An ultra-low noise capacitance to voltage converter for sensor applications in 0.35 µm CMOS

Abstract. In this paper we present a readout circuit for capacitive micro-electro-mechanical system (MEMS) sensors such as accelerometers, gyroscopes or pressure sensors. A flexible interface allows connection of a wide range of types of sensing elements. The ASIC (application-specific integrated circuit) was designed with a focus on ultra-low noise operation and high analog measurement performance. Theoretical considerations on system noise are presented which lead to design requirements affecting the reachable overall measurement performance. Special emphasis is put on the design of the fully differential operational amplifiers, as these have the dominant influence on the achievable overall performance. The measured input referred noise is below 50 zF/ Hz within a bandwidth of 10 Hz to 10 kHz. Four adjustable gain settings allow the adaption to measurement ranges from ±750 fF to ±3 pF. This ensures compatibility with a wide range of sensor applications. The full input signal bandwidth ranges from 0 Hz to more than 50 kHz. A high-precision accelerometer system was built from the described ASIC and a high-sensitivity, low-noise sensor MEMS. The design of the MEMS is outlined and the overall system performance, which yields a combined noise floor of 200 ng/ Hz , is demonstrated. Finally, we show an application using the ASIC together with a CMOS integrated capacitive pressure sensor, which yields a measurement signal-to-noise ratio (SNR) of more than 100 dB.

[1]  Kuei-Ann Wen,et al.  A monolithic CMOS MEMS accelerometer with chopper correlated double sampling readout circuit , 2011, 2011 IEEE International Symposium of Circuits and Systems (ISCAS).

[2]  W. Mokwa,et al.  Surface micromachined pressure sensors with integrated CMOS read-out electronics , 1994 .

[3]  Ron Hogervorst,et al.  A compact power-efficient 3 V CMOS rail-to-rail input/output operational amplifier for VLSI cell libraries , 1994 .

[4]  Qiang Fu,et al.  Harmonic Distortion Analysis for Switched-Capacitor Electromechanical Sigma–Delta Modulators , 2015, IEEE Sensors Journal.

[5]  F. Ayazi,et al.  A 2.5-V 14-bit /spl Sigma//spl Delta/ CMOS SOI capacitive accelerometer , 2004, IEEE Journal of Solid-State Circuits.

[6]  O. Hansen,et al.  Highly sensitive micromachined capacitive pressure sensor with reduced hysteresis and low parasitic capacitance , 2009 .

[7]  Michael Kraft,et al.  Encapsulation of implantable integrated MEMS pressure sensors using polyimide epoxy composite and atomic layer deposition , 2014 .

[8]  Bertrand Dutoit,et al.  Standard MEMS Sensor Technologies for Harsh Environment , 2006 .

[9]  N. Yazdi,et al.  Precision readout circuits for capacitive microaccelerometers , 2004, Proceedings of IEEE Sensors, 2004..

[10]  Gabor C. Temes,et al.  A noise-shaping accelerometer interface circuit for two-chip implementation , 2000, 2000 IEEE International Symposium on Circuits and Systems. Emerging Technologies for the 21st Century. Proceedings (IEEE Cat No.00CH36353).

[11]  Hanjun Jiang,et al.  A combined low power SAR capacitance-to-digital analog-to-digital converter for multisensory system , 2013 .

[12]  F. Rudolf,et al.  New generation of high performance/high reliability MEMS accelerometers for harsh environment , 2014, 2014 IEEE/ION Position, Location and Navigation Symposium - PLANS 2014.

[13]  Jonathan J. Bernstein,et al.  Low-noise MEMS vibration sensor for geophysical applications , 1999 .

[14]  K. Najafi,et al.  An all-silicon single-wafer fabrication technology for precision microaccelerometers , 1997, Proceedings of International Solid State Sensors and Actuators Conference (Transducers '97).

[15]  Jung-Suk Goo,et al.  Physical origin of the excess thermal noise in short channel MOSFETs , 2001, IEEE Electron Device Letters.

[16]  Liang Yin,et al.  A Closed-Loop $\Sigma\Delta$ Interface for a High-Q Micromechanical Capacitive Accelerometer With 200 ng/$ \surd$Hz Input Noise Density , 2015, IEEE Journal of Solid-State Circuits.

[17]  E. Vittoz,et al.  A CMOS Chopper Amplifier , 1986, ESSCIRC '86: Twelfth European Solid-State Circuits Conference.

[18]  Jr. W.M. Leach,et al.  On the calculation of noise in multistage amplifiers , 1995 .

[19]  G.K. Fedder,et al.  A low-noise low-offset capacitive sensing amplifier for a 50-/spl mu/g//spl radic/Hz monolithic CMOS MEMS accelerometer , 2004, IEEE Journal of Solid-State Circuits.

[20]  Rahul Sarpeshkar,et al.  An offset-canceling low-noise lock-in architecture for capacitive sensing , 2003, IEEE J. Solid State Circuits.

[21]  Yue Ruan,et al.  Design of a 5mW capacitive accelerometer based on MEMS and CMOS technology , 2012, WCICA 2012.

[22]  Christos Spathis,et al.  A Capacitive-to-Digital Converter With Automatic Range Adaptation for Readout Instrumentation , 2016, IEEE Transactions on Instrumentation and Measurement.

[23]  Wilfried Mokwa,et al.  Fully CMOS compatible capacitive differential pressure sensors with on-chip programmabilities and temperature compensation , 2002, Proceedings of IEEE Sensors.

[24]  Kari Halonen,et al.  Continuous-time interface for a micromachined capacitive accelerometer with NEA of 4 μg and bandwidth of 300 Hz , 2009 .

[25]  M. Kraft,et al.  A dicing free SOI process for MEMS devices , 2012 .

[26]  Haigang Yang,et al.  Noise Analysis and Simulation of Chopper Amplifier , 2006, APCCAS 2006 - 2006 IEEE Asia Pacific Conference on Circuits and Systems.

[27]  Gabor C. Temes,et al.  Circuit techniques for reducing the effects of op-amp imperfections: autozeroing, correlated double sampling, and chopper stabilization , 1996, Proc. IEEE.

[28]  M. Kraft,et al.  Low noise vacuum MEMS closed-loop accelerometer using sixth-order multi-feedback loops and local resonator sigma delta modulator , 2014, 2014 IEEE 27th International Conference on Micro Electro Mechanical Systems (MEMS).

[29]  G. Fedder,et al.  A lateral capacitive CMOS accelerometer with structural curl compensation , 1999, Technical Digest. IEEE International MEMS 99 Conference. Twelfth IEEE International Conference on Micro Electro Mechanical Systems (Cat. No.99CH36291).

[30]  Jean-Michel Stauffer,et al.  RS9000, a novel MEMS accelerometer family for Mil/Aerospace and safety critical applications , 2010, IEEE/ION Position, Location and Navigation Symposium.

[31]  Minkyu Je,et al.  118-dB dynamic range, continuous-time, opened-loop capactance to voltage converter readout for capacitive MEMS accelerometer , 2010, 2010 IEEE Asian Solid-State Circuits Conference.

[32]  Hin-Leung Chau,et al.  Noise due to Brownian motion in ultrasensitive solid-state pressure sensors , 1987, IEEE Transactions on Electron Devices.