A software-defined radio RFID reader design with improved wireless power transfer capabilities

We present a SDR-based RFID reader design possessing two features that allow to improve the wireless power transfer capability and thereby extend the reading range of passive transponders: 1) The reader generates optimized non-CW powering waveforms that improve the RF-DC conversion efficiency of passive transponders. The sensitivity of an RFID chip was measured using a CW and several non-CW signals, and a sensitivity gain of more than 3 dB relative to the CW was obtained for a 9-tone multi-sine signal. 2) Moreover, the reader employs a multi-polarization antenna scheme that switches between several linear polarizations to deliver 3 dB more power compared to circular polarization, while maintaining the desired orientation insensitivity.

[1]  Rainer Kokozinski,et al.  A UHF voltage multiplier circuit using a threshold-voltage cancellation technique , 2009, 2009 Ph.D. Research in Microelectronics and Electronics.

[2]  N. B. Carvalho,et al.  Extending Reading Range of Commercial RFID Readers , 2013, IEEE Transactions on Microwave Theory and Techniques.

[3]  Apostolos Georgiadis,et al.  Boosting the Efficiency: Unconventional Waveform Design for Efficient Wireless Power Transfer , 2015, IEEE Microwave Magazine.

[4]  P.V. Nikitin,et al.  Performance limitations of passive UHF RFID systems , 2006, 2006 IEEE Antennas and Propagation Society International Symposium.

[5]  Nuno Borges Carvalho,et al.  Evaluation of simultaneous wireless power transfer and backscattering data communication through multisine signals , 2015 .

[6]  M. Abbak,et al.  RFID Coverage Extension Using Microstrip-Patch Antenna Array [Wireless Corner] , 2009, IEEE Antennas and Propagation Magazine.

[7]  Koji Kotani.  Highly efficient CMOS rectifier assisted by symmetric and voltage-boost PV-cell structures for synergistic ambient energy harvesting , 2013, Proceedings of the IEEE 2013 Custom Integrated Circuits Conference.

[8]  Danilo De Donno,et al.  Listening to Tags: Uplink RFID Measurements With an Open-Source Software-Defined Radio Tool , 2013, IEEE Transactions on Instrumentation and Measurement.

[9]  H. Matsumoto,et al.  An Experimental Study of Passive UHF RFID System with Longer Communication Range , 2007, 2007 Asia-Pacific Microwave Conference.

[10]  Gregory D. Durgin,et al.  Survey of range improvement of commercial RFID tags with Power Optimized Waveforms , 2010, 2010 IEEE International Conference on RFID (IEEE RFID 2010).

[11]  Nuno Borges Carvalho,et al.  Enhanced front-end to extend reading range of commercial RFID readers using efficient multisine signals , 2012, 2012 IEEE/MTT-S International Microwave Symposium Digest.

[12]  Danilo De Donno,et al.  A Cost-Effective SDR Platform for Performance Characterization of RFID Tags , 2012, IEEE Transactions on Instrumentation and Measurement.

[13]  N. Carvalho,et al.  A Batteryless RFID Remote Control System , 2013, IEEE Transactions on Microwave Theory and Techniques.

[14]  A. Georgiadis,et al.  Improving range of passive RFID tags utilizing energy harvesting and high efficiency class-E oscillators , 2012, 2012 6th European Conference on Antennas and Propagation (EUCAP).

[15]  Pekka Pursula.  Analysis and design of UHF and millimetre wave radio frequency identification , 2008 .

[16]  Hyoung-Hwan Roh,et al.  Extending the Interrogation Range of a Passive UHF RFID System With an External Continuous Wave Transmitter , 2010, IEEE Transactions on Instrumentation and Measurement.

[17]  Nuno Borges Carvalho,et al.  Evaluation of simultaneous wireless power transfer and backscattering data communication through multisine signals , 2015, 2015 IEEE Wireless Power Transfer Conference (WPTC).