Modeling and optimization of the combined carbon dioxide reforming and partial oxidation of natural gas

The optimization of the combined carbon dioxide reforming and partial methane oxidation over a 1% Pt/-Al2O3 catalyst was studied in order to produce synthesis gas with hydrogen/carbon monoxide ratio close to 1, for applications in metallurgical and polycarbonates processes and for production of oxygenated compounds and hydrocarbons. The study was performed with the help of experimental design and two mathematical modeling approaches: empirical and phenomenological. Empirical polynomial models were employed to analyze the effects of the process variables on the response factors and the final correlation coefficients obtained were above 95%. The phenomenological model was obtained from individual mass balances and the obtained correlation coefficients were above 95% for CH4 and N2, 90% for CO2 and H2O and near 70% for H2 and CO. The empirical modeling approach was found to be more efficient, simpler and led to better results than those obtained with the phenomenological model approach. Therefore, the empirical modeling was used for optimization of the process operation conditions. At an oxygen/methane ratio of 0.55 gmol/gmol and temperature of 950 ◦ C, optimized process conditions were obtained with complete methane conversion, maximum carbon monoxide selectivity of 43% and minimum hydrogen/carbon monoxide ratio of 1.3, in absence of water. © 2001 Elsevier Science B.V. All rights reserved.

[1]  Yun Hang Hu,et al.  Combination of CO2 Reforming and Partial Oxidation of Methane over NiO/MgO Solid Solution Catalysts , 1998 .

[2]  M. Bradford,et al.  CO2 Reforming of CH4 , 1999 .

[3]  J. Lercher,et al.  Mono and bifunctional pathways of CO2/CH4 reforming over Pt and Rh based catalysts , 1998 .

[4]  J. Pinto,et al.  Preparation of high loading silica supported nickel catalyst: simultaneous analysis of the precipitation and aging steps , 1999 .

[5]  Yuji Naka,et al.  Mathematical Problems in Fitting Kinetic Models—Some New Perspectives , 1999 .

[6]  Andrew G. Glen,et al.  APPL , 2001 .

[7]  Y. Matsumura,et al.  Oxidative methane conversion to carbon monoxide and hydrogen at low reactor wall temperatures over ruthenium supported on silica , 1994 .

[8]  X. Verykios,et al.  Transient Kinetic Study of the Oxidation and Hydrogenation of Carbon Species Formed during CH4/He, CO2/He, and CH4/CO2Reactions over Rh/Al2O3Catalyst , 1996 .

[9]  L. Mleczko,et al.  A fluidised-bed membrane reactor for the catalytic partial oxidation of methane to synthesis gas , 1996 .

[10]  J. Smith,et al.  Introduction to chemical engineering thermodynamics , 1949 .

[11]  G. G. Stokes.  "J." , 1890, The New Yale Book of Quotations.

[12]  Rafael van Grieken,et al.  Co/HZSM-5 catalyst for syngas conversion: influence of process variables , 1995 .

[13]  Malcolm L. H. Green,et al.  Partial oxidation of methane to synthesis gas, and carbon dioxide as an oxidising agent for methane conversion , 1992 .

[14]  Gbmm Guy Marin,et al.  The Reaction Mechanism of the Partial Oxidation of Methane to Synthesis Gas: A Transient Kinetic Study over Rhodium and a Comparison with Platinum , 1997 .

[15]  V. Choudhary,et al.  Energy efficient methane-to-syngas conversion with low H2/CO ratio by simultaneous catalytic reactions of methane with carbon dioxide and oxygen , 1995 .

[16]  Yonathan Bard,et al.  Nonlinear parameter estimation , 1974 .

[17]  V. Choudhary,et al.  Simultaneous steam and CO2 reforming of methane to syngas over NiO/MgO/SA-5205 in presence and absence of oxygen , 1998 .

[18]  Kiyoshi Otsuka,et al.  Direct partial oxidation of methane to synthesis gas by cerium oxide , 1998 .

[19]  H. Al-Qahtani.  Effect of ageing on a steam reforming catalyst , 1997 .

[20]  T. Brubaker,et al.  Nonlinear Parameter Estimation , 1979 .

[21]  David Mautner Himmelblau,et al.  Process analysis by statistical methods , 1970 .

[22]  Yongwu Lu,et al.  Mechanistic investigations on the partial oxidation of methane to synthesis gas over a nickel-on-alumina catalyst , 1998 .

[23]  J. Fierro,et al.  New catalytic routes for syngas and hydrogen production , 1996 .

[24]  L. Mleczko,et al.  Engineering model of catalytic partial oxidation of methane to synthesis gas in a fluidized-bed reactor , 1998 .

[25]  Wilhelm F. Maier,et al.  Reaction kinetics of the CO2 reforming of methane , 1997 .

[26]  Julian R.H. Ross,et al.  The effect of O2 addition on the carbon dioxide reforming of methane over Pt/ZrO2 catalysts , 1998 .

[27]  Krzysztof Gosiewski,et al.  Effect of the intraparticle mass transport limitations on temperature profiles and catalytic performance of the reverse-flow reactor for the partial oxidation of methane to synthesis gas , 1999 .

[28]  Toshimitsu Suzuki,et al.  Effect of support on the conversion of methane to synthesis gas over supported iridium catalysts , 1998 .