An AC-DC converter for human body-based vibration energy harvesting

Abstract This paper presents an optimized AC–DC converter designed in 65 nm low power process technology. Two topologies of the AC–DC converter are designed, namely, Bias-Flip rectifier and Voltage Doubler. The design is part of a piezo electric energy harvesting system targeting wearable electronics. Voltage doubler and full-bridge rectifier are fabricated to support a start-up mechanism while the bias-flip rectifier supports higher efficiency for the normal operation mode. Using a piezo electric energy harvester mounted on a shaker and operated at 4.5 Hz, the maximum extracted power from the voltage doubler is measured as 79.8 nW at 0.21 g. In addition, the maximum extracted power from the full-bridge rectifier is measured as 22.2 nW. As such, voltage doubler is more efficient than full-bridge rectifier by 71%. The experiment uses MIDE V22BL piezo electric harvester with 25 Hz resonance frequency. However, the harvester was used at 4.5 Hz (human frequency) which degrade the energy extracted from the harvester. If another harvester was designed to tune to lower frequency, higher energy level can be extracted. Another contribution in this paper is to compare the on-chip voltage doubler to board level with discrete components. Our experimental results show 11% improvement in efficiency for the on-chip design compared to off-chip for the same input power. The combined bias-flip rectifier and voltage doubler support energy autonomous systems where no start-up power is needed.

[1]  Rajeevan Amirtharajah,et al.  A Full-Wave Rectifier for Interfacing with Multi-Phase Piezoelectric Energy Harvesters , 2008, 2008 IEEE International Solid-State Circuits Conference - Digest of Technical Papers.

[2]  Anantha Chandrakasan,et al.  An efficient piezoelectric energy-harvesting interface circuit using a bias-flip rectifier and shared inductor , 2009, 2009 IEEE International Solid-State Circuits Conference - Digest of Technical Papers.

[3]  Baker Mohammad,et al.  Piezo Electric energy harvester and its interface circuit: Opportunities and challenges , 2013, 2013 IEEE 20th International Conference on Electronics, Circuits, and Systems (ICECS).

[4]  Yogesh K. Ramadass.  Energy processing circuits for low-power applications , 2009 .

[5]  Mohammed Ismail,et al.  Energy efficient system-on-chip architecture for non-invasive mobile monitoring of diabetics , 2013, 2013 8th International Conference on Design & Technology of Integrated Systems in Nanoscale Era (DTIS).

[6]  Prusayon Nintanavongsa,et al.  Design Optimization and Implementation for RF Energy Harvesting Circuits , 2012, IEEE Journal on Emerging and Selected Topics in Circuits and Systems.

[7]  Lu Dong,et al.  Fabrication and performance of MEMS-based piezoelectric power generator for vibration energy harvesting , 2006, Microelectron. J..

[8]  Hamid Abdi,et al.  Human passive motions and a user-friendly energy harvesting system , 2014 .

[9]  Kaushik Roy,et al.  Efficient Design of Micro-Scale Energy Harvesting Systems , 2011, IEEE Journal on Emerging and Selected Topics in Circuits and Systems.

[10]  S. Bandyopadhyay,et al.  Platform Architecture for Solar, Thermal, and Vibration Energy Combining With MPPT and Single Inductor , 2011, IEEE Journal of Solid-State Circuits.

[11]  Dong Sam Ha,et al.  A Self-Powered High-Efficiency Rectifier With Automatic Resetting of Transducer Capacitance in Piezoelectric Energy Harvesting Systems , 2015, IEEE Transactions on Very Large Scale Integration (VLSI) Systems.

[12]  Anantha Chandrakasan,et al.  Platform architecture for solar, thermal and vibration energy combining with MPPT and single inductor , 2011, 2011 Symposium on VLSI Circuits - Digest of Technical Papers.

[13]  Bernard Chih-Hsun Yen.  Vibration-to-electric energy conversion using a mechanically-varied capacitor , 2005 .

[14]  Anantha P. Chandrakasan,et al.  A 1.1 nW Energy-Harvesting System with 544 pW Quiescent Power for Next-Generation Implants , 2014, IEEE Journal of Solid-State Circuits.

[15]  Dongsheng Ma,et al.  A 12-μW to 1.1-mW AIM Piezoelectric Energy Harvester for Time-Varying Vibrations With 450-nA $I_{\bm Q}$ , 2015, IEEE Transactions on Power Electronics.

[16]  Anantha Chandrakasan,et al.  23.2 A 1.1nW energy harvesting system with 544pW quiescent power for next-generation implants , 2014, 2014 IEEE International Solid-State Circuits Conference Digest of Technical Papers (ISSCC).

[17]  Mohammed Ismail,et al.  Characterization of Human Body-Based Thermal and Vibration Energy Harvesting for Wearable Devices , 2014, IEEE Journal on Emerging and Selected Topics in Circuits and Systems.