Optimization of cutting conditions for multi-pass turning operations using sequential quadratic programming
暂无分享,去创建一个
Han Tong Loh | Yoke San Wong | M. A. Rahman | M. S. Chua | Y. Wong | H. Loh | M. Rahman | M. S. Chua
[1] D. S. Ermer,et al. Optimization of Multipass Turning With Constraints , 1981 .
[2] G. Barrow,et al. Calculation of Optimum Cutting Conditions for Turning Operations , 1985 .
[3] M. J. D. Powell,et al. THE CONVERGENCE OF VARIABLE METRIC METHODS FOR NONLINEARLY CONSTRAINED OPTIMIZATION CALCULATIONS , 1978 .
[4] E. Armarego,et al. The Machining of Metals , 1969 .
[5] T. Yellowley. A fundamental examination of the economics of the two-pass turning operation , 1983 .
[6] van der Ach Wolf,et al. A computer aid in the optimization of turning conditions in multi-cut operations , 1978 .
[7] Shih-Ping Han. A globally convergent method for nonlinear programming , 1975 .
[8] K. Schittkowski. NLPQL: A fortran subroutine solving constrained nonlinear programming problems , 1986 .
[9] I. Yellowley,et al. The optimal subdivision of cut in multi-pass machining operations , 1989 .