The fire environment in a multi-room building: comparison of predicted and experimental results

Abstract This paper outlines results from a research project which is being used to investigate realistic fire environments in a prototype multi-room building. A comprehensive set of experimental data was obtained from a recently constructed three-storey Experimental Building-Fire Facility. The facility is used for a variety of fire investigation purposes, including fire growth and spread, smoke movement, and the effects of stair pressurisation and extinguishment. For the current investigation, a propane burner was located in the centre of a burn room to simulate a fire under both steady-state and transient-state conditions. The burn room was connected to other rooms. A comprehensive set of temperature, radiation and flow velocity measurements was obtained. The numerical results obtained from a computational fluid dynamics (CFD) model were found to agree well with the experimental results. The CFD model results were also found to agree well with zone model predictions. These results encourage use of the CFD model to research the phenomena of realistic fire growth and spread and smoke movement in prototype building layouts.

[1]  N. C. Markatos,et al.  Mathematical modelling of buoyancy-induced smoke flow in enclosures , 1982 .

[2]  W. Jones,et al.  The prediction of laminarization with a two-equation model of turbulence , 1972 .

[3]  F. Lockwood,et al.  A new radiation solution method for incorporation in general combustion prediction procedures , 1981 .

[4]  V. B. Apte,et al.  Pool Fire Plume Flow In A Large-scale Wind Tunnel , 1991 .

[5]  B. Launder,et al.  THE NUMERICAL COMPUTATION OF TURBULENT FLOW , 1974 .

[6]  K. Moodie,et al.  The King's Cross fire: Results and analysis from the scale model tests☆ , 1992 .

[7]  F. C. Lockwood,et al.  The prediction of the fluctuations in the properties of free, round-jet, turbulent, diffusion flames , 1975 .

[8]  W. Z. Black,et al.  Two-zone model for a single-room fire , 1992 .

[9]  B. Launder,et al.  The numerical computation of turbulent flows , 1990 .

[10]  J. Kent,et al.  Three-dimensional furnace computer modelling , 1988 .

[11]  G. Cox,et al.  Field Modelling of Fire in Forced Ventilated Enclosures , 1987 .

[12]  Kozo Saito,et al.  Scale modeling of fires with emphasis on room flashover phenomenon , 1992 .

[13]  Peter Johnson.  Comment on 'the accuracy of computer fire models: Some comparisons with experimental data from Australia' , 1991 .

[14]  W. Jones,et al.  Calculation methods for reacting turbulent flows: A review , 1982 .

[15]  Rodney Kenneth. Boyd.  Computer modelling of a coal fired furnace , 1986 .

[16]  S. Patankar.  Numerical Heat Transfer and Fluid Flow , 2018, Lecture Notes in Mechanical Engineering.

[17]  Richard W. Bukowski,et al.  Verification of a Model of Fire and Smoke Transport , 1993 .

[18]  Noam Lior,et al.  Numerical Calculation of Three-Dimensional Turbulent Natural Convection in a Cubical Enclosure Using a Two-Equation Model for Turbulence , 1986 .

[19]  Duy Q. Duong.  The accuracy of computer fire models: some comparisons with experimental data from Australia , 1990 .

[20]  Leonard Y. Cooper,et al.  Comparisons of NBS/Harvard VI simulations and data from all runs of a full-scale multi-room fire test program , 1989 .

[21]  H. Takeda,et al.  Simplified Fire Growth Models for Risk-Cost Assessment in Apartment Buildings , 1992 .