论文信息 - Optimization of suspension characteristics for shaping processes - 字舞流文

Optimization of suspension characteristics for shaping processes

H. Kamiya | M. Naito | J. Tsubaki | Y. Fukuda | N. Yoshikaw

[1] Hideo Takahashi,et al. Influence of Slurry Flocculation on the Character and Compaction of Spray‐Dried Silicon Nitride Granules , 1995 .

[2] H. Kamiya,et al. Powder Processing for the Fabrication of Si3N4 Ceramics: I, Influence of Spray‐Dried Granule Strength on Pore Size Distribution in Green Compacts , 1995 .

[3] K. Uematsu,et al. Direct Study of the Behavior of Flaw‐Forming Defect in Sintering , 1992 .

[4] Y. Yamauchi,et al. Tensile Rupture Strength and Fracture Defects of Sintered Silicon Carbide , 1989 .

[5] P. Nicholson,et al. Strength Improvement of Yttria‐Partially‐Stabilized Zirconia by Flaw Elimination , 1988 .

[6] T. Yokoyama,et al. Particle Size Measurement Based on Detection of Unbalance by Centrifugal Sedimentation [Translated]† , 1986 .

[7] A. Evans,et al. Fracture Mechanics of Ceramics , 1986 .

[8] Genji Jimbo,et al. Theoretical analysis of the tensile strength of a powder bed , 1984 .

[9] R. Rice. Fractographic Identification of Strength-Controlling Flaws and Microstructure , 1974 .

[10] Hans Rumpf,et al. Zur Theorie der Zugfestigkeit von Agglomeraten bei Kraftübertragung an Kontaktpunkten , 1970 .

[11] Yukitoshi Oka,et al. DETERMINATION OF THE TENSILE STRENGTH OF ROCK BY A COMPRESSION TEST OF AN IRREGULAR TEST PIECE , 1966 .