Dynamic Friction and Wear in a Planar-Contact Encapsulated Microball Bearing Using an Integrated Microturbine

The demonstration and characterization of a novel planar-contact encapsulated microball bearing using a radial in-flow microturbine are presented. Stable operation of the air-driven silicon microturbine is shown for over 1 000 000 revolutions at speeds, pressure drops, and flow rates of up to 10 000 r/min, 0.45 lbf/in2, and 3.5 slm, respectively. Incorporation of a gas thrust plenum using a novel packaging scheme has enabled comprehensive spin-down friction characterization of the encapsulated microball bearing. An empirical power-law model for dynamic friction has been developed for speeds of 250-5000 r/min and loads of 10-50 mN, corresponding to torques of 0.0625-2.5 muNldrm and friction torque constants of 2.25-5.25 x 10-4 muNldrm/ r/min. The onset and effect of wear and wear debris have been studied, showing negligible wear in the load bearing surfaces for the operating conditions considered.

[1]  A. D. Young,et al.  An Introduction to Fluid Mechanics , 1968 .

[2]  W. Janna,et al.  Introduction to Fluid Mechanics , 2012 .

[3]  Yu-Chong Tai,et al.  IC-processed electrostatic micro-motors , 1988, Technical Digest., International Electron Devices Meeting.

[4]  R. Muller,et al.  IC-processed electrostatic micromotors , 1989 .

[5]  R. Muller,et al.  IC-processed micro-motors: design, technology, and testing , 1989, IEEE Micro Electro Mechanical Systems, , Proceedings, 'An Investigation of Micro Structures, Sensors, Actuators, Machines and Robots'.

[6]  Dong-il Dan Cho,et al.  A proposal for electrically levitating micromotors , 1990 .

[7]  Stephen F. Bart,et al.  Principles in design and microfabrication of variable-capacitance side-drive motors , 1990 .

[8]  Jeffrey H. Lang,et al.  Friction and wear in microfabricated harmonic side-drive motors , 1990, IEEE 4th Technical Digest on Solid-State Sensor and Actuator Workshop.

[9]  Jeffrey H. Lang,et al.  Measurement of wear in polysilicon micromotors , 1992 .

[10]  A comparative study of bearing designs and operational environments for harmonic side-drive micromotors , 1993 .

[11]  R. I. Lewis,et al.  Turbomachinery Performance Analysis , 1996 .

[12]  Jeffrey H. Lang,et al.  MICRO-HEAT ENGINES, GAS TURBINES, AND ROCKET ENGINES -THE MIT MICROENGINE PROJECT- , 1997 .

[13]  R. Reuben,et al.  Frictional study of micromotor bearings , 1997 .

[14]  J. Lang,et al.  An electrostatic induction micromotor supported on gas-lubricated bearings , 2001, Technical Digest. MEMS 2001. 14th IEEE International Conference on Micro Electro Mechanical Systems (Cat. No.01CH37090).

[15]  K. Komori,et al.  Magnetically levitated micro PM motors by two types of active magnetic bearings , 2001 .

[16]  F. F. Ehrich,et al.  Development of High-Speed Gas Bearings for High-Power Density Microdevices , 2003 .

[17]  Benjamin Shapiro,et al.  Characterization of dynamic friction in MEMS-based microball bearings , 2004, IEEE Transactions on Instrumentation and Measurement.

[18]  S.D. Umans,et al.  A high-power MEMS electric induction motor , 2004, Journal of Microelectromechanical Systems.

[19]  Selin Arslan,et al.  DESIGN PRINCIPLES AND AERODYNAMICS OF LOW REYNOLDS NUMBER MULTI-STAGE MICROTURBOMACHINERY , 2004 .

[20]  R. Ghodssi,et al.  High-speed microfabricated silicon turbomachinery and fluid film bearings , 2005, Journal of Microelectromechanical Systems.

[21]  Xiaobo Tan,et al.  Measurement and Modeling of Dynamic Rolling Friction in Linear Microball Bearings , 2006 .

[22]  Nima Ghalichechian.  Design, Fabrication, and Characterization of a Rotary Variable-Capacitance Micromotor Supported on Microball Bearings , 2007 .

[23]  Reza Ghodssi,et al.  Encapsulated ball bearings for rotary micro machines , 2007 .

[24]  Nicholas R. Jankowski,et al.  MEMS Rotary Actuator using an Integrated Ball Bearing and Air Turbine , 2007, TRANSDUCERS 2007 - 2007 International Solid-State Sensors, Actuators and Microsystems Conference.

[25]  Jeffrey H. Lang,et al.  Dynamic characterization of a linear electrostatic micromotor supported on microball bearings , 2007 .

[26]  R. Ghodssi,et al.  Design, Fabrication, and Characterization of a Rotary Micromotor Supported on Microball Bearings , 2008, Journal of Microelectromechanical Systems.

[27]  R. Ghodssi,et al.  Measurement and modeling of friction in linear and rotary micromotors supported on microball bearings , 2008, 2008 IEEE 21st International Conference on Micro Electro Mechanical Systems.