Thermodynamic analysis of SOFC (solid oxide fuel cell)–Stirling hybrid plants using alternative fuels

A novel hybrid power system (∼10 kW) for an average family home is proposed. The system investigated contains a solid oxide fuel cell (SOFC) on top of a Stirling engine. The off-gases produced in the SOFC cycle are fed to a bottoming Stirling engine, at which additional power is generated. Simulations of the proposed system were conducted using different fuels, which should facilitate the use of a variety of fuels depending on availability. Here, the results for natural gas (NG), ammonia, di-methyl ether (DME), methanol and ethanol are presented and analyzed. The system behavior is further investigated by comparing the effects of key factors, such as the utilization factor and the operating conditions under which these fuels are used. Moreover, the effect of using a methanator on the plant efficiency is also studied. The combined system improves the overall electrical efficiency relative to that of a stand-alone Stirling engine or SOFC plant. For the combined SOFC and Stirling configuration, the overall power production was increased by approximately 10% compared to that of a stand-alone SOFC plant. System efficiencies of approximately 60% are achieved, which is remarkable for such small plant sizes. Additionally, heat is also produced to heat the family home when necessary.

[1]  Jiujun Zhang,et al.  Electrocatalysis of Direct Methanol Fuel Cells , 2009 .

[2]  J. Smith,et al.  Introduction to chemical engineering thermodynamics , 1949 .

[3]  G. Prentice,et al.  Electrochemical Engineering Principles , 1990 .

[4]  Kazunari Sasaki,et al.  Equilibria in Fuel Cell Gases II. The C-H-O Ternary Diagrams , 2003 .

[5]  Timo Kivisaari,et al.  Conceptual study of a 250 kW planar SOFC system for CHP application , 2004 .

[6]  E. Achenbach.  Three-dimensional and time-dependent simulation of a planar solid oxide fuel cell stack , 1994 .

[7]  Daniele Cocco,et al.  Externally reformed solid oxide fuel cell–micro-gas turbine (SOFC–MGT) hybrid systems fueled by methanol and di-methyl-ether (DME) , 2009 .

[8]  Eric Croiset,et al.  Performance Assessment of Bioethanol-Fed Solid Oxide Fuel Cell System Integrated with Distillation Column , 2007 .

[9]  Masoud Rokni,et al.  Plant characteristics of an integrated solid oxide fuel cell cycle and a steam cycle , 2010 .

[10]  Masoud Rokni,et al.  Thermodynamic Investigation of an Integrated Gasification Plant with Solid Oxide Fuel Cell and Steam Cycles , 2012 .

[11]  Yoshio Matsuzaki,et al.  Electrochemical Oxidation of H 2 and CO in a H 2 ‐ H 2 O ‐ CO ‐ CO 2 System at the Interface of a Ni‐YSZ Cermet Electrode and YSZ Electrolyte , 2000 .

[12]  Ricardo Chacartegui,et al.  Stirling based fuel cell hybrid systems: An alternative for molten carbonate fuel cells , 2009 .

[13]  Brian Elmegaard,et al.  DNA – A General Energy System Simulation Tool , 2005 .

[14]  R. Kee,et al.  A general mathematical model for analyzing the performance of fuel-cell membrane-electrode assemblies , 2003 .

[15]  Paola Costamagna,et al.  Electrochemical model of the integrated planar solid oxide fuel cell (IP-SOFC) , 2004 .

[16]  Y. Jaluria,et al.  An Introduction to Heat Transfer , 1950 .

[17]  Francesco Calise,et al.  Full load synthesis/design optimization of a hybrid SOFC–GT power plant , 2007 .

[18]  Masoud Rokni,et al.  Thermodynamic analysis of an integrated solid oxide fuel cell cycle with a rankine cycle , 2010 .

[19]  Bjarne A. Foss,et al.  Modeling and control of a SOFC-GT-based autonomous power system , 2007 .

[20]  Alberto Traverso,et al.  Thermoeconomic analysis of SOFC-GT hybrid systems fed by liquid fuels , 2010 .

[21]  Liming Wei,et al.  Effects of gas recycle on performance of solid oxide fuel cell power systems , 2011 .

[22]  Barnett F. Dodge,et al.  Chemical engineering thermodynamics , 1944 .

[23]  A. Lanzini,et al.  Operation of a solid oxide fuel cell under direct internal reforming of liquid fuels , 2012 .

[24]  Francesco Calise,et al.  Simulation and exergy analysis of a hybrid Solid Oxide Fuel Cell (SOFC)–Gas Turbine System , 2006 .

[25]  Jai-Woh Kim,et al.  The Effect of Anode Thickness on the Performance of Anode-Supported Solid Oxide Fuel Cells , 1999 .

[26]  Ibrahim Dincer,et al.  Energy and exergy analyses of a combined ammonia-fed solid oxide fuel cell system for vehicular applications , 2011 .

[27]  J. Warner,et al.  Combined - Cycle Gas & Steam Turbine Power Plants , 1999 .

[28]  Brian Elmegaard,et al.  Exergy analysis and optimization of a biomass gasification, solid oxide fuel cell and micro gas turbine hybrid system. , 2011 .

[29]  Fahad A. Al-Sulaiman,et al.  Performance comparison of three trigeneration systems using organic rankine cycles , 2011 .

[30]  Rory A. Roberts,et al.  Dynamic Simulation of a Pressurized 220kW Solid Oxide Fuel-Cell–Gas-Turbine Hybrid System: Modeled Performance Compared to Measured Results , 2006 .

[31]  Mogens Bjerg Mogensen,et al.  Reaction of CO/CO2 gas mixtures on Ni–YSZ cermet electrodes , 1999 .

[32]  G. Reader.  The Pseudo Stirling cycle - A suitable performance criterion , 1978 .

[33]  Noam Lior,et al.  Combining fuel cells with fuel-fired power plants for improved exergy efficiency , 1991 .

[34]  David Kennedy,et al.  Computer simulation of a biomass gasification-solid oxide fuel cell power system using Aspen Plus , 2010 .

[35]  Kevin R. Keegan,et al.  Analysis of a Planar Solid Oxide Fuel Cell Based Automotive Auxiliary Power Unit , 2002 .

[36]  Wolfgang Winkler,et al.  Design studies of mobile applications with SOFC-heat engine modules , 2002 .

[37]  Andrew C. Foley,et al.  A UNIQUE SUB 5KW SOLID OXIDE FUEL CELL/HEAT ENGINE HYBRID GENERATOR , 2004 .

[38]  Shinji Kimijima,et al.  Performance analysis for the part-load operation of a solid oxide fuel cell–micro gas turbine hybrid system , 2008 .