The Effects of Fuel Composition and Compression Ratio on Thermal Efficiency in an HCCI Engine

The effects of variable compression ratio (CR) and fuel composition on thermal efficiency were investigated in a homogeneous charge compression ignition (HCCI) engine using blends of n-heptane and toluene with research octane numbers (RON) of 0 to 88. Experiments were conducted by performing CR sweeps at multiple intake temperatures using both unthrottled operation, and constant equivalence ratio conditions by throttling to compensate for varying air density. It was found that CR is effective at changing and controlling HCCI combustion phasing midpoint, denoted here as CA 50. Thermal efficiency was a strong function of CA 50, with overly advanced CA 50 leading to efficiency decreases. Increases in CR at a constant CA 50 for a given fuel composition did, in most cases, increase efficiency, but the relationship was weaker than the dependence of efficiency on CA 50. The increase in efficiency with higher CR was fuel-dependent, so that the fuels requiring a higher CR to achieve ignition did not gain a proportionate efficiency increase. For example, n-heptane achieved an indicated thermal efficiency (ITE) of 38% at a CR of 9:1, whereas a 50 wt% blend of toluene with n-heptane required a CR of 12:1 to achieve the same ITE. A simplemore » heat balance around the engine showed that higher toluene content fuels had higher cooling losses. The high toluene fuels exhibited higher rates of maximum pressure rise than the lower octane fuels. The increased cooling losses can be attributed to the higher pressure rise rates, which are a driving force for heat transfer.« less

[1]  Bengt Johansson,et al.  Demonstrating the Multi Fuel Capability of a Homogeneous Charge Compression Ignition Engine with Variable Compression Ratio , 1999 .

[2]  William H. Green,et al.  A Modeling Investigation into the Optimal Intake and Exhaust Valve Event Duration and Timing for a Homogenous Charge Compression Ignition Engine , 2005 .

[3]  Gen Shibata,et al.  The Effect of Fuel Properties on Low and High Temperature Heat Release and Resulting Performance of an HCCI Engine , 2004 .

[4]  Bruce G. Bunting,et al.  The Use of Fuel Chemistry and Property Variations to Evaluate the Robustness of Variable Compression Ratio as a Control Method for Gasoline HCCI , 2007 .

[5]  Günter Karl Fraidl,et al.  The new AVL CSI engine : HCCI operation on a multi cylinder gasoline engine , 2004 .

[6]  Prediction of Heat Transfer to the Walls for Autoignition Related Situations in SI Engines , 2000 .

[7]  Ingemar Denbratt,et al.  The Effect of Knock on the Heat Transfer in an SI Engine: Thermal Boundary Layer Investigation using CARS Temperature Measurements and Heat Flux Measurements , 2000 .

[8]  C. Westbrook,et al.  A Comprehensive Modeling Study of n-Heptane Oxidation , 1998 .

[9]  S. H. Jo,et al.  Active Thermo-Atmosphere Combustion (ATAC) - A New Combustion Process for Internal Combustion Engines , 1979 .

[10]  Gen Shibata,et al.  Correlation of Low Temperature Heat Release With Fuel Composition and HCCI Engine Combustion , 2005 .

[11]  Richard Stone,et al.  Introduction to Internal Combustion Engines , 1985, Internal Combustion Engines.

[12]  John B. Heywood,et al.  Internal combustion engine fundamentals , 1988 .

[13]  M. Tazerout,et al.  A Non Intrusive Method for Knock Detection Based on the Exhaust Gas Temperature , 2005 .

[14]  Hua Zhao,et al.  Performance and analysis of a 4-stroke multi-cylinder gasoline engine with CAI combustion , 2002 .