Design of Self-tracking High-pass Filter
暂无分享,去创建一个
A novel self-tracking high-pass filter by using analog multiplier and current feedback op-Amp (CFA) is proposed in this paper. The frequency-voltage (F/V) converter transforms the input pulse signal into the voltage, and then the output of F/V converter controls the cut-off frequency of voltage controlled high-pass filter. Thus, the cut-off frequency of designed filter is linear with the frequency of input signal in case that resistors and capacitors are reasonable adjusted. The experiment and simulation results show that the cut-off frequency of designed filter is 1 kHz-100 kHz..
[1] Ahmed M. Soliman,et al. Voltage mode and current mode Tow Thomas bi‐quadratic filters using inverting CCII , 2007, Int. J. Circuit Theory Appl..
[2] A. Toker,et al. The dual-X current conveyor (DXCCII): a new active device for tunable continuous-time filters , 2003 .
[3] Song Xing,et al. Unifying Electrical Engineering and Electronics Engineering , 2014 .
[4] W. Sa-Ngiamvibool,et al. A 10.7-MHz fully balanced, high-Q, 107-dB-dynamic-range current-tunable bandpass filter , 2007 .