Mode detection with an optimised array in a model turbofan engine intake at varying shaft speeds
暂无分享,去创建一个
Modal measurement techniques in engine intakes have been used previously to analyse the generated fan noise. A proven method is to use a wall-mounted array of Kulite transducers and operate the (model) turbofan under constant shaft speeds. A drawback of this method is the large number of (expensive) microphones and acquisition channels needed to obtain complete m-mode spectra at high engine orders. Furthermore, to get a full scan of the m-mode spectra as a function of shaft speed, many measurements are required. The issue of the large number of microphones was addressed by using a sparse array instead of an equidistant array. An array optimisation technique, similar to a technique used for the design of phased microphone arrays for sound source localisation, was used to define such a sparse intake array. This array consists of 100 Kulites and is able to determine without aliasing the modal spectrum from m = -79 to m = -1-79, which is appropriate to determine the modal content up to 3 BPF of a modem turbofan. This array was tested in a Rolls-Royce model fan rig at Ansty as a part of the RESOUND project. A new digital data-acquisition system made it possible to simultaneously and continuously record the Kulite pressure data as the engine speed was varied continuously from idle to maximum speed or vice versa, with each acceleration/deceleration lasting for a period of 9 minutes. Time histories of the Kulites were processed giving power spectra of the engine orders, which revealed the rotor locked tonal components. For each rotor revolution, a Discrete Fourier Transform was applied and, after averaging over a number of revolutions, the m-mode spectra were determined. In this way, a full modal scan with respect to shaft speed in a very limited testing time was obtained. Paper presented at the 7th AIAA/CEAS Aeroacoustics Conference, 28-30 May 2001, Maastricht, The Netherlands.