Preliminary Results of a Study of the Relationship Between Free Stream Turbulence and Stagnation Region Heat Transfer

A study is being conducted at the NASA Lewis Research Center to investigate the mechanism that causes free stream turbulence to increase heat transfer in the stagnation region of turbine vanes and blades. The work is being conducted in a wind tunnel at atmospheric conditions to facilitate measurements of turbulence and heat transfer. The model size is scaled up to simulate Reynolds numbers (based on leading edge diameter) that are to be expected on a turbine blade leading edge. Reynolds numbers from 13 000 to 177 000 were run in the present tests.Spanwise averaged heat transfer measurements with high and low turbulence have been made with “rough” and smooth surface stagnation regions. Results of these measurements show that the boundary layer remains laminar in character even in the presence of free stream turbulence at the Reynolds numbers tested. If roughness is added the boundary layer becomes transitional as evidenced by the heat transfer increase with increasing distance from the stagnation line.Hot wire measurements near the stagnation region downstream of an array of parallel wires has shown that vorticity in the form of mean velocity gradients is amplified as flow approaches the stagnation region. Circumferential traverses of a hot wire probe very near the surface of the cylinder have shown the fluctuating component of velocity changes in character depending on free stream turbulence and Reynolds number.Finally smoke wire flow visualization and liquid crystal surface heat transfer visualization have been combined to show that, in the wake of an array of parallel wires, heat transfer is a minimum in the wire wakes where the fluctuating component of velocity (local turbulence) was the highest. Heat transfer was found to be the highest between pairs of vortices where the induced velocity is toward the cylinder surface.Copyright © 1985 by ASME

[1]  J. C. Mumford,et al.  The distortion of turbulence by a circular cylinder , 1979, Journal of Fluid Mechanics.

[2]  M. Morkovin.  On the question of instabilities upstream of cylindrical bodies , 1979 .

[3]  S. Sutera.  Vorticity amplification in stagnation-point flow and its effect on heat transfer , 1965, Journal of Fluid Mechanics.

[4]  J. Kestin,et al.  The Influence of Turbulence on Mass Transfer From Cylinders , 1971 .

[5]  R. I. Vachon,et al.  The effect of turbulence on heat transfer from heated cylinders , 1975 .

[6]  W. Sadeh,et al.  Coherent substructure of turbulence near the stagnation zone of a bluff body , 1981 .

[7]  Nils Frössling,et al.  Evaporation, Heat Transfer, and Velocity Distribution in Two-Dimensional and Rotationally Symmetrical Laminar Boundary-Layer Flow , 1958 .

[8]  Arnold M. Kuethe,et al.  Effects of Turbulence on Laminar Skin Friction and Heat Transfer , 1966 .

[9]  L. M. Russell,et al.  Evaluation of a Method for Heat Transfer Measurements and Thermal Visualization Using a Composite of a Heater Element and Liquid Crystals , 1981 .

[10]  S. J. Kline,et al.  Describing Uncertainties in Single-Sample Experiments , 1953 .

[11]  W. H. Giedt.  Effect of Turbulence Level of Incident Air Stream on Local Heat Transfer and Skin Friction on a Cylinder , 1951 .

[12]  H. Nagib,et al.  Vortices induced in a stagnation region by wakes - Their incipient formation and effects on heat transfer from cylinders , 1977 .

[13]  H. Schlichting.  Boundary Layer Theory , 1955 .

[14]  J. Kestin,et al.  On the sensitivity of heat transfer in the stagnation-point boundary layer to free-stream vorticity , 1963, Journal of Fluid Mechanics.

[15]  R. J. Simoneau,et al.  Heat transfer distributions around nominal ice accretion shapes formed on a cylinder in the NASA Lewis Icing Research Tunnel , 1984 .