Design and performance of a centimetre-scale shrouded wind turbine for energy harvesting

A miniature shrouded wind turbine aimed at energy harvesting for power delivery to wireless sensors in pipes and ducts is presented. The device has a rotor diameter of 2?cm, with an outer diameter of 3.2?cm, and generates electrical power by means of an axial-flux permanent magnet machine built into the shroud. Fabrication was accomplished using a combination of traditional machining, rapid prototyping, and flexible printed circuit board technology for the generator stator, with jewel bearings providing low friction and start up speed. Prototype devices can operate at air speeds down to 3? m?s?1, and deliver between 80??W and 2.5?mW of electrical power at air speeds in the range 3?7? m?s?1. Experimental turbine performance curves, obtained by wind tunnel testing and corrected for bearing losses using data obtained in separate vacuum run-down tests, are compared with the predictions of an elementary blade element momentum (BEM) model. The two show reasonable agreement at low tip speed ratios. However, in experiments where a maximum could be observed, the maximum power coefficient (~9%) is marginally lower than predicted from the BEM model and occurs at a lower than predicted tip speed ratio of around 0.6.

[1]  A. Kesel.  Aerodynamic characteristics of dragonfly wing sections compared with technical aerofoils. , 2000, The Journal of experimental biology.

[2]  C. C. Federspiel,et al.  Air-powered sensor , 2003, Proceedings of IEEE Sensors 2003 (IEEE Cat. No.03CH37498).

[3]  Michael S. Selig,et al.  The effect of rotation on the boundary layer of a wind turbine blade , 2000 .

[4]  M. Allen,et al.  Microfabricated, ultra-dense, three-dimensional metal coils , 2009, TRANSDUCERS 2009 - 2009 International Solid-State Sensors, Actuators and Microsystems Conference.

[5]  David C. Yates,et al.  Self-powered wireless sensor for duct monitoring , 2010 .

[6]  F. J. Xu,et al.  Design of a miniature wind turbine for powering wireless sensors , 2010, Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[7]  P. Lissaman,et al.  Low-Reynolds-Number Airfoils , 1983 .

[8]  D. Howey,et al.  CM-scale air turbine and generator for energy harvesting from low-speed flows , 2009, TRANSDUCERS 2009 - 2009 International Solid-State Sensors, Actuators and Microsystems Conference.

[9]  N. Schwesinger,et al.  Power supply for wireless sensor systems , 2008, 2008 IEEE Sensors.

[10]  Peter J. Kunz,et al.  Aerodynamics and design for ultra-low Reynolds number flight , 2003 .

[11]  Hyeoungwoo Kim,et al.  Small scale windmill , 2007 .

[12]  K. Pullen,et al.  Axial-flow microturbine with electromagnetic generator: design, CFD simulation, and prototype demonstration , 2004, 17th IEEE International Conference on Micro Electro Mechanical Systems. Maastricht MEMS 2004 Technical Digest.

[13]  Peter Jamieson,et al.  Generalized limits for energy extraction in a linear constant velocity flow field , 2008 .

[14]  S. L. Dixon,et al.  Fluid mechanics, thermodynamics of turbomachinery , 1966 .

[15]  Jacek F. Gieras,et al.  Axial Flux Permanent Magnet Brushless Machines , 2005 .

[16]  L Benini,et al.  A high-efficiency wind-flow energy harvester using micro turbine , 2010, SPEEDAM 2010.

[17]  C. J. Lawn.  Optimization of the power output from ducted turbines , 2003 .

[18]  Analysis , Design , and Testing of Airfoils for Use at Ultra-Low Reynolds Numbers , 2004 .

[19]  P. K. Chaviaropoulos,et al.  Investigating Three-Dimensional and Rotational Effects on Wind Turbine Blades by Means of a Quasi-3D Navier-Stokes Solver , 2000 .

[20]  A.S. Holmes,et al.  Axial-flux permanent magnet machines for micropower generation , 2005, Journal of Microelectromechanical Systems.

[21]  Mohammed F. Daqaq,et al.  A scalable concept for micropower generation using flow-induced self-excited oscillations , 2010 .

[22]  Dibin Zhu,et al.  A novel miniature wind generator for wireless sensing applications , 2010, 2010 IEEE Sensors.

[23]  Roger C. Strawn,et al.  Analysis and Design of Rotors at Ultra-Low Reynolds Numbers , 2002 .