Wet Clutch Tribology - Friction Characteristics in Limited Slip Differentials
暂无分享,去创建一个
[1] Stefan Björklund,et al. Friction models for sliding dry, boundary and mixed lubricated contacts , 2007 .
[2] P. Zagrodzki. Numerical analysis of temperature fields and thermal stresses in the friction discs of a multidisc wet clutch , 1985 .
[3] H. Ohtani,et al. The Effect of Friction Modifiers on the Low-Speed Friction Characteristics of Automatic Transmission Fluids Observed with Scanning Force Microscopy , 1998 .
[4] T. Stolarski. Tribology in Machine Design , 1990 .
[5] Michael Hoeck,et al. The Influence of Various 4WD Driveline Configurations on Handling and Traction on Low Friction Surfaces , 1999 .
[6] James L. Linden,et al. Anti-Shudder Property of Automatic Transmission Fluids - A Study by the International Lubricants Standardization and Approval Committee (ILSAC) ATF Subcommittee , 2000 .
[7] Hiroko Ohtani,et al. Prediction of Anti-Shudder Properties of Automatic Transmission Fluids using a Modified SAE No. 2 Machine , 1994 .
[8] J. Degrieck,et al. The tribological behaviour of paper friction plates for wet clutch application investigated on SAE#II and pin-on-disk test rigs , 2001 .
[9] Friction Characteristics of Controlled-Slip Differential Lubricants , 1966 .
[10] John Park,et al. Dana torque vectoring differential dynamic Trak , 2004 .
[11] Mamoru Miyazaki,et al. Evaluation of Vibration-Preventive Properties of Lubricating Oils in Wet Friction Plates and Retention of Such Properties Using a Friction Tester , 1988 .
[12] Hirotaka Kaneko,et al. Judder analysis of electronically controlled limited slip differential , 1996 .
[13] Andrew Baldwin,et al. X-by-wire technology , 2001 .
[14] Luciano Afferrante,et al. The effect of engagement laws on the thermomechanical damage of multidisk clutches and brakes , 2004 .
[15] George D. Huron. Numerical Simulations of SAE #2 Machine Tests , 1999 .
[16] Hisanao Kitabayashi,et al. Analysis of the Various Factors Affecting Drag Torque in Multiple-Plate Wet Clutches , 2003 .
[17] L. L. Ting. Part II: Consolidating contact phase — Poroelastic effect , 1975 .
[18] Robert C. Lam,et al. FRICTION MATERIAL/OIL INTERFACE FOR SLIPPING CLUTCH APPLICATIONS , 2001 .
[19] Toru Nakata,et al. New Electonically Controlled Torque Split 4WD System for Improving Cornering Performance , 1990 .
[20] Paula Vettel,et al. Advances in Additive Technology for Limited Slip Axles – Part I Friction Test Development , 2003 .
[21] Shinichi Natsumeda,et al. Numerical Simulation of Engagement of Paper Based Wet Clutch Facing , 1994 .
[22] M. A. Plint,et al. A new technique for the investigation of stick-slip , 1985 .
[23] Hiroki Sasaki,et al. Development of an electronically controlled limited slip differential system , 1994 .
[24] Fumio Ueda,et al. Development of Automatic Transmission Fluid for Slip-Controlled Lock-Up Clutch Systems , 1995 .
[25] Fumio Ueda,et al. Next Generation High Performance ATF for Slip-Controlled Automatic Transmission , 1997 .
[26] Pradeep Attibele,et al. CFD Simulation of the Flows Within Disengaged Wet Clutches of an Automatic Transmission , 2003 .
[27] Samuel H. Tersigni,et al. Fundamentals of Anti-Shudder Durability: Part II - Fluid Effects , 2003 .
[28] Hiromu Sugiyama,et al. A High-Speed Photography Study on Engagement Process of Wet Clutch. , 1996 .
[29] P. A. Willermet,et al. ATF Bulk Oxidative Degradation and Its Effects on LVFA Friction and the Performance of a Modulated Torque Converter Clutch , 1998 .
[30] Mikael Holgerson,et al. Wet clutch engagement characteristics , 1999 .
[31] P. L. Ko,et al. Friction-induced vibration — with and without external disturbance , 2001 .
[32] Rikard Mäki. Wet clutch tribology : friction characteristics in all-wheel drive differentials , 2003 .
