Recent Work on Boiling and Condensation in Microchannels

Recent work on boiling of water and condensation of steam in single and parallel microchannels is reviewed in this paper. It is found that the amplitude and frequency of fluctuations of temperature and pressure during the unstable flow-boiling mode depend greatly on the inlet/outlet configurations and the exit vapor quality. By fabricating an inlet restriction on each microchannel or the installation of a throttling valve upstream of the test section, reversed flow of vapor bubbles can be suppressed resulting in a stable flow-boiling mode. Boiling heat transfer coefficient and pressure drop in microchannels under stable flow-boiling conditions are obtained. These data at high vapor qualities are found to be substantially different from the correlations obtained for flow-boiling in macrochannels. Microbubble emission boiling phenomena, which can defer the arrival of critical heat flux, exist in a partially heated Pyrex glass microchannel at sufficiently high heat flux and high inlet subcooling conditions. For condensation in a microchannel, transition from annular flow to slug/bubbly flow is investigated. The occurrence of the injection flow is owing to the instability of the liquid/vapor interface. The location, at which the injection flow occurs, depends on the mass flux and the cooling rate of steam. Increase in steam mass flux, decrease in cooling rate, and microchannel diameter tend to enhance the instability of the condensate film on the wall, resulting in the occurrence of injection flow further downstream at increasingly high frequency. The pressure drop in the condensing flow increases with the increase in mass flux and quality or with decreasing microchannel diameter. The existing correlations for pressure drop and heat transfer of condensing flow in macrochannels overestimate the experimental data in microchannels.

[1]  Jonathan Rose,et al.  A Theory of Film Condensation in Horizontal Noncircular Section Microchannels , 2005 .

[2]  S. Garimella,et al.  Measurement and Modeling of Condensation Heat Transfer Coefficients in Circular Microchannels , 2006 .

[3]  J. Thome.  Boiling in microchannels: a review of experiment and theory , 2004 .

[4]  Y. Peles,et al.  Suppression of Boiling Flow Oscillations in Parallel Microchannels by Inlet , 2006 .

[5]  I. Mudawar,et al.  Flow boiling heat transfer in two-phase micro-channel heat sinks--II. Annular two-phase flow model , 2003 .

[6]  Moo Hwan Kim,et al.  An experimental study of condensation heat transfer inside a mini-channel with a new measurement technique , 2004 .

[7]  Daniel A. Willistein,et al.  EXPERIMENTAL EVALUATION OF PRESSURE DROP ELEMENTS AND FABRICATED NUCLEATION SITES FOR STABILIZING FLOW BOILING IN MINICHANNELS AND MICROCHANNELS , 2005 .

[8]  Albert Mosyak,et al.  Explosive boiling of water in parallel micro-channels , 2005 .

[9]  W. Wang,et al.  A condensation heat transfer correlation for millimeter-scale tubing with flow regime transition , 2002 .

[10]  Chai Ching Tan,et al.  The effect of mass transfer on Kelvin-Helmholtz instability at the gas-liquid interface of a sonic reacting and non-reacting gas jet submerged in a liquid , 1994 .

[11]  Ralph L. Webb,et al.  A New Equivalent Reynolds Number Model for Condensation in Smooth Tubes , 1998 .

[12]  Emad W. Jassim,et al.  Flow-Regime-Based Model for Pressure Drop Predictions in Microchannels , 2006 .

[13]  Huiying Wu,et al.  Condensation flow patterns in silicon microchannels , 2005 .

[14]  Steady-State and Transient Behavior of Two Heat Exchangers Coupled by a Circulating Flowstream , 2005 .

[15]  John R. Thome,et al.  Heat Transfer Model for Evaporation of Elongated Bubble Flows in Microchannels , 2002 .

[16]  Tian-yang Zhao,et al.  Theoretical analysis of film condensation heat transfer inside vertical mini triangular channels , 2002 .

[17]  John R. Thome,et al.  A new type of diabatic flow pattern map for boiling heat transfer in microchannels , 2007 .

[18]  Huiying Wu,et al.  Transition from annular flow to plug/slug flow in condensation of steam in microchannels , 2008 .

[19]  H. Wang,et al.  Film condensation in horizontal microchannels: Effect of channel shape☆ , 2006 .

[20]  Satish G. Kandlikar,et al.  Fundamental issues related to flow boiling in minichannels and microchannels , 2002 .

