost power, where the uttermost power produced at several speeds of the wind is relatively low. A novel modified fuzzy logic controller towards the side of rectifier is implemented to bring out the uttermost power produced at several speeds of wind turbine. The analysis carried out in this work will help in the surge of power production routine of the PMSG using modified fuzzy logic controller compared to fuzzy one input MPPT controller. The simulation results are obtained by MATLAB software.

[1]  Il-Yop Chung,et al.  A Grid Voltage Measurement Method for Wind Power Systems during Grid Fault Conditions , 2014 .

[2]  Chandan Kumar Chanda,et al.  Optimal mix of solar and wind distributed generations considering performance improvement of electrical distribution network , 2015 .

[3]  Mohammed Ouassaid,et al.  Optimal Power Control Strategy of Maximizing Wind Energy Tracking and Different Operating Conditions for Permanent Magnet Synchronous Generator Wind Farm , 2015 .

[4]  T Senjyu,et al.  A Coordinated Control Method to Smooth Wind Power Fluctuations of a PMSG-Based WECS , 2011, IEEE Transactions on Energy Conversion.

[5]  Bin Wu,et al.  A Medium-Frequency Transformer-Based Wind Energy Conversion System Used for Current-Source Converter-Based Offshore Wind Farm , 2017, IEEE Transactions on Power Electronics.

[6]  Djamila Rekioua,et al.  Robust nonlinear predictive control of permanent magnet synchronous generator turbine using Dspace hardware , 2016 .

[7]  P. Sebastian Vindro Jude,et al.  High Efficiency Control for a Wind Energy Conversion System with Induction Generator , 2014 .

[8]  Ralph Kennel,et al.  Advanced control strategies for direct-drive PMSG wind turbine systems: Direct predictive torque control approaches , 2017 .

[9]  Nilanjan Senroy,et al.  DG planning with amalgamation of economic and reliability considerations , 2015 .

[10]  Ashwani Kumar,et al.  Economic-emission load dispatch in renewable integrated system under availability based tariff (ABT) environment , 2013 .

[11]  Rachid Beguenane,et al.  Sliding mode speed control for wind energy conversion systems , 2015, 2015 IEEE 28th Canadian Conference on Electrical and Computer Engineering (CCECE).

[12]  P. Renuga,et al.  Fuzzy based MPPT controller's role in extraction of maximum power in wind energy conversion system , 2016, 2016 International Conference on Control, Instrumentation, Communication and Computational Technologies (ICCICCT).

[13]  J. Baskaran,et al.  Hybrid optimization implemented for distributed generation parameters in a power system network , 2016 .

[14]  Pierluigi Siano,et al.  Assessing Wind Turbines Placement in a Distribution Market Environment by Using Particle Swarm Optimization , 2013, IEEE Transactions on Power Systems.

[15]  K. Bradley,et al.  Reliability comparison of matrix and other converter topologies , 2006, IEEE Transactions on Aerospace and Electronic Systems.