Electrospun fibrous polyacrylic acid membrane-based gas sensors

Abstract Electrospun fibrous polyacrylic acid (PAA) membranes were studied as sensing material coated on quartz crystal microbalance (QCM) for ammonia detection at ppb level. The fibrous membranes with different morphology can be deposited on the electrode of QCM by electrospinning the PAA solutions with various solvent composition of H 2 O and ethanol. The results of sensing experiments indicated that the sensitivity of the fibrous membranes coated QCM (FM-QCM) sensors was four times higher than that of the casting films coated QCM (CF-QCM) sensors. Meanwhile, the FM-QCM sensors exhibited high sensitivity towards low concentration of ammonia, as low as 130 ppb at the relative humidity of 40%. The pre-sorbed water in fibrous membranes was proved to be the key factor to affect the sensitivity of FM-QCM sensors for ammonia. The sensor performance has been found to depend on the morphology of the fibrous membranes, concentration of ammonia, coating load of the fibrous membranes on QCM, and relative humidity. Preliminary study of the stability investigation was also presented.

[1]  Young-Soo Kwon,et al.  Effect of pH on the properties of palmitic acid LB films for gas sensors , 2001 .

[2]  A. Galdikas,et al.  Room-temperature-functioning ammonia sensor based on solid-state CuxS films , 2000 .

[3]  Craig A. Grimes,et al.  Ammonia detection using nanoporous alumina resistive and surface acoustic wave sensors , 2003 .

[4]  João A.B.P. Oliveira,et al.  Quantification of CO2, SO2, NH3, and H2S with a single coated piezoelectric quartz crystal , 2000 .

[5]  Chulki Kim,et al.  Morphology and crystalline phase study of electrospun TiO2–SiO2 nanofibres , 2003 .

[6]  H. Kim,et al.  Influence of a mixing solvent with tetrahydrofuran and N,N‐dimethylformamide on electrospun poly(vinyl chloride) nonwoven mats , 2002 .

[7]  D. Weinkauf,et al.  Glassy polymer‐sorption phenomena measured with a quartz crystal microbalance technique , 2003 .

[8]  A. T. Johnson,et al.  Electrostatically-generated nanofibers of electronic polymers , 2001 .

[9]  Masatoki Ito,et al.  Coadsorption of ammonia and electrolyte anions on a Pt(111) electrode , 1999 .

[10]  V. Erokhin,et al.  A physical insight into the gas-sensing properties of copper (II) tetra-(tert-butyl)-5,10,15,20-tetraazaporphyrin Langmuir–Blodgett films , 2000 .

[11]  Darrell H. Reneker,et al.  Beaded nanofibers formed during electrospinning , 1999 .

[12]  Yude Wang,et al.  Mesostructured SnO2 as sensing material for gas sensors , 2004 .

[13]  Eyal Zussman,et al.  Electrostatic field-assisted alignment of electrospun nanofibres , 2001 .

[14]  G. Wegner,et al.  PAA/imidazol-based proton conducting polymer electrolytes , 2003 .

[15]  B. H. Weiller,et al.  Polyaniline nanofibers: facile synthesis and chemical sensors. , 2003, Journal of the American Chemical Society.

[16]  D. Reneker,et al.  Nanometre diameter fibres of polymer, produced by electrospinning , 1996 .

[17]  Jagannath,et al.  Room temperature operating ammonia sensor based on tellurium thin films , 2004 .

[18]  M. Penza,et al.  SAW gas detection using Langmuir–Blodgett polypyrrole films , 1998 .

[19]  Hung-Bin Lin,et al.  Fullerene C60-cryptand coated surface acoustic wave quartz crystal sensor for organic vapors , 2003 .

[20]  Subramanian,et al.  Surface Chemical Studies on the Competitive Adsorption of Poly(acrylic acid) and Poly(vinyl alcohol) onto Alumina. , 1999, Journal of colloid and interface science.

[21]  Vasant Chabukswar,et al.  Acrylic acid doped polyaniline as an ammonia sensor , 2001 .

[22]  C. Lambert-Mauriat,et al.  Sputtered thin films of CuBr for ammonia microsensors: morphology, composition and ageing , 2002 .

[23]  Bin Ding,et al.  Electrospun nanofibrous membranes coated quartz crystal microbalance as gas sensor for NH3 detection , 2004 .