Optimization of Material Removal Rate in EDM Using Taguchi Method
暂无分享,去创建一个
Kaushik Kumar | Milan Kumar Das | Tapan Kumar Barman | Prasanta Sahoo | Kaushik Kumar | P. Sahoo | T. Barman
[1] John B. Shoven,et al. I , Edinburgh Medical and Surgical Journal.
[2] Genichi Taguchi,et al. Introduction to quality engineering.... , 2014 .
[3] P. V. Rao,et al. Surface integrity and material removal mechanisms associated with the EDM of Al2O3 ceramic composite , 2009 .
[4] A. Rajadurai,et al. Influence of EDM process parameters in deep hole drilling of Inconel 718 , 2008 .
[5] Pei-Jen Wang,et al. Semi-empirical Model on Work Removal and Tool Wear in Electrical Discharge Machining , 2001 .
[6] Pei-Jen Wang,et al. Predictions on surface finish in electrical discharge machining based upon neural network models , 2001 .
[7] Ko-Ta Chiang,et al. Modeling and analysis of the effects of machining parameters on the performance characteristics in the EDM process of Al2O3+TiC mixed ceramic , 2008 .
[8] T. R. Bement,et al. Taguchi techniques for quality engineering , 1995 .
[9] Stephen T. Newman,et al. State of the art electrical discharge machining (EDM) , 2003 .
[10] Nihat Tosun,et al. A study on kerf and material removal rate in wire electrical discharge machining based on Taguchi method , 2004 .
[11] K. Palanikumar,et al. Modeling and analysis for surface roughness in machining glass fibre reinforced plastics using response surface methodology , 2007 .