Spatially continuous strain monitoring using distributed fiber optic sensors embedded in carbon fiber composites

Abstract. A distributed fiber optic strain sensor based on Rayleigh backscattering, embedded in a fiber-reinforced polymer composite, has been demonstrated. The optical frequency domain reflectometry technique is used to analyze the backscattered signal. The shift in the Rayleigh backscattered spectrum is observed to be linearly related to the change in strain of the composite material. The sensor (standard single-mode fiber) is embedded between the layers of the composite laminate. A series of tensile loads is applied to the laminate using an Instron testing machine, and the corresponding strain distribution of the laminate is measured. The results show a linear response indicating a seamless integration of the optical fiber in the composite material and a good correlation with the electrical-resistance strain gauge results. The sensor is also used to evaluate the strain response of a composite-laminate-based cantilever beam. Distributed strain measurements in a composite laminate are successfully obtained using an embedded fiber optic sensor.

[1]  Vadakke Matham Murukeshan,et al.  Cure monitoring of smart composites using Fiber Bragg Grating based embedded sensors , 2000 .

[2]  Ginu Rajan,et al.  Overview of Fiber Optic Sensor Technologies for Strain/Temperature Sensing Applications in Composite Materials , 2016, Sensors.

[3]  K. Chandrashekhara,et al.  Monitoring of out-of-autoclave BMI composites using fiber optic sensors , 2013, Smart Structures.

[4]  Tomasz R. Wolinski,et al.  Composite materials with embedded photonic crystal fiber interferometric sensors , 2012 .

[5]  Eric Udd,et al.  Fiber optic smart structures , 1993, Optics East.

[6]  Zhi Zhou,et al.  Fiber-Reinforced Polymer-Packaged Optical Fiber Bragg Grating Strain Sensors for Infrastructures under Harsh Environment , 2016, J. Sensors.

[7]  Gangbing Song,et al.  Recent applications of fiber optic sensors to health monitoring in civil engineering , 2004 .

[8]  Jian-Hua Yin,et al.  Measurement of cracks in concrete beams using a brillouin optical time domain analysis sensing technology , 2010 .

[9]  Wing Kong Chiu,et al.  Fatigue Damage Monitoring of a Composite Step Lap Joint Using Distributed Optical Fibre Sensors , 2016, Materials.

[10]  S. Watkins,et al.  Assessment of an instrumented reinforced-concrete bridge with fiber-reinforced-polymer strengthening , 2007 .

[11]  Cheng Li,et al.  Flat-Cladding Fiber Bragg Grating Sensors for Large Strain Amplitude Fatigue Tests , 2010, Sensors.

[12]  Sasi Jothibasu,et al.  Rayleigh Backscattering Based Macrobending Single Mode Fiber for Distributed Refractive Index Sensing , 2017 .

[13]  Nobuo Takeda,et al.  Summary report of the structural health-monitoring project for smart composite structure systems , 2001 .

[14]  Peipei Liu,et al.  Structural Health Monitoring for Composite Materials , 2012 .

[15]  Dong Gun Lee,et al.  Characterization of Fiber Optic Sensors for Structural Health Monitoring , 2002 .

[16]  K. Chandrashekhara,et al.  Measurement and analysis of impact-induced strain using extrinsic Fabry-Pérot fiber optic sensors , 1998 .

[17]  Hua Xia,et al.  SUBSYSTEM DESIGN AND VALIDATION FOR OPTICAL SENSORS FOR MONITORING ENHANCED GEOTHERMAL SYSTEMS , 2011 .

[18]  M. Froggatt,et al.  High-spatial-resolution distributed strain measurement in optical fiber with rayleigh scatter. , 1998, Applied optics.

[19]  Lei Yuan,et al.  Strain monitoring of bismaleimide composites using embedded microcavity sensor , 2016 .

[20]  R. Bernini,et al.  A reconstruction technique for long-range stimulated Brillouin scattering distributed fibre-optic sensors: experimental results , 2005 .

[21]  Ralph P. Tatam,et al.  Development and application of optical fibre strain and pressure sensors for in-flight measurements , 2016 .

[22]  Marc Wuilpart,et al.  Optical frequency domain reflectometry: A review , 2009, 2009 11th International Conference on Transparent Optical Networks.

[23]  G. Sendeckyj,et al.  Review of the mechanics of embedded optical sensors , 1995 .

[24]  Gerald Hefferman,et al.  Ultraweak intrinsic Fabry-Perot cavity array for distributed sensing. , 2015, Optics letters.

[25]  Kok-Sing Lim,et al.  Chronology of Fabry-Perot Interferometer Fiber-Optic Sensors and Their Applications: A Review , 2014, Sensors.

[26]  Ginu Rajan,et al.  Hybrid Fiber Optic Sensor System for Measuring the Strain, Temperature, and Thermal Strain of Composite Materials , 2014, IEEE Sensors Journal.

[27]  Chen Zhu,et al.  Unclonable Optical Fiber Identification Based on Rayleigh Backscattering Signatures , 2017, Journal of Lightwave Technology.

[28]  Tomasz R. Wolinski,et al.  Influence of lamination process on optical fiber sensors embedded in composite material , 2012 .

[29]  Tomasz R. Wolinski,et al.  The influence of thermal expansion of a composite material on embedded polarimetric sensors , 2011 .

[30]  Jie Huang,et al.  Spatially continuous distributed fiber optic sensing using optical carrier based microwave interferometry. , 2014, Optics express.

[31]  Raffaella Di Sante,et al.  Fibre Optic Sensors for Structural Health Monitoring of Aircraft Composite Structures: Recent Advances and Applications , 2015, Sensors.

[32]  Kun Liu,et al.  Distributed magnetic field sensor based on magnetostriction using Rayleigh backscattering spectra shift in optical frequency-domain reflectometry , 2014 .

[33]  Liang Chen,et al.  Recent Progress in Distributed Fiber Optic Sensors , 2012, Sensors.

[34]  António Torres Marques,et al.  Implementation and Testing of Smart Composite Laminates with Embedded Piezoelectric Sensors/Actuators , 2008 .

[35]  Kent A. Murphy,et al.  Low-profile fibers for embedded smart structure applications , 1991, Other Conferences.

[36]  Jr. W.B. Spillman,et al.  Sensing and processing for smart structures , 1996, Proc. IEEE.

[37]  Toshihiko Yoshino,et al.  Fiber-Optic Fabry-Perot Interferometer and its Sensor Applications , 1982 .