[21]  Huiying Wu,et al.  Unstable and stable flow boiling in parallel microchannels and in a single microchannel , 2007 .

[22]  J. Thome,et al.  Investigation of saturated critical heat flux in a single, uniformly heated microchannel , 2006 .

[23]  Hiroshi Kawamura,et al.  Enhancement of heat transfer in subcooled flow boiling with microbubble emission , 2005 .

[24]  Ty A. Newell,et al.  Prediction of two-phase pressure drop and void fraction in microchannels using probabilistic flow regime mapping , 2006 .

[25]  Huiying Wu,et al.  Phase-Change Heat Transfer in Microsystems , 2007 .

[26]  Huiying Wu,et al.  Mesoscale and Microscale Phase-Change Heat Transfer , 2006 .

[27]  S. Kandlikar.  A General Correlation for Saturated Two-Phase Flow Boiling Heat Transfer Inside Horizontal and Vertical Tubes , 1990 .

[28]  I. Mudawar,et al.  Measurement and prediction of pressure drop in two-phase micro-channel heat sinks , 2003 .

[29]  Huiying Wu,et al.  Visualization and measurements of periodic boiling in silicon microchannels , 2003 .

[30]  Huiying Wu,et al.  Boiling instability in parallel silicon microchannels at different heat flux , 2004 .

[31]  Huiying Wu,et al.  An experimental investigation on pressure drop of steam condensing in silicon microchannels , 2008 .

[32]  John R. Thome,et al.  High heat flux flow boiling in silicon multi-microchannels – Part II: Heat transfer characteristics of refrigerant R245fa , 2008 .

[33]  P. Cheng,et al.  Effects of inlet/outlet configurations on flow boiling instability in parallel microchannels , 2008 .

[34]  T. Hibiki,et al.  Some characteristics of air-water two-phase flow in small diameter vertical tubes , 1996 .

[35]  Suresh V. Garimella,et al.  Microchannel size effects on local flow boiling heat transfer to a dielectric fluid , 2008 .

[36]  John R. Thome,et al.  Heat Transfer Model for Evaporation in Microchannels, Part I: Presentation of the Model , 2004 .

[37]  泉 亮太郎,et al.  サブクールプール沸騰特性曲線の研究 : 第1報, 局所熱伝達特性とそれにおよぼすサブクール度の影響 , 1981 .

[38]  Srinivas Garimella,et al.  An Expermentally Validated Model for Two-Phase Pressure Drop in the Intermittent Flow Regime for Noncircular Microchannels , 2002 .

[39]  Shigeru Koyama,et al.  An experimental study on condensation of refrigerant R134a in a multi-port extruded tube , 2003 .

[40]  Min-Soo Kim,et al.  The pressure drop in microtubes and the correlation development. , 2006 .

[41]  Suresh V. Garimella,et al.  Refrigerant flow boiling heat transfer in parallel microchannels as a function of local vapor quality , 2008 .

[42]  J. Thome,et al.  Investigation of Flow Boiling in Horizontal Tubes: Part II, Development of a New Heat Transfer Model for Stratified-Wavy, Dryout and Mist Flow Regimes , 2005 .

[43]  Moo Hwan Kim,et al.  An Experimental Study of Flow Condensation Heat Transfer Inside Circular and Rectangular Mini-Channels , 2005 .

[44]  R. Kulenovic,et al.  Heat transfer mechanism and flow pattern during flow boiling of water in a vertical narrow channel—experimental results , 2007 .

[45]  L. Friedel.  Improved Friction Pressure Drop Correlation for Horizontal and Vertical Two-Phase Pipe Flow , 1979 .

[46]  Davide Del Col,et al.  Condensation Heat Transfer and Pressure Gradient Inside Multiport Minichannels , 2005 .

[47]  Guodong Wang,et al.  Subcooled flow boiling and microbubble emission boiling phenomena in a partially heated microchannel , 2009 .

[48]  M. Shah.  A general correlation for heat transfer during film condensation inside pipes , 1979 .

[49]  P. Cheng,et al.  Condensation of steam in silicon microchannels , 2005 .

[50]  John R. Thome,et al.  Heat Transfer Model for Evaporation in Microchannels, Part II: Comparison with the Database , 2004 .

[51]  Lounes Tadrist,et al.  Experimental study of unsteady convective boiling in heated minichannels , 2003 .

[52]  Mohammad Layeghi,et al.  A Review of Concentric Annular Heat Pipes , 2005 .