[33] Rikard Mäki,et al. Wet clutch transmission fluid for AWD differentials: base fluid influence on friction characteristics , 2006 .
[34] Samuel H. Tersigni,et al. ATF Effects on Friction Stability in Slip-Controlled Torque Converter Clutches , 2003 .
[35] Mikael Holgerson,et al. Optimizing the smoothness and temperatures of a wet clutch engagement through control of the normal force and drive torque , 2000 .
[36] Parviz Payvar,et al. Laminar heat transfer in the oil groove of a wet clutch , 1991 .
[37] Takashi Yamamoto,et al. Development of a new electronically controlled 4WD system: Toyota active torque control 4WD , 1999 .
[38] Tatsuo Yoshioka,et al. Proposal of New Criteria and Test Methods for the Dynamic Performance of ATF , 1990 .
[39] Hiroshi Yabe,et al. Modeling of Heat Transfer and Fluid Hydrodynamics for a Multidisc Wet Clutch , 1995 .
[40] Rikard Mäki,et al. Measurement and Characterization of Anti-shudder Properties in Wet Clutch Applications , 2005 .
[41] Mark P. Everson,et al. Clutch Shudder Correlated to ATF Degradation through Local Friction vs. Velocity Measurements by a Scanning Force Microscope , 1996 .
[42] Rickard Olsson,et al. Durability and Friction Characteristics of a Novel High Performance Four Wheel Drive Automotive Transmission Fluid , 2000 .
[43] Yubo Yang,et al. Prediction of Torque Response During the Engagement of Wet Friction Clutch , 1998 .
[44] Elizabeth A. Schiferl,et al. Friction and Stick-Slip Durability Testing of ATF , 1994 .
[45] Rikard Mäki,et al. Limited Slip Wet Clutch Transmission Fluid for AWD Differentials; Part 1: System Requirements and Evaluation Methods , 2003 .
[46] Edward J. Berger,et al. Finite Element Modeling of Engagement of Rough and Grooved Wet Clutches , 1996 .
[47] Kohei Matsuo,et al. Study on the Change of Friction Characteristics with Use In the Wet Clutch of Automatic Transmission , 1997 .
[48] Mikael Holgerson. Apparatus for measurement of engagement characteristics of a wet clutch , 1997 .
[49] L. Ting. Engagement behavior of lubricated porous annular disks. Part I: Squeeze film phase — surface roughness and elastic deformation effects , 1975 .
[50] Thomas S. Derevjanik. Detergent and Friction Modifier Effects on Metal/Metal and Clutch Material/Metal Frictional Performance , 2001 .
[51] P. Zagrodzki. Analysis of thermomechanical phenomena in multidisc clutches and brakes , 1990 .
[52] Samuel H. Tersigni,et al. Fundamentals of anti-shudder durability: Part I - Clutch plate study , 2003 .
[53] Hiromu Sugiyama,et al. Visualizaion of Cavitation Phenomena in Wet Clutch Engagement Process , 1997 .
[54] E. Rabinowicz,et al. Friction and Wear of Materials , 1966 .
[55] James L. Linden,et al. A Comparison of Methods for Evaluating Automatic Transmission Fluid Effects on Friction Torque Capacity - A Study by the International Lubricant Standardization and Approval Committee (ILSAC) ATF Subcommittee , 1998 .
[56] P. A. Willermet,et al. Interaction Between ATFs and Friction Material for Modulated Torque Converter Clutches , 1998 .
[57] Bandaru V. Ramarao,et al. A Comprehensive Study of Self-Induced Torque Amplification in Rotary Viscous Couplings , 2003 .
[58] H. Cheng,et al. An Average Flow Model for Determining Effects of Three-Dimensional Roughness on Partial Hydrodynamic Lubrication , 1978 .
[59] Kent Ekholm,et al. Limited slip wet clutch transmission fluid for AWD differentials : Part 2: Fluid development and verification , 2003 .
[60] M. Khonsari,et al. Thermal Characteristics of a Wet Clutch , 1999 .
[61] Satoshi Segawa,et al. Development of a Slip Control System for a Lock-Up Clutch , 2004 .
[62] Edward J. Berger,et al. Analytical and Numerical Modeling of Engagement of Rough, Permeable, Grooved Wet Clutches , 1997 .
[63] J. L. Sumiejski,et al. Extended-Drain ATF Field Testing in City Transit Buses , 2003 .