One of the challenges in Doppler radar systems for physiological monitoring is a large DC offset in baseband outputs. Typically, AC coupling is used to eliminate this DC offset. Since the physiological signals of interest include frequency content near DC, it is not desirable to simply use AC coupling on the radar outputs. While AC coupling effectively removes DC offset, it also introduces a large time delay and distortion. This paper presents the first DC coupled IQ demodulator printed circuit board (PCB) design and measurements. The DC coupling is achieved by using a mixer with high LO to RF port isolation, resulting in a very low radar DC offset on the order of mV. The DC coupled signals from the PCB radar system were successfully detected with significant LNA gain without saturation. Compared to the AC coupled results, the DC coupled results show great advantages of less signal distortion and more accurate rate estimation.
[1]
Olga Boric-Lubecke,et al.
2.4 GHz 0.18µm CMOS passive mixer with integrated baluns
,
2009,
2009 IEEE MTT-S International Microwave Symposium Digest.
[2]
Behzad Razavi,et al.
Design considerations for direct-conversion receivers
,
1997
.
[3]
Byung-Kwon Park,et al.
Arctangent Demodulation With DC Offset Compensation in Quadrature Doppler Radar Receiver Systems
,
2007,
IEEE Transactions on Microwave Theory and Techniques.
[4]
Changzhi Li,et al.
Complex signal demodulation and random body movement cancellation techniques for non-contact vital sign detection
,
2008,
IMS 2008.
[5]
A. Abidi.
Direct-conversion radio transceivers for digital communications
,
1995,
Proceedings ISSCC '95 - International Solid-State Circuits Conference.